How much should I do if I lose the Tiida induction key?

Hello, about 1,000 yuan, the landlord can make a reference.

When you need to replace the full car key, BCM, or use the old ECM of another car, you need to make the following match:

1 Enter the NATS system menu under the OFF key;

Note: You can tap "Continue" on the detector display to enter; If no further information can be displayed, the detector should be charged before it is done;

2 Select "steering lock release" to unlock the steering post.

You need to enter a password, and after success, you can only open the ignition key, but you can't start the engine);

3 Open the ignition key, exit the Consult-II system and re-enter the system to initialize the NATS system "C u Initiallization" (password required).

4. Carry out key registration, turn off the key (off key) after the ignition key is initialized, and then open the ignition key, and the anti-theft indicator flashes 5 times to indicate that the key is successfully registered; If there is a second key, turn off the key and pull it out, then insert the second key, open the ignition key, and the anti-theft indicator flashes 5 times to indicate that the key is successfully registered; To exit the key registration process, start the engine or open the door;

4 To register your smart key, go to the "NATS I Key" section of Consult-II and select "Regist I Key".

Note that during the smart key registration process, the ignition key must be inserted into the lock cylinder;

5 Register the D-Pad: Select "Regist Strg Lock ID".

Note that during the D-pad lock registration process, the registered smart key must be placed in the cab, and after tapping the registration start "statr", turn off the ignition key, and then slowly press the ignition lock block (Ignition Knob) until the registration is successful.

1. If your key finds that the remote control distance is shortened, and it can be controlled close to the body, you need to replace the battery.

2. Battery model 1620, button battery. The battery of this model on the market is not easy to find, and the worst can be bought on **. Generally, a balance of 2 yuan is enough.

3. Disassemble the remote control: compare the instructions: use the small cross cone to push down the buckle in the key slot (the buckle is easy to hurt the buckle), pull it out forward to separate the key and the remote control, and pry the shell of the remote control with a small change cone to open the remote control.

Note that the force needs to be quite large, the key is tightly connected, the quality is very good, it is not easy to pry, and it will not be broken if you are careful.

4. Replace the battery, pay attention to the battery clamp next to the battery, if you get it off, carefully study and install it in place to install the battery.

5. After replacing the battery, it can generally be used normally.

However, if the battery has been dead for a long time before replacing it, you may find that the remote control light will turn on, but you just can't control the car remotely.

To rematch the remote!

1. Open the left front door and keep it open.

2. Push the door lock switch on the door 1 time and keep it in the unlocked state (I don't know what this is for, in fact, as long as the door is open).

3. Repeat 3 times with any key from lock--on, stop in the lock state, don't move the key, stay on it.

4. Close-open, the left front door opens and closes 3 times, then you will find that the door automatically locks - automatically opens once. Tell the mammoth.

5. Press any key of the remote control you want to match 2 times.

Note that if you press the button of a remote control 2 times at this time, the remote control will match the car. If you don't press the other remote control, then the other remote control will automatically fail, and the car should only recognize the remote control you have determined by default.!! At this time, you need to press any button for each remote control 2 times, so that each remote control you have pressed can be matched with the car!

Knowing the limbs!! Follow the above method to match one remote control and see if the other remote control is out of order.

6. Finally pull out the key (this key on the igniter can be any of the original keys, of course, the key you want to match is also OK, so you can also match as long as you have a key, the result is that after matching, the remote control of the other key will fail.) The car will automatically close and unlock 3 times.

The method is very simple, there will be no trouble, in case of trouble, just reset it, and the worst can be opened with a key.

Tiida key battery change tutorial: 1. Find a small switch on the back of the car key and flip it. 2. Grab the top part and pull it out.

3. After pulling out the mechanical key, you can see a small groove. 4. Use a flat screwdriver to pry the car key cover along the groove, and manually open it when there is a gap. 5. Open the cover of the car key, take out the old battery and replace it with a new one.

6. Put the original key cover back and insert the machine key.

Hello: "The Tiida key battery replacement tutorial is as follows: 1. Find a small open group on the back of the car key and pull it off.

2. Grab the top part and pull it out. 3. After pulling out the mechanical key, a small groove can be seen. 4. Use a flat screwdriver to pry the car key cover along the groove, and when there is a gap, pull it open.

5. Open the cover of the car key, take out the old battery and replace it with a new one. 6. Put the original key cover back and insert the mechanical key back. ”

The method of replacing the remote control battery of Nissan Tiida is: 1. First of all, the owner finds a small switch on the back of the car key and flips it; 2. Grab the top part and pull it out, and the owner can see that the metal mechanical key inside the car key search type is pulled out; 3. After pulling out the mechanical key, the owner can see a small groove, use a flat screwdriver or other tools to pry the car key cover along the groove, when there is a gap, the owner can manually pull it open; 4. When the car key cover is opened, the owner can see a round-shaped battery inside, and take out the old one and replace it with a new one (pay attention to the positive and negative poles). Nissan Tiida is a hatchback of Tiida, with a length, width and height of 4205mm, 1695mm, and 1540mm respectively, which is not very large in the same class of cars, but the space from the front seat to Senchun's head has reached 960mm, and the rear space is slightly smaller, and Dashichun guessed 940mm.

Tiida key battery replacement tutorial: 1. Find a small switch on the back of the car key and flip it. 2. Grab the part of the top ant and pull it out.

3. After pulling out the mechanical key, you can see a small groove. 4. Use a flat screwdriver to pry the cover of the key along the groove, and when there is a gap, manually pull it open.

1. Find a small dust slipper on the back of the car key and pull it. 2. Grab the top part of the cavity and pull it out. 3. After pulling out the mechanical key, you can see a small groove.

4. Use a flat screwdriver to pry the car key cover along the groove, and when there is a gap, manually pull it open. 5. Let the car let the key cover open, take out the old battery and replace it with a new one. 6. Put the original key cover back and insert the mechanical key back.

The steps to replace the key battery in Tidab are as follows:

There is a small switch in the upper part of the back of the key, and with a slight buckle, the spring preparation can take out the mechanical key.

Use a flathead screwdriver to open the smart key, and when you open it, you can see that the key picks up and destroys the battery.

Using a small flathead screwdriver makes it easier to remove old batteries.

The new battery should be installed with the positive pole facing up.

The battery replacement of the car key of this car is very simple, first take out the spare mechanical key, and then pry the wide button along the gap in the shell of the remote control key, and the battery can be replaced after prying the shell open. There is a battery in the remote control key of the car, this battery can generally be used for 2 to 3 years, if the battery is dead, then you need to replace the battery.

Tiida key battery change tutorial: 1. Find a small switch on the back of the car key and flip it6. Put the original key cover back and insert the mechanical liquid Songzhou key. How the key fob works: Sakura code is issued from the key first.

The battery replacement of the car key of this Zen wheel model car is very simple, first take out the spare He Gao's mechanical key, and then pry along the gap in the shell of the remote control key, and the battery can be replaced after prying the shell. If the car key is out of power, it will malfunction when remote control is at a distance.

1. Spare keys come in handyGenerally speaking, cars nowadays will have two keys, one for the usual use and the other for backup. When you lose your usual key, the spare key can come in handy, go back yourself or ask your family to send a spare key. You must remember that the spare key must not be placed in the car, it must be placed in a safe place at home, otherwise the common key is lost, and the spare key is still in the car, so you have to ask someone to unlock it.

2. Professional lock picking companyIf the vehicle is far away from the spare key, or the spare key cannot be found, then you have to ask a professional lock picking company to unlock it. There is usually a need to prove that the car is yours, such as an ID card.

driving license, etc. If they didn't have such documents, I'm afraid they wouldn't dare to open them.

S shop

Each car will have an anti-theft code configured with the car, and the owner only needs to provide the driving license to the 4S shop.

and identity information to the 4S store, the 4S store can obtain the anti-theft code of the car early and the dust according to the information provided, and then configure a new key. At the same time, the lost key data can also be erased, that is to say, the lost Luchan key becomes an illegal key, and the vehicle will not be able to start, but the door can still be opened, so the 4S store will also recommend replacing the full lock to ensure safety.

Hello, it is a pleasure to serve you and give you the following answers: First of all, the reason for this may be the damage of the key, aging or improper use of the key. Workaround:

1.Check the keys for damage, and if they do, you need to change the keys. 2.

If the key is not damaged, but the lock won't open, you can try wiping the oil on the key with a rag so that it can be used normally. 3.If neither of the above methods solves the problem, you can try using a car key replicator to make a new key copy so that it can be used normally.

Personal Tips:1When using the car key, care should be taken to avoid pollution, so as not to affect the use effect.

2.Regularly inspect the keys for damage to avoid more serious problems. 3.

Try to avoid gravity damage to the key to avoid unnecessary losses.

Hello, it is a pleasure to serve you and make the following answers for you: Solution:1

If the original key of Tiida car is broken, you can first try to check whether the battery is exhausted, if so, you can replace the battery with a new one, and then try to use the key again. 2.If replacing the battery does not solve the problem, you can have it checked at a professional car locksmith, who can tell if the key is broken according to its characteristics, and whether it can be repaired, you can provide a free inspection service, and if it can be repaired, you can repair it at a car locksmith.

3.If the key is broken, you will need to buy a new one, either from a locksmith or the car manufacturer. Personal Tips:

1.Be sure to check the key frequently for damage, and if there is any abnormality, check or replace it in time to avoid accidents. 2.

Try not to carry extra keys to avoid being stolen and causing greater damage. 3.Be sure to keep the key of the vehicle, and don't let others know that the key to the car is in the **, so as not to be stolen.

Nissan Tiida key battery replacement needs the tools, "one" screwdriver, a piece of cloth, to pull out the spare key. You can pry it from here, it's very simple, hold the head of the screwdriver with a cloth when prying, so as not to pry the opening. Then just break off the battery, replace it with a new one, and then put it back in according to the original parts.

The remote key is a key that uses the wireless remote control function of the central lock, and can open and lock the door from a distance without inserting the key key into the lock hole. The working principle is simple: first send a weak radio wave from the key, receive the radio wave signal by the car antenna, identify the signal ** by the electronic control unit, and then carry out the action of opening and locking by the actuator (motor or electromagnetic coil) of the system.

When the key is awakened, it analyzes the authentication password issued by the car and sends corresponding signals, which are encrypted for added security. The car compares the received signal with the information stored inside the car, and if the verification is successful, the car unlocks the door. Once the driver is in the car, he only needs to press the start button with a simple press and the car engine will start.

When the button is triggered, the PKE system first needs to detect whether the "key" device is in the car, and then complete the same authentication process before starting the engine. When the driver leaves the car, the door is locked by simply pressing the door handle, and the car is also subject to the same detection of the driver's position before the car is actually locked, and goes through the same verification process. (Photo by photo:.)

Zou Ting1).