When a new refrigerator is purchased, it needs to be left static for 8 hours before it is powered

1. It is best to leave the refrigerator for more than three hours before powering on, because the refrigerator will tilt and bump during handling, so the refrigerant in the compressor will be there.

May enter the capillary, evaporator.

If the compressor is turned on in this state, the compressor will be similar to idling, and it will not be refrigerated, so it needs to be left standing.

2. If the transportation process is excessively tilted or violently shaken, the lubricating oil will be free from the bottom of the cylinder and infiltrate into the cylinder block, so that the lubricating oil at the bottom of the cylinder will be reduced.

Extended Materials. Stopping the refrigerator in winter will indeed reduce the service life of the refrigerator, because the plastic in the refrigerator liner is more likely to age at room temperature than at low temperature, so continuous use of continuous low temperature can slow down the aging phenomenon and relatively prolong the service life of the refrigerator. In addition, if the refrigerator is not used for a long time, the internal pipes will be corroded, resulting in internal leakage.

In winter, when there is nothing in the refrigerator, you can shift it.

Adjust to the lowest, then some refrigerators support the refrigerator compartment to be turned off separately, which not only ensures the normal operation of the compressor, but also saves electricity, and is also a way to maintain the refrigerator.

If the refrigerator is not in use, it means that the refrigerator will completely stop running, and it will not produce water vapor heat that disperses the condensation of external causes, which will rust the metal parts of the refrigerator, resulting in a shortened service life of the refrigerator, and in serious cases, the refrigerator will break.

5 things to pay attention to when transporting the refrigerator.

In the past, refrigerators were carried upright and could be used with electricity.

Generally speaking, newly purchased refrigerators need to sit for 2-4 hours before they can be powered on.

Therefore, after the new refrigerator arrives at home, it needs to be left for 2-4 hours before it can be turned on. However, according to the general situation, it will be left for 24 hours to allow the lubricating oil to flow back into the compressor. In addition, when you buy a new refrigerator, you also need to clean it, so that the odor in the refrigerator can be used to make it more safe.

When using the refrigerator daily, you should also pay attention to some rules of use.

1. Do not use the refrigerator for a long time.

If you don't use the refrigerator for a long time, you need to cut off the power, but it should not be too long, and it is generally used once every three months or so, so as to avoid the aging of the internal circuit of the refrigerator and the damage of accessories, thereby reducing the service life of the refrigerator.

2. Placement.

Refrigerators generally cannot be placed against the wall, and a certain amount of ventilation space needs to be reserved, because refrigerators also need to dissipate heat. It should also be placed in a ventilated and dry place to ensure the safety of electrical appliances.

3. Clean the refrigerator.

It is inevitable that the refrigerator will have odors after a long period of use, so it is necessary to clean the refrigerator regularly to prevent the accumulation of dirt and bacteria that can contaminate the ingredients. Although some refrigerators are equipped with sterilization and deodorization devices, they still need to be cleaned after a long time.

All in all, as a necessary electrical appliance for everyone's daily life, refrigerators should also be used in accordance with the specifications in use, so as to extend the service life of our refrigerators. After all, refrigerators are large appliances, and the longer you use them, the more you can save money.

Do not leave the new refrigerator for 24 hours. The newly bought refrigerator can stand for 2-6 hours, and it does not need to stand for 24 hours so long. The standing time and season of the refrigerator are also related, generally in summer to carry the refrigerator, the refrigerator only needs to stand for 2-3 hours after the refrigerator is placed.

If you are carrying the refrigerator in winter, you need to let it sit for 6-7 hours after the refrigerator is placed.

Because the lubricant in the refrigeration system will flow out during the re-handling of the refrigerator, we need to let the refrigerator sit for a period of time to allow the lubricant to return to its place. Moreover, during the handling of the refrigerator, its internal spring may be overstretched, and letting the refrigerator stand for a period of time is also conducive to the spring recovery force.

Precautions for purchasing a new refrigerator

After the refrigerator is bought, it is necessary to prepare a proper position to place the refrigerator, not close to the wall, and generally have a certain distance from the wall, which is conducive to the heat dissipation of the refrigerator.

In addition, it is necessary to check whether the refrigerator is grounded, read the instructions carefully before use, and do not extend the external power cord of the refrigerator without permission, if possible, it is recommended that the user connect it directly to the wall socket, which may cause oil circuit failure during transportation.

The above content refers to Encyclopedia - Refrigerator.

After the new refrigerator is carried back, it should be left to stand for about two hours before powering on the test machine.

Attached to the common sense of refrigerator use:

1. After the new refrigerator is purchased, it should be wiped several times with a clean rag, but do not close the door after wiping it clean, open the door to let the odor inside dissipate and then use the electricity, or use an electric fan to blow it inside to speed up the emission of the odor.

2. After the new refrigerator is carried back, it should be left to stand for 2-24 hours before powering on the test.

3. The refrigerator should be placed in a cool and ventilated position, and a certain amount of space should be left around it to facilitate the ventilation and heat dissipation of the refrigerator and improve its refrigeration efficiency.

4. When the machine is powered on, the temperature setting of the freezer should be adjusted to minus 18 degrees, and the temperature of the refrigerator should be about 2-6 degrees. If there is no food in the freezer that needs to be stored for a long time, the temperature can be appropriately adjusted to about minus 12 degrees to minus 16 degrees, which will save more electricity, especially in summer. The same goes for the refrigerator, which can also be raised to between 8-15 degrees if there are no special food requirements to preserve, which is also more energy-efficient.

The mechanical thermostat should adjust the size of the digital gear according to the ambient temperature of the season, adjust the smaller digital gear in summer, adjust the middle gear in spring and autumn, and adjust it in the larger digital gear in winter. In summer, it is the most power-efficient to adjust to 1st gear.

5. When the machine is powered on, do not put in the food first, wait for the temperature in the refrigerator to drop and stabilize, and then slowly put in the food after the compressor starts and stops normally, and do not put too much food at one time to avoid overload of the compressor.

6. The food placed in the refrigerator should be sealed and wrapped in a container or food bag to avoid odor caused by mutual odor.

Generally, whether the refrigerator is newly bought or moved, as long as it is moved, it needs to be static for a period of time before it can be used with electricity, but it will not be used for eight hours.

How long does it take for a new refrigerator to arrive at home?

It is best to leave the refrigerator for 6-10 hours before turning it on. There are two main reasons:

1. Because the lubricating oil and refrigerant are completely enclosed in the refrigeration system when the refrigerator is completed, and the refrigerator will tilt and bump during the handling process, then the refrigerant in the compressor may enter the capillary tube and evaporator, if the machine is turned on in this state, the compressor will be similar to idling, resulting in damage to the refrigeration system.

2. If the transportation process is excessively inclined or violently shaken, the lubricating oil will be free from the bottom of the cylinder, infiltrating the cylinder block to reduce the lubricating oil at the bottom of the cylinder, if the machine is started at this time, the running parts can not be lubricated enough to cause wear, which will shorten the service life of the compressor.

Based on the above two reasons, for the sake of insurance, the installation and delivery personnel will remind the user to stand still for more than 3 hours before powering on the new refrigerator.

Common sense of refrigerator maintenance:

1. After cleaning the refrigerator, it should be dried in the sun and moisture-proof.

2. The position of the refrigerator should be flat, otherwise it is easy to produce noise.

3. Place it in a ventilated and dry place, which is conducive to the ventilation and heat dissipation of the compressor and prolongs the service life of the refrigerator.

4. The refrigerator should use a good quality socket during use to avoid poor contact.

5. In the process of transporting or pushing and pulling the refrigerator, it is necessary to pull and put it gently, so as not to cause the external pipeline to be broken and the compressor to jam.

Summary. Hello, the newly bought refrigerator should be left for 2-4 hours before it can be powered on.

Hello, the newly bought refrigerator should be left for 2-4 hours before it can be powered on.

Because the newly bought refrigerator in the process of transportation, the box may vibrate and tilt, causing the lubricating oil in the compressor to flow out, so it is necessary to stand for 2-4 hours to make the lubricating oil return to the compressor, so that the refrigerator can work normally, otherwise it is very likely to cause refrigerator failure.

The length of time you want to keep the smile is related to the angle of inclination of the refrigerator during the handling process, the degree of brightness and movement, and the temperature of the environment. In the instruction manual of the refrigerator, the standing time given is 2 vegetables and potatoes are missing 4 hours.

In order to insure the slag excavation, we generally recommend that it be placed for 24 hours after each handling and then powered on (data** in the manual of the Bingjian loose trouser box). Of course, this data is very simple and conservative, and users can appropriately reduce the placement time according to their own situation.

1. After the newly purchased refrigerator is bought, it must be left for at least two hours before it can be turned on. And the longer it is placed, the better the effect will be. Fanhui also decided based on the current temperature situation, if in summer, because the refrigerant in it can flow and does not freeze, the standing time can be slightly shorter, and it can flow into the compressor after two or three hours.

2. In winter, the temperature is relatively low, and the freezing liquid may have been frozen and solid, so the standing time should be slightly extended, such as up to six hours.

3. There may still be a plastic smell in the newly purchased refrigerator, so we also need to ventilate and disperse the smell before we can power up the test.