-
1. Connect the hardware correctly: ** wire to the cat, the cat to the router WAN port, and the computer to the router LAN port.
2. Correct settings: the local connection IP of the computer is set to automatically obtain; In the route settings, select PPPoE (ADSL Virtual Dial-up) when you select Internet access.
3. Do not dial up when surfing the Internet (the router automatically dials up), and go directly to the Internet.
Isn't it telecom prohibiting routing and sharing Internet access? If that's the case, try to clone the MAC address, I've helped a few friends, and it's all done.
-
The network cable enters the modem, the cat connects to the router, the router connects to the computer, and then sets the IP on the computer to automatically obtain, enter it in the IE address bar, enter the web management interface of the router, use the wizard, enter the account and password, OK
-
Detailed steps:
1.Enter the router in the address bar. The default username and password are admin2Click on the setup wizard, except for entering the broadband username and password, don't enter anything else, keep clicking Next, and finally save and launch.
3.The IP address of each computer is set to be obtained automatically, and the DNS is also set to be obtained automatically.
Let's surf the Internet!
-
Turn on the router, connect the network cable, enter the wide waiting to dial and enter the account password.
-
The manual is there.,Just fill it out foolishly when you turn it on.。
-
Under Settings, it may not be set up.
-
Isn't it written inside the router?
-
Please give the router model, otherwise it is not easy to write the answer.
-
Open the e-Surfing Morning Travel Gateway Router Settings in the browser, turn on the wireless network function and set the password after opening. Here's how:
1.Find the default username and password on the e-Surfing gateway router, and set the IP <> the router
2.Enter your IP address in your browser and enter your password to log in.
3.Once you're in, tap on Wifi.
4.Find the WPA password settings, fill in the secret of Qingzhengxin, click on the application, and log in to the wifi through the password set
5.Or click on the verification mode, change to open and you don't need the secret stool code.
6.Click on the app to save, so that you don't need a password, and you can connect to wifi.
Me too, I tried a few times and finally succeeded, so I'll tell you about it below! >>>More
Put the ** line that comes in. Attached to the cat. Get another network cable. One end to the cat. One end is connected to the WAN port of the router. >>>More
I don't know what you mean by the network cable is the landlord's? It's really hard for you. >>>More
Prepare two network cables (the first one you have ready, which is the one that goes through the "modem"). >>>More
Well, refer to the upstairs. Speed limiting software is a good idea. >>>More