-
The door warning light is always on, indicating that the door is not closed properly.
Solution: 1. Check whether each door is closed first, and then close it firmly after opening.
2. Secondly, check the induction switch at the door door by door to see if there is any invalid and replace it.
-
The way to deal with the door indicator light is to keep it on: 1. Check whether each door is closed first, and then close it hard after opening; 2. Secondly, check the induction switch at the door one by one, check whether there is any invalidity, and replace it; 3. If you are sure that the door is closed tightly and the sensor switch cannot be checked, it is recommended to go to the 4S shop to check the circuit and repair it. The door warning light is always on means that the door is not closed properly, and the door light will only go out when the door is closed, like the top light, mainly to facilitate the owner to know whether the door has been closed.
-
Hello, 1Check that each door is closed first: open it and then close it firmly2
Secondly, check the sensor switch at the door door by door to see if there is any invalid, and replace it 3If you are sure that the door is closed tightly and you cannot check the sensor switch, it is recommended to go to a 4S shop to check the circuit and repair it.
-
Hello, first check whether the door is closed tightly (push open and reclose), if the check is closed tightly, it is a door sensor failure.
-
Drink for the treasure of wealth.
-
Each door has a switch that can be seen on the door frame.
If the doors are closed tightly, the lights will be on.
It means that one of the door switches is broken. You can open a door and manually press the switch, try them one by one, and see which switch feels abnormal.
Generally, the switch is broken, and the switch is mostly electrocuted and oxidized to cause poor contact contact.
-
Four door lights and two front footlights the engine turned off and kept on,
-
1.The door light was always on because the door was not closed properly. If any of the doors are not closed properly, the door light will come on. In this case, the first step is to check all the doors that are closed to see which one is not closed properly, then open the closed door and close it again.
2.If the above method closes the door tightly, the problem is still not solved, is the door light still on? Then it may be that there is a problem with the switch sensed by the door Huaiji.
It is necessary to go to the 4S shop or repair shop to check the circuit, and the door should be repaired in time. If you don't close the door while driving, you are very prone to accidents.
on charge, or on insufficient power.
If it is a problem with the broadband itself, first directly connect to the broadband network cable for testing, and if it is a broadband problem, contact broadband customer service to solve it. 2) If it's a problem with the router, if it can be used originally, it can't be used for the time being, my own practice is to disconnect the power of the router and plug it in, and I'll take a look. In there is a factory reset, from the new strict according to the manual settings can be used, I don't understand, it is not recommended to set it at will (this is under the premise of the correct physical connection, sometimes the router is slow or failed to find the IP address, not that the router is broken). >>>More
No, the double flash of the door opening is automatic. Its function is to prompt the driver to open the door so that he does not know that the rear door is open or closed tightly. >>>More
The fault light is lit to indicate that the engine system is faulty, but the specific component problem needs to be detected using a diagnostic instrument to determine. Common faults of classic Focus include inlet control solenoid valve failure, EGR valve failure, ignition system failure, discharge system failure, etc., please go to the repair shop as soon as possible to check and repair.
If the ESC indicator is green, it is normal and anti-slip. If the ESC indicator is yellow, the electronic stability control system is malfunctioning. >>>More