After the ignition of the Changan Suzuki antelope started, there was a motor grinding sound

Landlord, this is the sound produced by the friction between the starter and the flywheel ring gear, it is recommended to check whether the flywheel gear ring is damaged.

The motor sleeve is worn and axial is open, so that the gear clearance between the flywheel ring gear and the motor gear is too large, and when the engine is started, the load of the motor increases, and the two gears are easy to collide with the teeth.

Abnormal. Go ssss and debug it.

Generally, the car has a high speed when it starts, and it will come down after a while. You're a little too tall though. What is the normal time?

Common causes and solutions for antelope car idling instability:

1.The engine has a lot of carbon deposits.

The most common cause of car shake is a dirty throttle or excessive carbon build-up in the fuel injector. When the carbon deposition inside the engine is excessive, the gasoline sprayed by the cold start fuel injector will be absorbed by the carbon deposition in large quantities, resulting in the mixture of cold start being too thin, making it difficult to start, in this case, only when the gasoline absorbed by carbon deposition is saturated, it is easy to get on the car, and the gasoline adsorbed on the carbon deposition after the car will be sucked into the cylinder by the vacuum suction of the engine for combustion, and the mixture becomes thick, and the combustible mixture of the engine is dilute and thick, causing idle shaking after cold start. The lower the temperature, the greater the amount of oil required for the cold start, and the more the presence of carbon deposits will affect the cold start.

Solution: Clean the oil circuit and check whether the idle motor has carbon deposits and should be cleaned.

2.Problems with the ignition system.

Check the working condition of the spark plug, high-voltage wire and ignition coil, the ignition system is not working well, and the spark plug tripping condition is not good, which will also lead to this kind of failure.

Solution: Check whether the spark plug has too much carbon deposit, and replace the spark plug.

3.The oil pressure is unstable.

If you have cleaned the engine carbon deposit, washed the throttle, changed the oil pad and spark plug, etc., and still found that the body shakes when idling, it is recommended that you go to the 4S shop to check whether the fuel supply pressure and intake pressure sensor are normal, if the oil pump supply pressure is abnormal or the intake pressure sensor value is wrong and the work is not good, the body shake will be triggered.

Solution: Check the oil pressure and replace the parts if necessary.

4. Aging of engine parts.

Car jitter is also related to the aging of the engine feet (also known as claw pads). The engine foot is actually the suspension system of the engine, and the engine foot is responsible for absorbing the subtle shake of the engine when it is running, and if there is a problem with the engine foot, these vibrations will be transmitted to the steering wheel and cab, causing shaking when idling.

Workaround: Replace the parts.

Hello, clean the lower throttle and idle motor. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

What is the reason for the increase in idle speed when the Changan Suzuki Antelope car is blocked In fact, it is not the problem of the car, it is the fuel, the oil road is dirty, don't look at the new car, it will be dirty, because when you refuel, the oil itself is not 100% clean, the gas station regularly cleans the oil storage tank. Therefore, regardless of the petrochemical industry, it will encounter impurities in the same fuel. This can't be helped.

The clutch burned. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

The transmission shaft on the right side of the antelope car has an intermediate support, also called the bridge bearing, which should be smoothed out of the inner teeth of this bearing, which will cause the gear to loosen and not walk! [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】

Hello! Because it has a steering wheel lock and an anti-theft function. Before ignition, you can gently shake the steering wheel left and right, and you can smoothly insert the key to ignite the ignition, and the steering wheel will be unlocked after turning the key.

Mine, are you still satisfied?

Hello, it should be a throttle problem, if it helps, please click for, thank you.

Dear, it is recommended to check the idle motor.

It is recommended that you clean the throttle

4-cylinder 16-valve, displacement. It's an old machine, and there is no better technology to replace it, and there is an improvement in the electronic ignition system, which is the stuff of two square boxes inserted into the spark plug. Don't doubt the quality of this machine, although it is domestic, but the mature technology is irreplaceable.

Check whether the idle motor is working properly, and check whether the exhaust check valve is damaged. Check whether there is any air leakage in the intake branch pipe, such as the booster pipe, etc. Not a big problem, it is estimated that there is an air leak.

Hello, this ** is at 800 yuan.