How to clip a flat clip into curly hair, and what are the tips for using a flat clip?

The most important technique for clipping the flat clip into curls is to first move the roots upwards to create volume at the roots, rather than pulling them straight forward. The roots of the hair are raised first to bring out the fluffiness.

Where it has been clamped, use a circular comb to smooth the angle, and then use a circular comb frame to stay on the inside of the just clamped curl for 5 seconds (it is not necessary to use a hair dryer to reheat, depending on personal curl needs) Let the curl have no embarrassing angle creases through the circular comb! Of course, if the curl is small, it is recommended to use a round comb with a smaller diameter; On the contrary, use a large round comb, so that the curl will be beautiful

Where it has been clipped, use a round comb to smooth the angle I believe that many people will use a flat plate clamp to clamp the curl of the inward or outward curl of the hair and tail, but when the clip comes out, I feel that there is a very embarrassing crease stuck there? There is no supple roll like an electric rod roll.

The flat splint is a splint that many women have prepared at home in modern times to manage straight hair. Many women are very fond of flat splints and use them every day to straighten their straight hair. But did you know that flat splints can also be used to manage curls?

This article will introduce how to make curly hair with a flat splint.

Hair straightener how to make curly hair one.

Step 1: First of all, it doesn't matter if your hair is straight or curly, as long as it's dry. Then turn on the straightener and let it warm up, then start clipping from the middle of the hair.

Step 2: When clipping, the angle of the straightener should be oblique from top to bottom, between 45°-60°.

Step 3: When the straightener is flipped outward, keep your hair around the clip at all times, but keep the hair at both ends unheated, and maintain a natural feel, so that you can create a loose feeling with only the middle of the hair curling.

Step 4: Finally, follow the same practice to pinch the rest of the strands and spray with styling solution.

Hair straightener how to make curly hair two.

step1, the short hair layer, the top of the head as a layer, the hair below automatically becomes a layer, first use a medium-sized hairpin to fix the hair on the top of the head, the electric splint clamps the hair ends of the hair below and curls upward, shaped, the effect is like this, slightly outward, very good-looking;

Step 2: Divide the hair from the top of the head into a thin layer, and shape it with an electric splint by rolling it downward, and the effect is like this;

step3, the electric splint clamps the bangs, and pulls down the arc, which is the effect of coming out;

Step 4, the rest of the hair on the top of the head needs to be curled up in the effect, the specific operation is like this, the electric splint clamps the hair 2 to 3 cm away from the hair root, and then moves the electric splint to the pull parallel to the hair as shown in the figure.

step5. The electric splint clamps the involution at the end of the hair, which is to create the effect of involution.

This article explains how to make curly hair with a flat splint. If you want to make your hair curly, but you only have a flat splint for straight hair at home, then you can also refer to this article for how to use a flat splint to create curls. In fact, flat splints can also create good-looking curls.

Let's try these two ways to manage curly hair in this article.

1. Wash your hair and use a hair dryer to dry for 8 minutes.

2. Extract a strand of hair from the right side, hold the upper half of the hair with a splint in your right hand and rotate it, and tilt the remaining hair from the inside to the top.

3. The hair rotates clockwise around the splint, and the splint tilts down in the same direction, and the roll comes out.

4. Rotate the hair on the left counterclockwise in the same way and tilt it down with a splint.

5. In this way, the use of splint perm is completed.

Here's how to curl your hair with a splint:

1. Smooth your hair first.

2. Weave a braid, then divide the hair into two sides, weave each into two braids, and tie it with a rubber band.

3. Twist in the same direction, and then twist the left braid in the same direction.

4. Clamp the electric splint and put the twisted braid in the electric splint.

5. Release the electric splint, hold for 2-3 seconds, and let go of the splint. Clip the left strand in the same way.

I can make curls ... You're going to use a splint to make the hair spiral. Then slowly pull out the splint from top to bottom... But remember. Be sure to use a splint to spiral your hair from the outside to the inside.

Splints can curl your hair like this, allowing you to curl a beautiful hairstyle at home, super easy.

Straightener clips can be used for a variety of curly hairstyles, and we can do curls at the ends, which is very simple. Hold the ends of the hair with a straight clip, straighten out the hair with a comb, and then use the straight clip to clip the hair to the ends, and roll it inside while pulling, and after a few seconds, the curls can be formed, so that there can be an inner buckle effect.

Although a straight clip can create a curly effect, the permed hairstyle is definitely not as good as a curling iron, so if you want to have a better curling effect, it is best to use a special curling iron.

After dividing the hair, use a comb as an aid to push the hair towards the place where the hair is divided, use a hair dryer to strengthen the position of the hair roots, and use a hair dryer to heat the hair roots.

The comb is held in place for about 3 seconds to make the hair roots fluffier and not collapse so quickly, and then blow the hair on the back of the head, otherwise the hair on both sides will be fluffy and the back will collapse. With a straight clip, clip the ends of the hair out of the C-shape, and clip the ends of the hair according to the upper and lower layers, and grab a few handfuls of the upper hair irregularly. After curling, wrap your fingers outwards to make the curl of the hair more pronounced and three-dimensional, and you can also use a little hair in other positions.

If you want to make a small roll, you can wrap it tightly, and then clamp it with a straight plate clamp and stay for a longer time.

Everything is about practice, as long as we practice more, we can slowly make beautiful curls. It is also recommended to watch some **** tutorials at ordinary times, which will be of great help to the improvement of curly hair skills.

If it is a flat splint, it is not possible to cut hair. If it's a cylindrical splint, you can curl your hair.

After the hair is washed and completely dried, take a strand of hair, roll it inward or outward, leave it for about 15 seconds and then disassemble it, and do the same for other parts, then the beautiful curls are completed.