Eggs hit the earth, eggs hit the earth experiment

Find a very large number of brackets, form a group of tic-tac-toe buffers for every 4 of them, and stack them in order from high to low. The mouth in the center of the buffer is required to be aligned, and the eggs can be placed vertically to ensure that there is some small friction on the eggs every time, but not scratching the eggs. Well, let the eggs fall freely from the height in an upright position.

As long as you calculate well, you can make the egg hit the earth exactly without breaking.

..Soak the eggs in vinegar for 2-3 days. Take it out, you can basically hit the earth and play.

o(∩_o...Ha ha.

You're going to break like this.

Landlord, why is there no other condition for the egg to hit the earth?

If it doesn't have to be vertical, I can make a long tunnel for him to slide down slowly, and the angle is so small.

If it had to be vertical, it would have to be like this. Look at the picture.

Figure 1: i Figure 2:

0 i o/ i \

i // i \

i /o___i___o___

In Figure 1, each section falls like a funnel-shaped section.

In Figure 2, each section has only a semicircle, one high and one low, one left and one right.

But the distance between the sections should not be too large, and the distance should be calculated, so that it is OK to go down one level at a time!

Make yourself a relatively large shuttlecock (with its feathers upright).

At the bottom is the inverted lid of the cannon-filled soda bottle (cut 1 3 or so in the fill).

The principle of blasting ......I did it when I was in middle school.

According to the law of gravitation and the theorem of interaction forces, it can be seen as the earth hitting the egg!!

I don't know, you ask someone else!! I'll tell you when I know!

Production method: 1. Parachute type: it is to use the parachute to increase the air resistance, so that the egg and the whole device can land smoothly;

2. Outer packaging type: It is to use more shock-absorbing materials to wrap the eggs tightly. Through the cushioning effect of these materials, the purpose of protecting eggs is achieved;

3. Tumbler type: it is to make the whole device like a tumbler, and lower the center of gravity as much as possible, so that the device can maintain a stable state when it falls, and ensure that it is always there;

4. Polyhedron type: It is to make the whole device into a polyhedron, and fix the egg on the polyhedron with a strong rope, so that the whole egg is empty and empty.

Experimental principle: The egg falls downward due to the earth's geocentric force, and the egg is hitting the earth. But theoretically anything can be used as a reference, so if you think of the egg as a reference and treat it as stationary, the egg is hitting the earth.