How to drive a manual transmission car to save fuel? How to drive a manual transmission car to save

How to drive most fuel-efficient.

First, the new car run-in.

The new car must be run in within the first 3,000 kilometers. The run-in of the new car should pay attention to the speed control within 80 kilometers per hour; Minimize sudden acceleration and deceleration.

2. Reasonable maintenance of the car - regular maintenance.

It is important to know that a car in good condition can save 15 to 20 meters of fuel.

1. Air filter, gasoline filter, oil filter: every 5,000 kilometers or more of the accessories need to be replaced, because the air filter blockage will cause a decrease in gas volume, resulting in insufficient gasoline combustion, reducing fuel efficiency, and the blockage of the gasoline filter will also make the engine work abnormally.

2. Engine oil: Add an appropriate amount of engine oil, and pay attention to the scale marked on the oil scale. Too much oil will submerge the crankshaft and increase resistance; Too little oil will not lubricate and seal the engine, and may even affect engine efficiency.

3. Tire condition: low tire pressure will cause fuel consumption to increase. According to the U.S. Department of Energy, if the tire pressure per vehicle is 1 pound square inch less than the standard air pressure, the United States will consume 15 million liters of gasoline more per day; Check the wear of the tires regularly to see if they are evenly worn.

If you find that the tires are eccentric, or the steering wheel is not centered, you need to go to a professional repair shop for repair as soon as possible.

4. Do not decorate excessively, such as spoilers, rain covers, etc., which will destroy the abundance of the original car design and improve fuel consumption; Don't put a lot of things that are not commonly used in the trunk, increasing unnecessary loads will also increase fuel consumption, statistics show that every 1 kg of load will increase fuel consumption; When the speed is higher than 85 km/h, the wind resistance consumption after opening the window is more than the fuel consumption of the air conditioning system, which will reduce your fuel economy index by 10.

3. Develop good driving habits.

1. Choose a reasonable driving state according to different road conditions: reduce emergency acceleration and deceleration and emergency turning. When driving, it is necessary not only to look at the previous car, but also to see the situation of the first two or three cars at the same time, so as to take measures in advance to reduce sudden braking; Don't add oil violently, once you add it violently and slowly to the same speed, the difference in fuel consumption can reach 12 ml; Drive at a constant speed and, where possible, maintain the most economical conditions:

The engine speed is 2000 to 3000 rpm and the speed is 60 to 90 km/h.

2. Shift timing: choose the best time to shift gears (engine speed is between 2000 and 3000 rpm); Put an end to low-gear high-speed, low-gear high-speed driving often makes fuel consumption exceed the normal value of 45; Hand row car users should avoid starting in high gear.

3. Reduce idling: It is a good habit to warm up the car moderately, it is recommended to let the car drive slowly for a distance to complete, and the long-term in-situ hot car will increase fuel consumption; Running an air conditioner at prolonged idle and idle conditions consumes fuel in particular.

How to drive fuel-efficient with manual transmission of the car.

1.Smooth start and stop:

During driving, it is strictly forbidden to brake sharply and refuel violently. These are basically symptoms of considerable fuel consumption during driving. Keeping the car as stable as possible during driving not only provides great comfort, but also maximizes fuel savings, while also reducing wear and tear on the car, especially during driving.

Frequent operation will accelerate the wear of the brakes and shorten the service life of the brake pads.

2.Reasonable hot car:

In the usual driving process, a reasonable hot car can also save fuel, especially in winter, the car is parked overnight, and the engine temperature is relatively low, so it is necessary to make a reasonable hot car in the morning. During the process of heating up, the temperature of the car's engine rises to adapt to the surrounding temperature, and a hot car does not mean idling. If it idles for a long time, it will cause carbon deposits in the car, and it will dry up on the road within a minute after the car starts, and the car will remain in place during driving.

3.Driving at the speed of the locust economy:

Basically, there will be an economic speed for each gear. According to the road conditions at the time, make reasonable gear adjustments. Most of the economic speed of the first gear is around 10, the second gear is around 25, the third gear is 50, the fourth gear is 70, and the fifth gear is 100.

Adjusting the speed within the economic rpm will reduce the fuel consumption of the engine. If it is higher or lower than the economic speed, it will basically have something to do with the fuel consumption of the car. Therefore, the speed of the car should be reasonable while driving.

4.Prevent the car engine from running dry:

A lot of drivers like to idle when waiting for someone, so that the engine of the car is idling, there are relevant experiments have shown that the fuel consumption of the manual transmission engine idling for 3 minutes can make the car drive a kilometer, so if you stop for more than a minute, you can choose to turn off the engine to prevent unnecessary fuel consumption.

Millions of car purchase subsidies.

1. Don't stop and go and abuse the brakes, try to avoid traffic jams on the way before driving, because in this case, the manual transmission car consumes twice as much fuel as normal driving, and the braking should be minimized during driving, and the engine and low gear are used to pull the production, which is more fuel-efficient.

2. Starting skills, different from automatic transmission cars, when starting with manual transmission, remember to step on the clutch to the end, hang a gear, put the right foot on the accelerator in the void, slowly lift the clutch while releasing the handbrake and lightly step on the accelerator, step on the clutch of the left foot slowly lift a little and immediately step on the accelerator, the vehicle starts smoothly to save fuel.

3. Try to keep the appropriate gear as much as possible, each car has its own characteristics, the speed of the high-speed engine needs to be higher when driving at a constant speed, such as 2000 rpm, and the low-speed engine speed may be lower, such as 1500 rpm, what we need to do is to increase and reduce the gear according to the current speed needs, so that the engine works at the most comfortable speed, of course, this time is also the most fuel-efficient time for the engine.

4. Maintain the best speed, the most fuel-efficient driving state is to drive in a straight line at a constant speed, the most fuel-efficient speed of small displacement vehicles is 60 80 kilometers per hour, and medium displacement vehicles are 80-100 kilometers per hour.

5. Neutral coasting believes that there are many old drivers who do this, it can achieve the effect of fuel saving, since there are benefits, of course, there are disadvantages, that is, it brings carbon deposits to the engine, which is not good for the heart of the car.

Manual transmission cars are the most fuel-efficient according to the following methods:

1. Drive a manual transmission car to slide, neutral coasting, the engine is always at idle speed, and with gear coasting, only a very short coasting and then immediately will supply normal fuel, it can be seen that neutral coasting is more fuel-efficient;

2. But if you want to achieve real fuel saving, relying on neutral coasting or gear coasting is not the best fuel-saving method, it is not recommended to use these two methods, it is recommended to do this: in the process of driving, it is necessary to predict in advance, control the speed with gear, and do not step on the brakes as much as possible, even in the process of coasting in neutral gear;

3. If you need to slow down, it is also recommended to use the engine braking method to slow down, so that the operation is more fuel-efficient than directly stepping on the brake to slow down.

Whether the vehicle can save fuel has a lot to do with the driver's driving skills. Especially for manual cars, mastering the skillful and correct way of shifting gears can make the old Shanna gearbox play the best working condition when the vehicle is driving, which is not only fuel-efficient, but also will not hurt the car.

1. Don't stare at the gear lever to change gears.

Many novice drivers are not familiar with the operation of the gear, and often need to stare at the gear lever to hang the gear when changing gears. This method is not only very dangerous, but also requires a deliberate deceleration before shifting, so as to repeatedly brake, shift, and refuel, which not only hurts the car and increases fuel consumption, but also is very dangerous. It is recommended that the driver be familiar with the gears so that he can change gears without staring.

2. Don't change gears if the speed is not enough.

Some drivers want to speed up quickly when driving, so they will force upshifts when the speed and speed are not enough, although this practice can increase the speed a little, but it is very easy to aggravate the wear and tear of the transmission. It is recommended that the driver should not be too anxious to upshift, first speed up in advance, and wait until the speed and engine speed have been increased before upshifting, which can not only make the gearbox work more smoothly, but also reduce fuel consumption.

3. Slide with gear.

Many old drivers think that the vehicle is very fuel-efficient when coasting in neutral, but in fact, the engine is still in idle mode during neutral coasting, and fuel is needed to maintain, so the fuel-saving effect is not obvious. When an accident occurs in front of you, it is difficult for the vehicle to quickly change its coasting state and brake to a stop, which is quite dangerous.

Therefore, it is recommended that the driver can choose to coast with gear, at this time the engine will stop injecting fuel, but the vehicle continues to ignite, and the instant fuel consumption is "0", and the fuel saving effect is very obvious. Because the ignition of the vehicle continues, even if there is an emergency ahead, the engine can be braked, and this kind of coasting is safer.