-
Then you've bought a pirated one!
-
Under normal circumstances, the situation that the mobile phone does not turn on is mostly caused by two reasons: the mobile phone cannot be turned on after being turned off due to excessive discharge, or the phone does not turn on due to flashing.
Cases of over-discharge. After the phone runs out of power and automatically shuts down, it will also immediately connect to the charger for charging, but it is possible that the phone will not respond at this time. This is caused by the battery being over-discharged and the voltage is too low to have normal charging and power-on conditions.
You can try to press and hold the power button for more than 10s first, if the phone vibrates, you can release the power button, and then connect the charger to charge for more than half an hour before turning it on.
If the phone does not respond at all when you press and hold the power button, then you need to refuel, keep the power button and plug in the charger at the same time, release the power button after the phone vibrates, charge normally for more than half an hour, and then turn it on.
If you don't turn on the phone due to flashing, press the power button and the volume down button at the same time on the shutdown interface, let go after vibrating, and see if you can enter recovery mode.
You can enter the recovery mode, find the clear data and cache in the recovery mode, and restart the phone after double clearing. This method can mostly solve the problem of infinite reboot after flashing or stuck in the boot interface and unable to boot.
After Shuangqing, it still can't be turned on normally, and it is recommended that you can save bricks with a line brush.
If you can't enter recovery mode, then in the shutdown interface, press the power button + volume up button at the same time to see if you can enter fastboot mode. If you can enter fastboot mode, if the phone is not flooded, bumped, or dismantled, you can also directly try to solve the problem by wire brushing.
Unable to enter recovery mode and unable to enter fastboot mode, in this case, it is recommended to go to a professional repair shop to help try to solve it. Remind everyone that you must back up before flashing.
-
Problems with the charger, battery or charging interface, will lead to your situation, first check whether the output voltage of the charger is correct, and then check whether there is anything dirty in the charging interface, if there is no problem, then it is a problem with the mobile phone battery.
-
2. It may also be that there is a problem with the charger or data cable, you can change the charger or change the data cable to recharge it.
3. If there is a problem with the mobile phone system, you can try to press and hold the power button and the volume button to see if you can enter the recovery mode.
4. If the circuit board is damaged, go directly to the after-sales service.
Hope it helps.
-
First of all, check whether there is any problem with the charger and charging cable. On the premise of ruling out the problem of the charger and charging cable, it is best to send it for repair - it is possible that the tail plug is broken, the battery is broken, and the charging circuit is broken.
-
Replace the charger, whether the charging cable can be charged normally, if not, it may be that the mobile phone battery is broken and needs to be replaced.
-
The phone charging does not respond, it is recommended that you:
1.If the phone automatically shuts down due to low battery power, it may not turn on when the charger is just plugged in, it is recommended to try to turn on again after charging for 15-30 minutes;
2.Check that the connection between the charger and the socket is secure.
3.Replace the charger and data cable separately, or replace the charger + data cable at the same time;
4.If you plug in the charger, the breathing light of the mobile phone can be lit up, and the battery icon in the upper right corner shows the charging status (green), but the battery power growth can not be clearly felt, which is generally caused by the low power of the power supply equipment, it is recommended to use the original adapter and data cable to try.
5.If you plug in the original charger and do not perform any operation, and the mobile phone or tablet is hot, it is recommended that you unplug the charger and take the mobile phone, tablet, original charger and data cable to the outlet for testing.
-
The Redmi phone cannot be charged and turned on, it is recommended to try the following operations: 1. Unplug the battery and reinstall it to see if it can turn on normally. 2. Whether it can enter recovery.
How to enter recovery: In the shutdown state, first press and hold the "volume up button" to not let the Redmi phone run out of power and can't charge it, what to do 1, the battery of the Redmi phone can't be charged, it may be that the battery has entered a dormant state. This is mostly caused by the user running out of power and the phone automatically shuts down.
The solution to this situation is to remove the battery, wait 5 minutes, and then reinstall the battery. Connect your Redmi phone to your computer with a data cable, and after 30 minutes, turn it back on. 2. What happens if the Redmi phone can't be charged suddenly?
My red rice started like this at the beginning, and there is a method that has been done now. Turn off --- the battery comes out--- take out the phone card--- charge it directly for 30 seconds--- put the battery in--- press and hold the power button. When I turned it on, I saw that the charge went in.
Then put the phone card in and restart the phone. What should I do if the big red rice phone can't be turned on and can't be charged, it is recommended that you try the following methods to see if it can be turned on:1
Press and hold the power button for 10 seconds to force restart the phone. 2.You can try charging for 20 minutes, then press and hold the power button for 10 seconds to see if it can turn on (the phone is completely out of power and recharged without any prompt).
3.When the phone is turned off, press and hold the volume up button and the power button at the same time for 3 to 4 secondsAfter the vivo phone logo appears on the phone, let go of the button to enter recovery mode, first select wipe data factory reset, select wipe cache partition after completing the waiting interface jump, and select reboot system after completionRedmi phone can't be charged Ah Problem cause: 1
Charger issues. 2.There is a problem with the phone itself.
Solution and steps:1The first thing to do should be to turn off the phone, then restart it, and then charge the phone to see if it can be charged.
2.If it still fails to charge after restarting, check whether the power socket is in poor contact or has lost power. 3.
If there is no bad contact or power failure, you can try to change to another charger to charge to see if the phone can be charged normally. 4.If none of the above methods work, it may be that there is a problem with the charging port of the mobile phone, and you can take it to a repair shop to check it.
-
、About the aboveWhat is the reason why the Redmi phone does not respond when charging? For this problem, first check whether the power socket isThere is a normal 220 volt voltageWhen the voltage is normal, check whether the original charger is normal.
Check the inside of the original charging data cable to see if there are problems such as poor contact.
Check the charging cable plugwithMobile phone charging interface, check the inside between the two, whether there is poor contact, etc.
Check if the battery inside your phone is normal(For this inspection, it is best to ask a professional master to test the mobile phone battery).
-
1.Redmi mobile phone can not be charged when the spring is turned on, it is recommended that users can hide branches to try to back up the phone data first, and then restore the phone to factory settings to eliminate system failures.
2.After the phone factory reset, the hand will return to its initial state, and the user will try to charge it. Pick this up.
3.If it still can't be turned on and charged, it is recommended that users try to change the charger to charge.
4.If the fault cannot be eliminated, it is recommended that the user bring the mobile phone, invoice, and warranty card to the local brand customer service for testing.
-
Hello, your Redmi phone can't be turned on, and there is no response to charging, the phone may be hardware bad, this reason is more than line, it needs to be detected before it can be determined.
-
Summary. The Redmi phone can't be turned on, and the charging doesn't respond Hello dear, I'm glad for your question: If it's not an all-in-one Redmi phone, then you can try to use a universal charge if it can't be charged.
2. If it is an all-in-one machine that cannot be charged, then you can detect whether there is a problem with the charger. 3. If there is a problem with the charger, replace it in time, and then charge it and turn it on. 4. If it is not caused by power problems, then it is caused by system problems, and you can go to Xiaomi after-sales service to flash the phone for free.
Generally, it is not recommended to force the mobile phone to turn on again after it is automatically turned off when it is out of power, which will cause great loss of battery and not good for the mobile phone, which will easily cause the situation that the phone cannot be turned on and cannot be charged.
The Redmi phone won't turn on, and the charging doesn't respond.
The Redmi phone can't be turned on, and the charging doesn't respond Hello dear, I'm glad for your question: If you don't have a reputation for being an all-in-one Redmi hand laughing source machine, then you can try to use universal charging if you can't charge it. 2. If it is an all-in-one machine that cannot be charged, then you can detect whether there is a problem with the charger.
3. If there is a problem with the charger, replace it in time, and then charge it and turn it on. 4. If it is not caused by power problems, then it is caused by system problems, and you can touch the virtual state to go to Xiaomi after-sales free flashing processing. Generally, it is not recommended to force the mobile phone to turn on again after it is automatically turned off when it is out of power, which will cause great loss of battery and not good for the mobile phone, which will easily cause the situation that the phone cannot be turned on and cannot be charged.
The charger is fine, right?
The charger is fine, right? Hello dear, I am glad that your problem returned to the state: there is no problem with the charger If there is a problem with the charger, replace it in time, and then charge it and turn it on.
If it is not caused by a power problem, then it is caused by a problem with the Huaishi Li lead delay system, and you can go to Xiaomi after-sales service to brush the machine for free. Generally, it is not recommended to force the mobile phone to turn on again after it is automatically turned off when it is out of power, which will cause great loss of battery and not good for the mobile phone, which will easily cause the situation that the phone cannot be turned on and cannot be charged.
How to force it to boot on?
How to force the boot to be buried? Hello dear, glad of your question: press and hold the volume up key and the power button at the same time for five seconds; The local limb mobile phone vibrates once, let go of the hand; The fastboot screen will appear on the phone, and Changtong Qiaoshi can force it on by pressing the power button.
-
Hello dear, <>
The reason why the Redmi phone can't be turned on and doesn't respond to charging: 1. Poor contact. 2. Replace the power cord or data cable.
Try to replace the data cable or charger, if there is a land transportation capacity that is the fault of the data cable or charger, replace them separately to identify what the problem is. 3. Turn the computer off and on again. If you have tried all the above methods and still don't work, it is recommended to turn off the mobile phone and then turn it on.
Sometimes the mobile phone is chaotic in its own system, and it may also lead to failure to charge, I hope this service can help you <>
Wishing you well; Have a good life and all the best!
Hi! 1. It is normal for current smartphones to heat up for a long time, this is because most Android mobile phones use high-performance CPUs, and many new mobile phones this year use quad-core or 8-core CPUs. This is the same as the CPU of the computer, the better the performance, the greater the power consumption, and the power consumption is large, the battery will be discharged quickly, the battery will heat up when it is discharged quickly, and the processor will also heat up when it is working, resulting in the higher temperature of the mobile phone CPU and battery, and we will feel that the phone is very hot. >>>More
Open the system settings, shortcut to open the way: function key - system settings. >>>More
Redmi 1S-Unicom Telecom Edition, 4G Edition Redmi Note and Xiaomi mobile phone series use Qualcomm's processor, (Mi 3 Mobile Edition uses Nvidia processor, but the Sanqing method is the same.) The method of three clearances is as follows: >>>More
In this case, the general situation is that the mobile phone battery is not charged, or the system of the mobile phone is damaged and cannot be turned on. >>>More
If you have a problem with your phone, it is recommended that you back up your important data first, and then perform a full package of wire flashing (it is recommended that you flash to the latest development version). >>>More