Desktop ASUS motherboard boot press F8 and del does not respond to boot directly?

It is recommended to press and hold the logo when it appears on boot and do not let go.

ASUS motherboard F8 is the boot item selected, and del is the BIOS

You press it once or hold it down, and it's 100 percent unresponsive. You have to press wildly, do you know what it means? You can't press it once, you can't hold it down, you have to press it quickly and continuously to have an effect.

Under normal circumstances, pressing F8 before booting to detect the hard disk is to enter the fast boot item (but this boot is valid). Crazy press DEL is to enter the BIOS settings. If the crazy press is invalid, it is recommended to change a round port (it does not support boot and unplug, and the round port keyboard is easy to burn the chip that supplies power to the keyboard on the motherboard) keyboard, because I have also had this situation before, and it is okay to change the keyboard.

Some motherboards fail to access the BIOS after Fast Boot is enabled.

You can try opening the case and removing the hard drive, which will go into the BIOS.

Then modify the boot settings, cancel the fast boot option, and the interface will boot normally, and you can enter the BIOS.

The way to enter the BIOS of ASUS motherboards is not necessarily the same depending on the model, you can search for shortcuts to enter the BIOS according to your motherboard model. In addition, the button should not be pressed all the time, but pressed continuously until it enters the BIOS interface.

The F 8delete button on desktop ASUS motherboard does not respond, under normal circumstances, it can be solved by F1 or F2.

It's not that the ASUS motherboard will react when you press F8 and DEL when you boot up. It is possible to press F2F12 and F11F10. So give it a try.

What do you want to do first? Do you want to make a system? You can press f9 to 12 to try it.

Since the prompt says that you can enter the motherboard setting screen by pressing del, but it doesn't work in actual operation, then it must be that the software system of the motherboard is faulty, which needs to be repaired directly by the motherboard manufacturer, I hope you are still under warranty.

Click the Enter key, select "Enable" from the pop-up options and OK. Then continue looking for ExternalDevice below and move it to the top with the F5 key. Finally, press "F10" on the keyboard, and then select "Yes", and after restarting, you can enter the PE interface of the U disk installation master.

IBM (press F1 for cold start, some new models can be started on reboot press F1).

HP (press F2 on startup and restart).

Sony (press F2 on startup and restart).

dell (press F2 on startup and restart).

acer (press F2 on startup and restart).

Toshiba (press ESC and then F1 on cold start).

Compaq (press F10 when the cursor flashes in the upper right corner when the power is turned on, or press F10 when the power is turned on).

Fujitsu (press F2 on startup and restart).

ASUS motherboard into BIOS method:

1. When the motherboard is powered on for self-check, press it repeatedly"del"Keystroke.

2. You can also "Start" in the Windows 10 system - Settings - Restore - Advanced Boot - Troubleshooting - UEFI firmware settings, and then the machine will reboot to enter the BIOS setting interface.

Cause.

1. Caused by external equipment.

Cause. 2. Caused by a motherboard BIOS error.

Solution: If you can enter the motherboard BIOS, directly initialize the BIOS setting information, and then press F10 to save and exit and restart the computer.

If you can't access the motherboard's BIOS settings, you can remove the motherboard's coin cell battery and put it back in place, or you can restore the BIOS settings to the default settings to complete the initialization of the BIOS settings.

Cause. 3. Damage to the hard disk or SATA data cable of the hard disk.

Solution: Generally speaking, as soon as the computer is turned on, the first thing is to conduct a device self-test, if the computer is stuck on the boot brand screen, there is also a situation that the hard disk detection has not passed, try to unplug the hard disk cable, and then reboot.

Cause 4: Faulty motherboard or memory.

Solution: Re-insert and unplug the memory, it is best to wipe the memory gold finger, if it is invalid, consider whether the problem is caused by the motherboard failure or memory failure, if there are multiple memory, you can use the elimination method, alternately try.

Hello, it is recommended that you deduct the motherboard battery replacement, there are sold in the computer city, change it on the motherboard after you come back, boot into the BIOS, restore the factory settings, press F10 to save and exit.

1) Shut down and cut off the total power supply, only connect the motherboard, CPU graphics card, a memory and power supply and a keyboard to try to boot to see if you can enter the BIOS, if you can, after the shutdown, add the peripheral hardware one by one, to see which device is installed to cause this problem.

2) If this problem still occurs when only the main hardware is connected, it is recommended that you cross-test the motherboard, memory and other major devices, if there is no platform cross-test, you can also take the motherboard to the ASUS service center to help you test the motherboard.

It's not that the battery is dead, the battery is out of power and won't be stuck in the motherboard logo, you have after-sales to find after-sales, no after-sales. Find yourself a computer repair shop and ask someone to take a look at it for you.

The registered boot disk is not defined

This interface will usually appear, allowing you to enter the BIOS and then set the first boot disk, save and exit.

ASUS motherboard boot display to press F2 or del to enter the BIOS, after pressing no response and can not enter the operating system.

Dear, your situation has something to do with the computer hardware, the suggestions are as follows: 1) Shut down and cut off the total power supply, only connect the motherboard, CPU graphics card, a memory and power supply and a keyboard to try to boot to see if you can enter the BIOS, if you can, after the shutdown, install the peripheral hardware one by one, and see which device is installed to cause this problem. 2) If this problem still occurs when only the main hardware is connected, it is recommended that you test the motherboard, memory and other major devices, if there is no platform cross-test slow Bubu, you can also take the motherboard to the ASUS service center to help you test the motherboard.

1: Memory module defect?

2: Try a part reset. Remove the coin cell battery.

Remove the memory module. Remove the hard disc wire. Disc drive cable removed ==> and then.

Attach the coin cell battery and memory module. Boot ====> if it is normal. No automatic shutdown = > after the power is turned off.

Plug it in and turn it on again.

If the hardware is really trouble-free. It should be back to normal boot!

PS: Always pay attention to the correct system date in the BIOS. Is the first boot project correct?

Take out the memory and erase it with an eraser.

According to the boot information of your computer, it is normal, then the problem should be in the hardware:

Four common scenarios:

1. It will automatically shut down when it is turned on, then you should check whether it is caused by memory, and it is best to try another memory. Sometimes the memory loses a resistor, and this is also the case with one of my company's computers.

2. It may be caused by poor heat dissipation. Then check if it is caused by the problem of CPU fan heat dissipation.

3. Failure caused by the computer boot button. Dial the cable that is turned on first, and use a screwdriver to shorten the circuit and test it.

4. Caused by motherboard problems.

If the keyboard light does not respond, consider that the keyboard socket is plugged in incorrectly or the keyboard is broken.

Dear ASUS users, this has something to do with computer hardware, and the suggestions are as follows:

1) Shut down and cut off the total power supply, only connect the motherboard, CPU graphics card back, answer a memory and power supply and a keyboard try to boot to see if you can enter the BIOS, if you can, after the shutdown, add the peripheral hardware one by one, see which device is installed to cause this problem.

2) If this problem still occurs when only the main hardware is connected, it is recommended that you cross-test the motherboard, memory and other major devices, if there is no platform cross-test, you can also take the motherboard to the ASUS service center to help you test the motherboard.

Summary. 1.Front-end jobs.

Remove external devices such as portable hard drives, printers, memory cards, optical discs from optical drives, adapter cards from card readers, etc.

2.Perform a CMOS reset.

a.Please remove the transformer first.

b.Please remove the laptop's battery.

Note: Some models may not be able to remove the battery, please skip step (b). Figure C below shows the removable battery module.

ASUS motherboard is stuck in this interface when it is turned on, no matter what you press, it is useless, and the F2 del button is useless and cannot enter the BIOS?

Hello, I have seen your question and am sorting out the answer, please wait a while

Good. The method is basically tried.

When the laptop persists on the ASUS ROG logo screen after booting up, please refer to the following solutions:1Front-loading Remove external devices, such as portable hard drives, printers, memory cards, optical discs in optical drives, and also transfer cards in bridge readers, etc.2

Perform a CMOS reset APlease remove the transformer first. b.

Please remove the battery from your laptop Note: Some models may not be able to remove the battery, please skip step (b). Figure C below shows the removable battery module.