How to install the bearing housing and base of the wind turbine

The basis of the bearing seat and the blower is often seen in the installation of Raetts Reitz blower, the use of these two components, mainly in the installation process, some problems in the installation If you can't get the attention of the user, the fan will have a lot of problems in late use, and the use effect can not be guaranteed. Choose to use a fan for the user to maintain the quality of the living environment.

The role will be to assemble the housing and base of the fan, and more importantly, there are many factors that can choose the user fan assembly, or in order to save costs, or to adapt to the environment, however, the specific environment still requires the use of a specific type of Retz blower, in some places, the most important thing to install a fan is the balance between the fan and the mounting surface. Because of the phenomenon that many fans are directly assembled, so the cutting surface on the basis should be properly protected and should not be corroded or operated, and the base is placed on the foundation, in pairwise wedge elevation measurement applications.

When mounting the housing and some data must be installed properly on the basis of the data so as to protect the Leitz blower. The longitudinal level should not exceed, at the measuring level of the spindle, and the horizontal bottom should not exceed 1000, by measuring the level on the bearing surface. This value has a direct impact on the effectiveness of the use of the Retz blower and must therefore be brought to the attention of the user.

For timed Reitz centrifugal fans, the radial position deviation of the fan shaft and the motor shaft should not exceed millimeters, and the tilt should not be exceeded. The bearing assembly of centrifugal fans, the frame of different shaft bearing holes, can be mounted on the rotor, and the rotation is flexible.

The bearing seat and the base should be tightly connected, the longitudinal non-levelness should not be exceeded, measured on the spindle with a level, the transverse non-horizontal bottom should not be exceeded, and the horizontal level should be measured on the faceted surface of the bearing seat in the level.

There are many types of fans, and the installation methods of different fans are not the same, today we will explain to you what problems should attract our special attention when installing the bearing seat and base of the centrifugal fan. In many of the components of centrifugal fans, many people are not careful, always ignore the installation of bearing seats and bases, many times often due to the user's ignorance of this problem, resulting in various problems in the use of the fan, in fact, relatively speaking, the frequency of problems in the assembled machine is indeed more than the problem of the original machine, but if the assembled machine has no problems, its use effect is still very good, but the premise is to master the assembly problem of the fan, In particular, there is a problem between the housing and the base.

There are many reasons why users choose to assemble fans, either to save costs, or to better adapt to the environment, but in any case, a specific environment still requires the use of a specific fan type, for some places, the installation of fans is the most important balance between the fan and the installation surface. Because many fans are directly assembled in the phenomenon, the cutting surface on the base should be properly protected, there should be no rust or operation, and when the base is placed on the foundation, a pair of oblique horns should be used for leveling.