How to install a water heater when the home is a gypsum board partition?

Use a percussion drill first.

Punch holes in the load wall and install the hook, and the spacing between the hooks is clear according to the interval between the water heater hangers, and the water heater is hung to. Then make sure there is an electrical outlet next to the water heater.

Ensure that the power supply system is properly connected to the inlet and outlet of the water heater and the embedded pipes in the home. Install the shower head, finally turn on the shower head and infiltrate the water to carry out the tank irrigation, until the shower head is stable water output, and finally connect the power cord plug to test whether the device can work normally, so that you can do it.

Clarify the electric water heater.

The location of the installation is in **, mark it with a paintbrush, and then fix the water heater, the fixed water heater can be fixed with a percussion drill to install expansion nails, and the water heater can also be tied to the fixed object with iron wire, as long as the installation is fixed and stable. After connecting the water pipe, installing and fixing the water heater, take out the water inlet and outlet and install it, tighten it and fix it, and then add water to fill the utensils.

When installing wires, it is necessary to clarify the connection of wires, and accurately connect the neutral wire, neutral line and grounding wire of the switching power supply.

Clarify the connection method of power plug and socket. Inspect the application. After the installation is completed, the electric water heater and hydropower project will be inspected to ensure that there is no water seepage and electricity, and the normal inspection can be plugged in. First, from the socket.

Unplug the power cord of the electric water heater and turn off the water inlet valve. Then unscrew the outlet valve at the bottom of the water heater to drain the water and sediment from the internal structure of the electric water heater. Then open the water inlet valve, clean the water heater liner with drinking water for 30 seconds, then close the water inlet valve, wait for the water in the internal structure of the electric water heater to drain again, open the water inlet valve again, clean the water heater liner with drinking water for 30 seconds (a total of 2 times), and do not block the drain of the electric water heater in the case of cleaning.

Unplug the power cord of the electric water heater from the socket again, turn off the water inlet valve, take a plastic bucket and put it under the electric water heater, carefully unscrew the outlet valve at the bottom of the electric water heater, and drain the boiling water from the internal structure of the electric water heater. Then clean the water heater liner with drinking water for 30 seconds according to the above method. The primary purpose of heating is to use the basic principle of thermal expansion and cold contraction of objects, so as to make it easier to remove dirt and waste from the surface of the electric water heater liner and electric heating pipes.

If the embedded parts are not processed on the plasterboard partition wall, the water heater cannot be installed directly on the gyppool partition wall. Installing a water heater is a technical job, and it is best to ask a professional to install it to ensure safety. When installing, it is recommended that you use through-wall screws through the wall panel to increase the load-bearing capacity.

It can be placed directly in the cabinet, directly installed on the house, and solved by pulling the pipe, so that the use effect is also very good.

This should be determined according to the actual situation, and it can be installed directly on the roof, which is very strong.