Some questions about Sony Ericsson W995

It's a dedicated interface for Sony Eyney.,It seems to remember to call it fastport.。。 In fact, it's not easy to break!

My friend's w810 has been used for 4 years and there is no problem...

What you said is also right, if there is a problem with the interface, there may be problems with charging!

But at most this interface is oxidized! Then you use a knife to scrape the oxide layer can also continue to be normal and practical, the problem of loose slide cover! This will appear sooner or later, after all, it is normal mechanical wear.

This is the case for all of them.

But the workmanship of w995 is still very good.,It shouldn't be too serious.。。。

It probably won't affect the use of this. I have a friend who uses Nokia's N81. That slide is so loose that I personally think it's a bit exaggerated. It also does not affect the normal use of . . .

Buy it with confidence! You won't be disappointed. 。After all, they are all 9 series mobile phones, and the quality is still very good.

Hello, I have used a lot of Sony Ericsson mobile phones, as long as you don't break the small copper piece of the connector when charging, and you should be careful not to get wet and it won't rust. The slide will be a little loose, as long as the looseness is not particularly obvious, I am now using Sollove W995

It is a unique interface of Sony Ai This interface should be careful when you use it, otherwise it will be unplugged sooner or later Pay attention to the direction of pulling Look at the manual, some up and some down If the maintenance is good, it is not very bad.

But the few Sony Ai I used for a long time will be in poor contact with the interface, but only one is completely broken

In terms of slide cover, W995 is a flagship product, the workmanship is very good, basically it is not loose, and the feel is good, and it does not affect the use at all.

First of all, you need to determine whether the charger port is loose.

Personally, I also use w995, and I have been using it for half a year? There has also been the kind of problem you said, but the quality of the licensed charger is really good recently, and I still use the charger with the C902 I bought 2 years ago (cable length).

Do you often break off when charging?

In my personal experience, this is not the cause of loose interfaces, the main reason is probably the aging of the contacts, resulting in the inability to connect normally.

Of course, if you don't believe me, you can also try the following methods:

Take a cotton swab, dip it in a little medical alcohol, and then wipe it on your hand first, and when the cotton swab has less alcohol and is slightly dry, carefully wipe the contacts of your phone.

The main thing is the lower contact, and the upper one can be wiped slightly, so be careful.

Then you will see that the place where the cotton swab has been wiped over the contact will be a little black, then change the root, and then use the same method to wipe carefully, remember that the alcohol should not be too much, of course, not too little, about 3 cotton swabs will be fine, and then you connect the power test to see if it will get better.

Theoretically speaking, this can be solved, anyway, the individual solves it every time, but the symptoms are not cured.

W995 estimates that a large number of machines have this problem, and it is likely that the contacts are not done well, so when this method cannot be used, go to the official maintenance point to change the contact.

Just go and solder it, my P4 used to be like this, just fix it.