How to add laundry detergent to Sanyang automatic washing machine

Sanyoqun automatic washing machines also have two forms: drum and sleeve cylinder, and the way to add laundry detergent is different

Sleeve washing machine.

There is no special detergent to put in the washing machine, so it can only be directly put into the cylinder and then carry out the washing program.

Of course, there is no pre-set softener, only the last rinse is carried out directly into the sleeve to achieve the effect of making the clothes soft.

Drum washing machine, there are two different detergent addition tanks, described separately below, how to use, marked on **.

In fact, these are described in detail in the manual, and users can also read the manual carefully, which can also be easily mastered and used.

A simpler form:

The detergent preset box with the pre-washed drum washing machine:

Of course, the drum washing machine can also be like a sleeve washing machine, directly add the washing powder to the drum, and then close the door to carry out the washing program.

This is especially applicable to the use of laundry detergent, because the detergent tank has no baffle, and the laundry detergent will leak directly into the inlet and remain on the wall, which is not conducive to later rinsing.

1. It can be placed near the control panel in a box for washing powder and softener, put it in, and the washing machine will automatically add it according to the situation.

2. You can also pour it in at your own discretion before washing clothes.

Pour directly into or add to the detergent box that comes with the washing machine.

The specific use methods and steps of Sanyang drum washing machine:

For the installation of the drum washing machine, place the washing machine on a solid and flat ground, adjust and install it, connect the water inlet hose with the faucet and the water injection port of the washing machine, and open the faucet, put down the drain pipe, and insert the drain pipe mouth into the floor drain hole; If it is a drainage structure, hang the drainage pipe on the edge of the pool.

Plug in the power plug, press the power button, and turn on the power of the washing machine.

Add detergent to the washing machine detergent container and gold spinning or clothing softener to the washing machine laundry softener container.

Place the laundry that needs to be washed in the washing machine drum and close the washing machine door. Decide on your laundry options and set up your laundry routine.

Depending on the amount of dehydrated laundry to be washed, select the high, medium, and low water levels set the water level switch.

Start the washing machine, turn on the water inlet solenoid valve, and start the water inlet (at the same time, flush the detergent that was placed in the detergent container box into the machine).

When the water injection reaches the predetermined water level, the water level switch contact is turned on, and the computer controller sends a command to close the solenoid water inlet valve at this time, and the washing machine starts to run automatically (washing--- rinsing--- dehydration is completed).

At the end of the entire laundry washing program, the washing machine automatically shuts down after the beep is announced.

It is recommended to read the instruction manual again before use.