Mobile phone film tutorial, how to apply mobile phone film tutorial

1. Wiping the screen is an important part of the preparation, and the cleaning liquid does not need to be sprayed too much, but it will affect the efficiency of wiping the screen, and sometimes it will be contaminated with dust because the screen is too wet.

2. In addition to the cleaning liquid, you also need to pay attention to the method of wiping the screen, if you drag it back and forth, it is difficult to clean the screen thoroughly, and it is easy to leave traces of the cleaning solution.

3. Most of the current films use a three-layer structure, compared with the previous two-layer products, the three-layer film greatly reduces the difficulty of operation, and is more suitable for ordinary consumers without any experience.

4. In addition to the convenience of operation, we can also tear off the A side and stick it on the screen first, so as to stick the dust off, which is also a small trick.

5. When carrying out this step, the most important thing is to be careful and patient, even for veterans, there will be deviations in position. No matter which direction you choose to start with, compare carefully before starting.

6. It doesn't matter if you find the misalignment after pasting, just lift the B side again, and then compare and paste it again. During this process, be careful not to let dust get between the screen and the film.

7. Since the A side and the B side are glued together, it is best to start from the corner when peeling off, pry up an edge first, and then press and hold the B side with your fingers and then remove the whole A side.

8. Basically, every time you stick the film, you need to catch up with bubbles, and the role of hard cards is this. Compared to handling air bubbles with your fingers, a flat, hard card will allow for a more even and thorough treatment.

9. The step of catching up with bubbles is "big first and then small", take care of the larger area first, and the remaining small bubbles can be processed slowly. During operation, try to rush to the nearest edge, which can also shorten the "distance" and increase the success rate.

10. These "repeatedly banned" bubbles cannot be solved by using cards to catch up, the reason is that they are contaminated with some dust, most of which are caused by negligence. In this case, another auxiliary tool, wide tape, is required.

12. When pulling the adhesive tape, you can't use force in the horizontal direction, you need to detach it along the adhesive tape and the sticking place on the B side, otherwise the whole film will be dragged away.

To sum up, the steps of mobile phone film are mainly the following:

1. Clean up the screen;

2. Correct the position of the film;

3. Correction, air bubbles, and ash cleaning.

In fact, like doing other things, film is also a skilled job, practice makes perfect, and it is normal to paste a few films at the beginning. After grasping a few key points, all that remains is care and patience, and the details mentioned above also need to be paid more attention to in the operation. For novices, the last step is basically to hover between catching bubbles and cleaning the ash, repeating the operation several times.

<> prepare the film material and mobile phone.

Usually purchased film kits contain a tempered film, a wet wipe, and a dry cloth.

Clean your phone. Let's first lead roll and tear open the paper in the first step, and inside is a wet paper towel. Usually before we post it, we must wipe this screen clean, and there should not be any dust particles on it, otherwise there will be a lot of small bubbles when it is posted.

Then we tear the paper of the second part, which is a dry cloth, we use a wet paper towel to wipe the dust on it, and immediately use this dry cloth to wipe the moisture on it, if there is a sticker, we use the sticker to dip the dust on it.

Peel off the toughened film of the phone.

Next, we began to tear off the tempered film of the mobile phone, when tearing off the tempered film, the action must be gentle, tear off the layer of paper on it, and then put the sticky side, directly down, and then aim at these holes, it must be neat, and put down the tempered film slowly.

Eliminate air bubbles. Next, we poke the middle of the phone with our fingers, and the tempered film itself is slowly pasted on the screen of this mobile phone, and then, we use our fingers to squeeze out some bubbles on the edge, okay, now the tempered film, we have finished pasting.

Summary. We can see that the paste is very flat and there are no bubbles, and finally we use a wet paper towel to wipe the fingerprints on it, and it is now done.

You can post it at home, you can get it in a few minutes, and it is also very cost-effective, which is much more cost-effective than more than 100 yuan outside.

The tutorial for mobile phone film is as follows:Tools Raw materials: Huawei P30, EMUI10, tempered film set, clear water.

1. First clean your hands to keep them in the clean chain.

2. After the mobile phone is flattened, the person should be as far away as possible from the position of the mobile phone, and gently buckle the corner of the tempered film with a fingernail along the edge of the mobile phone.

3. When the corner of the tempered film is lifted, the tempered film can be broken down along the direction of the paste.

4. Before pasting the new film, please wipe the mobile phone screen with an alcohol swab, call Hu and then wipe off the excess alcohol on the screen with a dust-free cloth.

5. Tear off the protective layer of the new film and stick it on the opening of the mobile phone screen.

The tutorial of mobile phone film is as follows:

Prepare the materials and tools to be used first, generally when buying mobile phone film online, it is a complete set, wipe the mobile phone screen with wet wipes, and wipe the bezel of the screen until it is wiped clean;

After the screen is wiped clean, take out our screen cleaning cloth, wipe the mobile phone screen and bezel again, wipe the residual alcohol and fine dust, and the wiped mobile phone screen is likely to have some dust left, then you can use our electrostatic dust removal sticker to suck off the fine dust on the screen;

Then take out the prepared mobile phone film, first tear off a small area of the mobile phone film protective film close to the earpiece, align the mobile phone film part of the protective film with the mobile phone earpiece, and then slowly put it down, so that the mobile phone film is automatically adsorbed to the screen, and then slowly pull down the protective film, and when the mobile phone film is completely adsorbed on the mobile phone screen, our mobile phone film will be pasted.

Tools Raw materials: Huawei P30, EMUI10, tempered film set, clear water.

1. Clean your hands first to keep them clean.

2. After putting the mobile phone flat, the person should try to stay away from the position of the mobile phone, and gently buckle the corner of the tempered film with a fingernail along the edge of the mobile phone.

3. When the corner of the tempered film is lifted, the tempered film can be broken down along the direction of the paste.

4. Before pasting the new film, please wipe the mobile phone screen with an alcohol cotton and wipe off the excess alcohol on the screen with a dust-free cloth.

5. Use a dust suction film to suck off small dust that is not easy to wipe off.

6. Tear off the protective layer of the new film and stick it on the opening position of the mobile phone screen.

7. Gently squeeze to complete the dust lead film.

The tutorial of mobile phone film is as follows:Tools: mobile phones, mobile phone films, flannel.

1. Prepare the mobile phone film.

2. We use flannel and dust strips to thoroughly clean the screen of the mobile phone.

3. Put the side marked 1, facing the mobile phone, and the side marked 2, facing yourself.

4. Uncover one-third of the side of 2.

5. Find the world mokong wiping cloth that I used just now, hold the wiping cloth in my left hand, press the pasted part, and at the same time keep peeling off the middle finger and ring finger of my right hand to search the blind side.

6. Uncover all 2 and paste it all.