Samsung s DV model vp 93i wants to transfer the video to the PC

Open VideoStudio step by step according to the guide (software prompts().

You're done.

For a small fee, go to the store and ask someone to burn it down for you.

Can you tell us about your system? XP just forks it up. 98 and. I still spend money.

If the machine is a tape-based machine. If so, buy a cable, install a software, and you can upload it to the computer. If not, you have to equip the computer with a 1394 capture card first.

It can only be recorded in *** format, up to 180 minutes.

There is no such feature.

You can't copy, you can only collect.

There is no such feature.

80 minutes. The computer has a 1394 interface, and it is also possible to use XP's movie maker to capture or other software.

Photography is not permitted.

The Samsung VP-D381i model is relatively early, so it is recommended not to buy it, in case there is a problem with the quality, it will be miserable.

800,000 pixels. The old tape is not cheap at all, and Samsung's card machine is poor, and the DV is even worse, and Samsung's DV and Chinese mainland's DV are actually about the same status.

You take a look at Sony Panasonic, these two are the real more reliable.

You need to connect the 1394 interface of the computer through the 1394 cable, and then transcribe it through a third-party capture software.

Here's how:

1.The DV interface on the camera is a standard 4-pin 1394 connector.

2.Prepare the 1394 cable, which is a cable with a 1394 connector at both ends.

3.Connect the camera to the 1394 connector of the computer via the 1394 cable. (Note: If there is no 1394 interface on the computer, **install 1394** capture card, please refer to the instruction manual for the use of the capture card.) )

4.Rotate the camera mode dial to "player" mode.

If "DV" cannot be displayed, it is recommended to check whether the 1394 cable is intact or whether the 1394 interface on the computer is normal.

6.Open the third-party capture software on the computer, here take "VideoStudio 9" as an example, please refer to the third-party capture software manual for specific use.

8.Select a saved folder, using "Desktop" as an example.

10.Go to the desired end position and click "Stop Capture".

The phone is connected to the computer, first of all, after the installation of Samsung's official kit Samsung Kies, the driver will be installed when the phone is connected!! My phone will appear on my computer! I'm using a 9300 s3

Open the pea clip or 91 mobile assistant and you can copy it.