Where is the Nissan Teana 2 5V6 exhaust gas circulation felling?

Updated on Car 2024-08-05
3 answers
  1. Anonymous users2024-02-15

    The fault ** you described does not exist, it is either P1635 or P1655, I will send you the diagnostic definitions of these two fault codes, you are looking for a maintenance worker to see how it helps.

    Fault code: P1635

    Chinese definition: Sensor supply voltage - circuit a fault.

    English definition: sensor supply voltage - circuit a malfunction

    Category: Powertrain systems (manufacturer-defined).

    Background: This fault code appears if the ECC detects that the 5 volt reference voltage1 circuit is below volts or above volts for more than 10 seconds. The 5 volt reference voltage 1 circuit is responsible for powering the manifold absolute pressure (MAP) sensor, throttle position (TP) sensor, exhaust gas recirculation (EGR) valve position sensor, and oil pressure sensor.

    Fault code: P1655

    Chinese Definition: Evaporative Discharge (EVAP) Carbon Tank Purge Valve - Circuit Fault.

    English definition: Evaporative Emission (EVAP) Canister Purge Valve - Circuit Malfunction

    Category: Powertrain systems (manufacturer-defined).

    Background: The evaporative emission (EVAP) system directs gasoline vapor from a fuel tank into a tank containing activated carbon that can absorb gasoline vapor. The engine then uses fresh air to blow these gasoline vapors into the engine's combustion chamber.

    Causes of failure include failure of the EVAP solenoid valve itself or its circuit, failure of the electronic control module (PCM or ECM), etc.

  2. Anonymous users2024-02-14

    Hello, it is recommended to look for it in the valve chamber cover.

  3. Anonymous users2024-02-13

    The Nissan Teana V6 will be equipped with the following 4 exhaust valves: 1. Exhaust valve: used to control the exhaust gas from the cylinder, usually located on the cylinder head of the engine.

    2. Electronic throttle valve: used to control the amount of air intake, which is adjusted according to the driving conditions of the vehicle and the needs of the driver. 3. Fuel tank evaporation control valve (EVAP valve):

    It is used to control the slow inflow of fuel vapor from the tank system into the engine combustion chamber to reduce harmful gas emissions. 4. Gasoline evaporation control valve (Canister Purge valve): It is used to control the flow of gasoline vapor in the system before fuel evaporation to prevent harmful gas leakage.

Related questions
6 answers2024-08-05

The timing chain of Nissan can be proofread in the following ways. >>>More

7 answers2024-08-05

All of them are mid-to-high-end domestic cars.

The Camry has a slight increase in size, while the wheelbase and track have been raised even more, which gives the Camry an impressive interior. At the same time, in terms of comfort, safety, handling, high-tech and many other aspects, Camry has comprehensively surpassed the previous generations of products, Camry with a liter 2AZ-FE engine, in-line 4-cylinder 16-valve, assisted by VVT-i, the maximum power is 123kW 6000rpm, the maximum torque is 224Nm 4000rpm, with a 5-speed automatic transmission. As we all know, Toyota's best thing is the allocation of engine power, even if the Camry weighs 1550kg, the car will not cause excessive load from the start. In terms of newness, the Camry is equipped with a keyless start device, which was previously only available in premium cars. >>>More

12 answers2024-08-05

Formaldehyde removal method for new cars: 1. Ventilation and deodorization method, within half a year after the purchase of a new car or a period of time after decoration, you should develop the habit of driving with the window open moderately to maintain the circulation and convection of fresh air in the car. 2. Fruit deodorization method, you can place lemon or pineapple and cut the lemon or pineapple, so that its fruity aroma will volatilize well and resist the peculiar smell in the car. >>>More

11 answers2024-08-05

The Nissan automatic transmission uses a 6-speed automatic transmission, which is composed of D gear, which is an automatic gear, and L gear, that is, a low-speed gear, and can only be upshifted to 3rd gear at the highest speed in L gear, which is used in high-torque situations such as slopes and mountain roads, and the specific operation steps are as follows >>>More

16 answers2024-08-05

I'm the Duke of Kai, but I think the female Kai is also quite good-looking. >>>More