Ask the server to launch a dedicated CPU processor Intel Xeon 3 80GHz CPU with a normal heating temp

Updated on technology 2024-02-09
12 answers
  1. Anonymous users2024-02-05

    normal temperature.

    It is generally stable in the range of 30 degrees Celsius. In other words, the CPU has a harvest temperature of 65 degrees, and the maximum temperature of the CPU is 30 degrees Celsius based on the maximum of 35 degrees in summer. And so on, if your ambient temperature is 20 degrees now, it's best not to exceed 50 degrees on the CPU.

    Of course, the lower the temperature, the better. No matter how far you overclock, don't make your CPU more than 30 degrees above the ambient temperature.

    2.As for the 110-degree plus you said, that's very abnormal.

    We hope you find the above reply helpful. Intel is wonderful because of you!

  2. Anonymous users2024-02-04

    A laptop's CPU is considered normal if the temperature does not exceed 70 degrees Celsius under high loads. The normal use temperature does not exceed 60 degrees Celsius.

  3. Anonymous users2024-02-03

    Hello, the CPU temperature is generally not more than 80, as long as it does not burn out. Normal operation is 10 degrees higher than room temperature, and full load operation is 20 degrees higher than room temperature. The temperature can be set in the BIOS.

    Set the number of degrees to automatically shut down. It is recommended to install Master Lu, and the temperature will automatically alarm when the temperature is high to avoid being too high and burning the machine. If it's too high, you can buy a small fan and add a cooling base, which can reduce it by about 10 degrees.

  4. Anonymous users2024-02-02

    This is in danger of burning down at any time. Check the heat dissipation of the CPU.

  5. Anonymous users2024-02-01

    Dear, generally after 65 degrees will be me, but the problem is that now people change computers not because of lifespan but because they are not new.

  6. Anonymous users2024-01-31

    It's Celeron D, it's very abnormal, it's close to crashing.

    Dust the machine and wash it off. CPU fans, in particular, are re-re-re-greased.

  7. Anonymous users2024-01-30

    This is a quad-core processor for early servers, graphics workstation hosts. The specific parameters are as follows:

    Core 2 architecture, 771-pin interface, 65nm process, 64-bit quad-core,Frequency, L2 cache 8MB, front-side bus 1066MHz (266MHz external frequency), up to SSE3 multi-** instruction set, support VT-X instruction set, and Q6600 such quad-core belongs to the same camp.

    About a decade ago, it was a pretty awesome CPU. Now it seems that its biggest problem is that the default clock clock is too low, although it has four cores, but the clock clock is too low, which makes it very low performance, especially for single cores. If used for games, it is obviously very inappropriate.

    Because server applications have high requirements for multi-core, stability and power consumption, and the main frequency requirements are not too high, this kind of quad-core is still suitable for servers.

    If you want to use this CPU to exert some residual heat, it is recommended to use a G31 motherboard with better workmanship and good overclocking performance, and exceed the external frequency to at least 333MHz, so that the main frequency will be increased to 2GHz, and the performance of this CPU will be significantly improved. If it can be overclocked to400MHz external frequency、Main frequency,Its performance will surpass Q6600,With 4GB or larger memory,You can run 64-bit Win7 or Win10 system smoothly,If the independent graphics card is better,Running most ordinary online games is also okay。

    The default clock speed is not good, it is too low.

    PS: When the 771 Xeon is used in 775 motherboards such as G31, it must be transformed with a conversion post, or cold soldered before it can be used, otherwise it will not light up if it is installed directly.

  8. Anonymous users2024-01-29

    Hello, the CPU you said belongs to the server CPU, the difference between the server and the PC's processor is that there is more hyper-threading and virtualization technology, the server can work for a long time, the PC's processor is not, I hope my answer can help you.

  9. Anonymous users2024-01-28

    The lift is small,. Early games may not be as good as the E5200, because the E5310 clock speed is too low, and the single-core performance is much worse than the E5200.

    Just 2 more cores.

  10. Anonymous users2024-01-27

    Intel Xeon E5310 is a server launched in 2006 and Core 2 Duo Core 2 Quad of the same era, workstation dedicated quad-core processing, after all, the main frequency is more than 10 years ago CPU, get the current era, of course, its performance is not what it used to be, Intel's server processor is generally XEON (Zhiqiang) series, and the CPU of ordinary PC is Core I, Pentium, Celeron series. The CPUs of the Xeon series generally focus on multitasking and high-traffic data processing, but the single-core processing speed is not high.

  11. Anonymous users2024-01-26

    It's quite rubbish, it's foreign garbage.

    A server processor is the CPU that is used on a server

  12. Anonymous users2024-01-25

    Hello Xeon Xeon 5600 series processors.

    No, it's all in bulk, but the CPU is real, there is no fraud, you can buy the official version!

    This can't be faked, there is no technology.

Related questions
15 answers2024-02-09

2800+Frequency modulation is not adjusted to 1900+,The key reason for the white screen is that the power supply voltage of the motherboard is unstable caused by capacitor damage,Your problem can generally be solved after the merchant has replaced the capacitor for you!!

4 answers2024-02-09

Let's talk about the configuration first, the configuration is no problem, but there is no way to put the computer room, and the PC hosting ** should be very high. >>>More

7 answers2024-02-09

With 65nm technology, lower power consumption and better performance! The dual-core core uses a shared second-level cache, which is better than that of PD, PD does not have a core and a second-level cache, and the data between the two cores needs to pass through the north-south bridge, while the core uses a shared second-level cache, and the data transmission is faster!

14 answers2024-02-09

The print server is used to professionally process the printing service, acting as the background of the printing service, and now the printers are directly spooling, so making a special print server can improve the printing efficiency, it is best to install the server operating system of Windows, such as Windows Server 2003, Windows Server 2008, the printers that need to be shared are connected to this print server, and the network printing is to use the shared printer on the print server to print, It belongs to network printing, that is, the printing content is sent to the print server, and the print server is processed to print This machine does not do any printing, because the printer is connected to the server

11 answers2024-02-09

In fact, U is a unit that represents the external dimensions of a server. >>>More