What should I do if the red sandalwood bracelet has been soaked in water for a long time

The red sandalwood soaked in water may not have the previous luster and shine, because soaking in water will make the red sandalwood oil pterostilbene loss, and it is also very likely that the humidity changes sharply to cause cracking, so the red sandalwood beads that have been soaked in water should be wiped clean immediately on the surface, and then put them in a sealed bag for preservation, so that the water in the wood can slowly evaporate, rather than drying quickly, which will definitely crack. In the sealed bag, we can also put a dry cloth or absorbent paper, so as to absorb the water faster, and then take it out to play after half a month, and then slowly dish, you can re-dish the gloss. Of course, after all, the small-leaved red sandalwood is still wood, and it is always afraid of water, so we can only minimize the bad problems after soaking in water, and can not completely solve it, or keep your small-leaved red sandalwood away from the water source.

Wipe it off! Seal it with a glove plate and don't see the wind!

Take it out as soon as possible, wipe off the water with a clean towel, wrap the newspaper and leave it in a cool and unventilated place to dry naturally, avoid drying and drying, I hope it will help you.

Cool and dry slowly in the shade ......But I've had a skewer in the water, and I've cracked.

The surface of the beads will lose its oiliness and take it out to feel dry before sanding.

Everyone is grinding water, the material is good and blistered, the carriage is exposed to the sun and rain for decades, and it is still a treasure to sell to the people.

Summary. Kiss! <>

Hello, a blessing, a warmth, a touch. <> with a grateful heart

<> life is full of touching! Your question has been received, it will take a little time to type, please wait a moment, please do not end the consultation. You can also take this time to provide more effective information so that I can better answer your <>

Hope mine can solve your problem and sort out the answer for you right away, please wait a moment. Hello, please wait a minute. <>

What to do if the sandalwood bracelet gets wet.

Kiss! <>

Hello, a blessing, a warmth, a touch. <> with a grateful heart

<> life is full of touching! Your question has been received, it will take a little time to type, please wait a moment, please do not end the consultation. You can also take this time to provide more effective information so that I can better answer your <>

Hope mine can solve your problem and sort out the answer for you right away, please wait a moment. Hello, please wait a minute. <>

Hello Dear Kiss According to the official data, your questions are as follows: wipe the water dry, and do not let the sun shine directly on the bracelet for a short time. Sandalwood bracelet maintenance precautions:

1. It is very important to finish the plate in the early stage, which can make the beads brighter and reduce the impact caused by water in the later stage. 2. Try to avoid water, including sweat on your hands, after all, sandalwood is still wood, and you can dry it quickly after wetting. 3. Never get on all kinds of chemical detergents, pesticides, perfumes, etc.

4. Try to avoid direct sunlight, ultraviolet rays will accelerate the decomposition of sandalwood, so that sandalwood loses its fragrance. 5. Wipe it clean with a cotton cloth or gloves before going to bed every night. 6. If conditions permit, raise it with pearl powder at night.

That's all my reply 2Do you have any other questions? <>

I can go on and on for you <>

3.Hope this service can help you, <>

4.If you are satisfied with my service, please give it a thumbs up, <>

Laoshan sandalwood is a natural wood, the principle is afraid of water and sweat, but wearing a little sweat normally, in fact, there is no problem, the part of the sticky sweat will become a little whiter if you wear it directly, don't pay attention to it, just wear it for a few more days. Try not to wear it when exercising or taking a bath, and if there are stains on the surface, use cotton gloves to coil it. 2.

Stay away from peculiar smells, any peculiar smells will have an effect on Laoshan sandalwood and will affect his taste, so try to stay away from peculiar smells. 3.If the taste becomes weak, you can put it in the maintenance powder and seal it for a few days, and the taste can be restored.

Put it in a cool place and dry it naturally, and the small leaf red sandalwood plate will be dark purple on the side, and it will look a little black, which will not affect the quality, and there is basically no problem with the method of playing on the Internet.

Put it in a cool place, do not see the sun, otherwise it is easy to crack.

Dry quickly, don't dry, don't blow, and dry naturally.