How to clean a home drum washing machine How to clean a drum washing machine

The method of cleaning the dirty things in the drum washing machine is as follows: 1. Clean the laundry bucket with a special detergent for the washing machine to fill the laundry bucket with clean water to the highest water level, then pour the detergent into the laundry bucket, run for five minutes to fully dissolve the detergent, if the washing machine can be heated, it can be heated to 40 degrees, then turn off the power of the washing machine, soak for about an hour, and then clean it according to the daily washing mode, when the washing machine stops, a large number of dirt fragments will float on the water surface. 2. Use drifting agent to clean the washing machine Add an appropriate amount of chlorine-containing bleach to the washing machine, then fill the washing machine with water, stir it evenly after the water is filled, and the dirt can be thoroughly cleaned after 20 minutes.

3. Use household white vinegar to clean the washing machine, first fill the washing machine with more than half of the water, then do not put any washing items, let it soak for more than three hours, then start the washing machine switch to rinse several times, then put half of the water, and finally pour the white vinegar into the washing machine barrel, put the water away after leaving it for one night, and then wash it with clean water again, and then open the lid of the washing machine and let it dry naturally.

Precautions for the use of drum washing machine: 1. When the "washing" or "rinsing" program is selected, the wave wheel will not run until the selected water level. 2. During the dehydration procedure, the cover must be closed, and the cover should not be opened from time to time.

3. Never touch the washing and dehydration bucket with your hands, so as not to get your hands involved and cause danger. 4. Do not wash or dehydrate clothes containing volatile substances (solvents, alcohol, etc.) to avoid accidents. 5. When the dehydration is unbalanced, the computerized automatic washing machine can be corrected for dehydration imbalance, if the imbalance problem is not solved after 2 corrections, it will stop and alarm, at this time, the cover should be opened, the clothes that are squeezed on the side should be placed evenly, and then the cover should be closed, and the "start pause" button can be pressed.

1. Use cleaning agent for disinfection. Find a container and pour water and descaler, mix it according to the ratio of descaler to water 1 2, and stir well. Pour in the prepared special detergent and stir well.

Pour into the washing machine and let the washing machine work according to the normal washing mode20, then recycle this water for about 3 washes, and then use clean water to finish the finishing work. This allows the inner wall of the washing machine to be cleaned.

2. Bleach disinfection. The first step is to put half of the water in the drum washing machine and pour in 400 ml of bleaching powder. After working half a year after booting, if it feels like it is not cleaned, work for half a half.

The next step is to drain the washed sewage and inject clean water for a wash.

3. Hydrogen peroxide cleaning. Hydrogen peroxide is a common disinfectant that can be used to disinfect well, mix it into a drum washing machine and add an appropriate amount of laundry detergent. Turn on the machine and work for a half, and then soak it for about 3 years, so that it can be decontaminated and disinfected.

Wash the washing machine again with clean water and open the lid to dry.

1. Materials to be prepared: 1 towel, 200ml of white vinegar, 50g of baking soda.

2. First of all, prepare a clean towel and pour 200ml of white vinegar on the towel.

3. Put the towel into the drum washing machine, then turn on the spin drying mode, let the white vinegar on the towel fill the barrel, and let it stand for a while, and the dirt inside the drum will be dissolved by the white vinegar.

4. Then add 50g of all-purpose baking soda to the drum, turn on the washing mode, adjust the water level to the highest, fill the washing machine with water, let the washing machine run normally for 5 minutes, and soak for two hours after the end.

5. Finally, turn on the rinse mode and rinse twice, so that the dirt in the drum of the washing machine will be removed.

1. We can buy special tools for washing machines first. For example, buy washing machine cleaners sold in supermarkets.

2. Adjust the washing machine to a high water level, fill the drum with water, and add bleach or a special washing machine.

3. In a few minutes or so, the washing machine will slowly foam, and the detergent will begin to dissolve and start to wash the dirt.

4. After waiting for about half a minute, the dirt will come out and the water will become dirty. At this time, we can turn on the stirring button of the washing machine until the water in the washing machine is completely discharged.

5. After the water of the washing machine is discharged, there will be residual dirt at the bottom of the washing machine. We need to wash it thoroughly again.

6. You need to use a dry towel to scrub the inner cylinder of the washing machine, and it is especially important to pay attention to the water in the mat outside.

1. Clean the inside.

The first step is to clean the inside of the drum washing machine. Prepare a clean towel, pour 200ml of white vinegar on the towel, put it in the drum washing machine, turn on the spin drying mode, let the white vinegar on the towel fill the bucket, let it stand for a while, and the dirt inside the drum will be dissolved by the white vinegar. Then add 50 grams of baking soda to the drum, turn on the wash mode, turn the water level to the highest, and let it soak for two hours.

Finally, turn on the rinse mode and rinse twice so that the dirt in the drum of the washing machine is removed.

2. Clean the washing box.

The washing box of the washing machine should also be washed. Remove the washing box from the drum washing machine and place it in the basin. Pour hot water and soak in 20 grams of baking soda overnight. Then put the washing box in clean water and scrub it again with a cleaning ball.

1. First of all, remove the door of the drum washing machine, generally there will be screws in the position of the door of the washing machine, after removing all the screws, you can remove the door of the drum.

2. After the door of the washing machine is removed, remove the upper cover of the washing machine.

3. Disassemble the control panel after the upper cover of the washing machine is removed. It should be noted that there are wiring on the control board, and it is best to take a photo of the wiring position to save it for installation after cleaning.

4. Disassemble the panel after the control panel is disassembled.

5. After disassembling the front upper panel, remove the cement blocks with the upper and lower counterweights, and then the upper and lower baffles, as well as the baffles in front.

6. The outer barrel is divided into two parts, and the upper and lower red circles are a circle of screws that have removed the cement counterweight part and then removed the arrow.

7. Then after removing the front half of the outer barrel, the inner barrel is exposed.

8. Then open the back panel of the washing machine.

9. Remove the belt first, then disassemble the center fixing screw, and gently tap it with a rubber hammer, so that the inner barrel can be taken out.

10. After the inner cylinder is disassembled, you can start cleaning, and you can use hydrogen peroxide disinfectant or washing machine special cleaning agent or bleach to clean it, which has a good cleaning effect.

Cleaning a washing machine requires three steps: cleaning the inside of the drum or using self-cleaning mode, then cleaning the drain and finally wiping the washing machine housing.

1. First of all, clean the drum, pour an appropriate amount of detergent into the detergent box, if the washing machine has a self-cleaning function, press the self-cleaning button directly, no need to add detergent, if not, you need to follow the daily laundry mode, set for half an hour.

2. Clean the sewage outlet of the drum washing machine, there is a small square lid at the bottom right of the washing machine, use a rocker or key to reach into the gap above the lid, pry the small cover open, you can see the round box and a drainage pipe inside. You can pull out the drain pipe, drain the sewage, put it back in place, and unscrew the lid of the round box. You can see that there are clothes lint and small dirty things in the box, pour out the dirty things, clean the box, install it back, and then close the lid.

3. After that, clean and wipe the shell of the washing machine, cut off the power first, and unplug it. Mix detergent with water in the basin to make a foam, and wipe the washing machine shell with a rag dipped in washing water, from top to bottom. After that, wipe both sides with clean water until there is no foam and detergent left, and finally wipe the washing machine shell with a dry rag.