How to type with one hand, how to put a type with one hand

Input methods can be used.

Set it to one-handed mode, the specific setting steps are as follows:

Materials required: mobile phone, input method.

1. Open the input method and click the "du button" in the upper left corner.

Second, click on the "one-handed mode" option in the pop-up input method option.

3. At this time, you can reduce the virtual button to the lower right corner of the screen, and you can use the right thumb to enter with one hand.

The specific steps are as follows:

1. First of all, open the mobile phone chat box, click the chat box below the selection to bring up the input method.

2. Then click and select the "Keyboard" icon button in the upper left corner of the new interface.

3. After that, click and select the "One-handed Keyboard" button in the new interface.

4. Then click on the new interface and select the "Done" button.

5. Finally, on this page, you can see that you can type with one hand.

In the first step, the keyboard must be "turned into" a "one-handed keyboard", and the standard keyboard layout must be changed to a one-handed keyboard layout suitable for one-handed use

One-handed keyboard pc computer keyboard layout:

Laptop keyboard:

One-handed typing fingering diagram.

Second, start typing practice - spelling users.

1. Be sure to practice 30 letter combinations first, each combination should be repeated 10 times, and the whole should be repeated 3 times, and it is strictly forbidden to blindly press the keys without returning to the initial state, which takes about 15 minutes.

2. Practice 20 initials, and practice at the same time to be familiar with the key distance of finger return and running, each initial keystroke 5 times, repeat 20 times, be sure to keep the fingers always on the default key when starting and ending keystrokes, do not follow this method to quickly repeat the key is meaningless for this exercise, it takes about 15 minutes.

3. Repeat the above again, it takes about 15 minutes.

4. Open Kingsoft Typing, start to look at Pinyin typing, Pinyin is visible, practice watching Pinyin play for 15 minutes, and then evaluate which key or combination is not proficient, pick out a special practice for 5 minutes.

5. Enter the Pinyin blind typing module of Kingsoft Typing and practice for 15 minutes.

6. According to your own situation, you can selectively repeat all or part of the above steps again, which takes about 60 minutes, and the input speed should reach 10-15 word minutes.

,,, practice requires ,,, put your hands in the middle of the keyboard and make the most of your five fingers.

This one-handed keyboard can type, through custom key mapping, usually play games, and there is no problem with typing (the typing rate is about 3 4 of both hands), just like you usually play games, just put your finger on the ASD. **Links: Links to web pages.

Part One Finger Standard Bit.

Everyone knows the standard technique of two-handed typing, so I won't go into too much detail here.

The reason for using FGHJ as the standard position is that if you press the little finger to F and the index finger to J, it happens that F and J have corresponding markings (such as pits, protruding dots) so that you can quickly find the standard position after playing.

Part two Finger key area division of labor.

This is what I call the division of labor with reference to two-handed typing key area, why?

The division of labor in the key area of two-handed typing is more scientific, and everyone is more familiar with it.

Therefore, it is believed that the importance of one-handed typing lies in the parallel movement of the left hand.

The left hand will be panned and placed in turn

ASDF area (where the left hand should be placed for both hands typing).

FGHJ Zone (Standard Zone for One-Hand Typing).

jkl；Zone (where the right hand should be placed for both hands typing).

In other words, when you're going to type with one hand, it's important to move your left hand in the three areas.

This probably means that when you're typing with your left hand, when you want to use the corresponding letter, move the area where your left hand responds and then press it using the standard typing method.

Specifically, when the desired letter appears in the ASDF area, first move the hand completely from the standard area (FGHJ) to the left-handed standard area for two-handed typing.

Then use the two-handed typing method to type (this part is easier to type with the left hand, please refer to the following for the right hand to type jkl with the left hand; area content, and think backwards)

When the desired letter appears in the FGHJ area, it may be a little uncomfortable at first, but as with typing in the ASDF area, there are few fingers responsible for the keys, so it only takes time to get familiar with it. It is worth mentioning that the observant can see that this area is the same as the ASDF area mentioned earlier and the JKL that will be mentioned later; There will be an intersection of some buttons, how to solve this situation once encountered?

My personal opinion is that if you can strike, you don't move, after all, one-handed typing is based on the parallel movement of the hand, and the time it takes to move is very long, for example, at this time my hand is in the FGHJ area, but I want to type an F, so naturally I can press F directly with my little finger instead of moving my hand to the ASDF area and then pressing F with my index finger, obviously the latter takes longer.

When the desired letter appears in JKL; Personally, I think this is more troublesome, that is to say, use the left hand to control the key area of the right hand, in which the little finger occupies a very important position, so please pay attention to practice the flexibility of the little finger. The typing method has been introduced in detail earlier, and I will not repeat it here, the only trouble is how the spacebar should be struck, and I personally think that there is no better way to use the little thumb, just practice more.

I'm still used to using my left hand. Or put it in its place. Five-stroke input method. Or the left hand is used more. Jump over and press it every now and then. Of course, it's impossible to have one hand and you want to have two hands as fast.

I haven't heard of it. I've only heard of it with both hands. But you can also use one handIn short, not fast with both hands.

There are systems that can type kanji with one hand. For example, the 98 king code input method includes this input method. It uses only the number keys on the keypad to enter Chinese characters. There are other input methods as well. Please refer to the text:

New Stroke Input Method:

A really simple input method that uses and can type as long as you can write.

Anyone can learn to import Chinese characters in less than two minutes.

Solve the threshold for computer beginners to learn to type.

It's simpler than any other input method (Wubi is too difficult to learn, simple is the last word).

The input efficiency is higher than that of the pinyin input method (the pinyin repetition rate is too high, and not everyone understands pinyin).

It is more efficient than traditional stroke input (solving the problem that traditional stroke input is too inefficient).

Constantly updated and optimized, the new stroke is aimed at making input standards from PCs to mobile phones and handheld devices.

Input Method 1New stroke input method press"The order in which Chinese characters are written in strokes"Typing.

2.with"Keypad"Operation, 5 keys for typing, 1, 2, 3, 4, 5 for :"one", 丨", 丿",", b"

3.Keypad"+"is a page turn key.

4.Keypad"/"To toggle the word selection status key, press"/"button, then press 0-9 to select the corresponding word, 6-9, 0 and enter.

key to select words directly.

5.Keypad".del"For the removal key, the large keyboard","or"."Enter a key for Chinese punctuation (only when set to Chinese symbols.)

Effective). 6.Keypad"*"For word mode, you can enter the word split into words.

7.The large keyboard 0-9 can also be used directly, and other keys can be used normally.

8.If it's a laptop, in"Input method setting interface"will"Computer type"Set to"Notebook", for notebooks.

Large keypad numeric key input,"or"\"Toggles the word selection status.

9.If you want to type with a different key, in"Input method setting interface"Settings"1 2 3 4 5"The corresponding button is sufficient.

10.If you want to enter traditional Chinese characters, in"Input method setting interface", checked"Enter Traditional"I do not choose it"Enter Simplified".

11.In"Input method setting interface", you can set different styles and colors of the interface, etc.

12.You can type with one hand, and you can also type and chat**.