My surveillance video recorder keeps ringing the alarm, I can t record the image, but I can watch it

Check if there is a problem with the hard drive.

The reasons why the surveillance video playback is not recorded are as follows:3. The operator will not operate the DVR, and does not correctly call the recording of the DVR according to the normal steps.

4. There is a problem with the motherboard of the DVR. Supplement.

If the video playback is not recorded, it may be that the recording settings of your video recorder are not set properly, or the hard disk is faulty.

It is also possible to think that the hard drive has been formatted and so on.

Hello question. Answer 1 The hard disk is damaged, in the hard disk management menu to see if the hard disk status is wrong, if there is no important video, you can format the hard disk, there is a certain possibility of repair. 2. The recording settings are incorrect, such as setting motion detection, but not dividing the motion detection area, checking whether the recording function has been turned on, checking whether the system time of the monitoring host is correct, determining the time period of monitoring playback, checking the saving path, etc. 3. Software problems, the machine crashes when searching for video, reboot can be normal, this is likely to be a software problem, if the computer is the host, you need to reinstall the monitoring software driver with full antivirus.

The young lady said, what should I do if there is no video playback in the surveillance? Actually, you just need to learn this trick.

There is no video recording on the surveillance, and what is the password required on it.

Summary. Hello dear.

2. Some do not have a brand to dig and sell, or dash cams, or some small monitoring, often copied to the computer can not be used, and many ** devices are not available. Because there are hundreds of monitoring brands, there are many kinds of game judges.

Surveillance video playback without video What's going on, dear! There are several reasons why the camera playback does not record the video: 1The camera may not be connected to the DVR, **The image is not stored, and you can only watch the real-time picture.

There is a problem with the DVR motherboard. 4.The surveillance record storage is set up with an overlay, and the later video replaces the previous video.

Hope it helps!

First of all, you need to check whether the power supply of the surveillance video recorder is connected properly and whether the plug is secure. If the plug is not in good contact, you can replug and unplug the test section, if there is a problem with the power cord itself, you need to replace the power cord. 2.

Faulty power adapter: If there is no problem with the power cord, you can check if the power adapter is working properly. You can try replacing the power adapter or using a multimeter to measure whether the output voltage of the power adapter is normal.

3.Blown out fuse: If there is no problem with the power cord and power adapter, you can check whether the fuse inside the surveillance video recorder is burned out.

You need to open the shell of the surveillance video recorder, check whether the fuse on the motherboard is burned, if the fuse is burned, you need to hold it hidden and replace it with a new fuse. 4.Faulty board or component:

If the above three situations are ruled out, it may be that the circuit board or components inside the surveillance video recorder are faulty and need to be repaired or replaced. It should be noted that caution is required when dealing with these carrying issues to avoid secondary damage to the device, and it is recommended to seek professional help. At the same time, in order to avoid similar problems, it is recommended to follow the operation specifications when installing and using surveillance video recorders to avoid equipment failure caused by incorrect operation and excessive use.