How to run in the new car of Nissan Teana with automatic transmission

Hello, the vehicle is mainly limited speed and load during the run-in period, the speed should not exceed 80 miles, the engine speed should not exceed 3000 rpm, and avoid sudden braking, emergency throttle, so that you can effectively do a good job of running-in.

Hello, try not to run high speed in the run-in period, if you run high speed try to control the speed below 100 yards, the engine speed is controlled below 3000 rpm, do not overload, do not accelerate sharply, so that the engine and gearbox run-in is better.

Hello, during this run-in period, be careful not to drive savagely. The engine speed should not exceed 3000 as much as possible. The speed is not more than 100.

The main thing is to focus on gentle driving, try to drive the engine at a speed of no more than 3000, no more than 100 yards per hour, and be sure to drive gently, which is very important. Another thing is to never drive violently.

During the run-in period of the new car, the speed of the engine should not exceed 3000 rpm, the speed should not exceed 100 miles per hour, and the speed should not accelerate or decelerate sharply in the middle of driving, and do not overload. Practice good driving habits.

The run-in period of the car is generally about 3,000 kilometers, in fact, it is okay to drive normally during the run-in period, do not drive violently.

The speed is controlled below 100, the speed does not exceed 3000, and do not accelerate and brake sharply.

During the run-in period of the new car, the engine speed should not exceed 3,000, the speed of the vehicle should not exceed 100 yards, and the driving force should not be violent.

During the run-in period, try to maintain a constant speed, control the speed, preferably not more than 100 yards, do not exceed 3000 rpm, and drive gently.

Hello, it is recommended that the speed of the new car during the run-in period is less than 3000, and the speed is better within 100.

Hello, it is recommended not to drive violently during the run-in period of the new car, do not step on the accelerator and brake, and try to keep the engine speed within 3000 rpm.

Hello, automatic transmission, do not exceed 100 yards per hour during the run-in period, do not brake urgently, and step on the accelerator sharply.

Hello, pay attention to the speed of the new car during the run-in period should not exceed 100, do not brake suddenly, and do not step on the accelerator suddenly.

Hello, the speed of this car should not exceed 100 during the run-in period, the speed of the car should not exceed 3000, and there should be no sudden braking and pressing on the accelerator.

During the run-in period, avoid rapid acceleration and sudden braking, try not to exceed 3,000 rpm, and the speed should not exceed 100 yards per hour.

Hello, during the run-in period of the new car, you need to pay attention to control the speed of the vehicle not to exceed 100 miles, and the speed to not exceed 3,000 rpm.

Just drive normally, don't drive violently. Just keep the speed at 3000 rpm. Do not exceed 120 speed

Hello, if the car is running-in, it is best not to exceed 100 per hour, and then try not to exceed 2000 rpm

Generally, the run-in period of 3000 km. Is it recommended that the speed should not exceed 100 during the run-in period? Don't exceed 3000 rpm.

Generally speaking, it is recommended that the speed of the run-in period should not exceed 3000 rpm and the speed should not exceed 100 yards.

The vehicle is in the run-in period, it is recommended that the usual driving speed should not exceed 100km, and the engine speed should be kept within 3000 rpm.

Hello, during the run-in period of the vehicle, pay attention to the speed of the vehicle should not exceed 100, and the speed should not exceed 3000 rpm.

Generally speaking, new cars drive smoothly during the run-in period, with a speed of no more than 3,000 rpm and a speed of no more than 100 yards per hour.

For the vehicle, if it is said that it is in the run-in period, it is recommended to maintain a good driving habit, and the vehicle speed should not exceed 100!

Hello, this is not the first warranty of the new car, the engine speed should not exceed 3000 rpm, and the speed should not exceed 100 kilometers per hour.

In the case of a new Nissan Teana automatic transmission, the speed should not exceed 100, and the speed should be within 3000 rpm.

Generally speaking, the speed of the engine during the run-in period is controlled at about 2700, and the speed is controlled at about 100, which is more reasonable.

Normally, as long as the speed does not exceed 100 miles, do not exceed 3000 revolutions, it is good for your reference.

Nissan Teana run-in period speed: 1. During the run-in period, do not use manual mode, cruise at a fixed speed, so as not to brake sharply, speed up quickly, and do not hang the trailer.

100km, which is the most critical initial run-in. Only run in urban areas, the speed of the car should not exceed 60km h, brake in advance to control the speed, do not carry the load. For the medium-term run-in period, do not exceed 100km h, and it is best not to run long distances, high speed, and less load.

1600km late run-in, the maximum speed can be appropriately increased, as long as it is not illegal. Increasing the speed appropriately not only has an impact on the engine, but also has a promoting effect on the running-in, and you can see if there is any abnormality in the process of speeding up. Because running-in is a step-by-step process, it must be gradual.

Do not exceed 3000 rpm. Precautions for the run-in period of the new Ethereal: The basic precautions are as follows:

Change the speed of the vehicle, do not drive at a constant speed for a long time; 4。Don't pack too much. The maximum load is about 480kg, and the running-in period must be controlled below 400kg.

Nissan's run-in speed: 1. Do not use manual mode and cruise control during run-in to avoid sudden braking, rapid acceleration and trailer.

100 km, which is the most critical initial run-in, only run in the city, do not exceed 60 km/h, and brake in advance to control the no-load speed. The public crack is a mid-term run-in and should not exceed 100 km/h. It is better not to run long distances at high speed and low load -1600 km after the run-in, the maximum speed can be increased appropriately, as long as it is not illegal.

Proper acceleration will not affect the engine, but will promote the run-in from the source, and you can see if there is any abnormality in the speed. Because running-in is a gradual process, it must be gradually increased.

Do not exceed 3000 rpm.

Precautions for the run-in phase of the new day:

The basic precautions are as follows:

Change to different speeds, do not drive at a constant speed for a long time; 4.Don't load too much. The maximum load is about 480kg, and the run-in period must be controlled below 400kg.

5.Use high-quality fuel.

The choice of fuel has a certain impact on the car, high-quality fuel is full of power, and low-quality fuel causes certain damage to the car.

6. Start cold start and preheat first.

When the car just starts, the engine temperature is low and the lubricating oil is not in place, which is easy to cause dry grinding of parts. The warm-up time should not be too long, and the car can be started when the operating temperature is reached.

7.The gear should be appropriate.

Anyone who has ever learned a manual transmission should know that they should be wary of a mismatch between gear and speed. Each gear has a suggested speed range to match, and the owner can follow the instructions to suggest driving.

Millions of car purchase subsidies.

Hello! Dear, here is the answer to your question: The specific initialization steps are as follows.

1) Press and hold on the close up side for about 10s, the sunroof will move in the direction of the upward slope, and then stop, and then automatically close completely; Then the sunroof will be operated in the order of tilting up, tilting down, sliding to open and sliding to close (you need to hold down the sunroof control switch all the time during the operation of the world). (2) After the sunroof stops working for 5s, release the sunroof control switch, if the sunroof control switch can control the work of the sunroof normally, the initialization is completed, otherwise repeat the above steps.

The Nissan Teana's manual shift mode can be added or subtracted by the paddle shifters on the head-direction disc after being in D gear. The Teana is a mid-to-high-end luxury sedan owned by Nissan. With the latest technology, the company has perfectly matched driving technology and comforttechnology to bring the design concept of a mid-size sedan to a new level.

The VQ350DE has a maximum power of 180 kW at 6000rpm and a maximum torque of 318N·m at 3600rpm. In the yardage of its rivals, the literal Audi A6 has a maximum power of 125 6000kW and a maximum torque of 230Nm. The maximum power of the Accord is 177 kW 6250, and the maximum torque is 288 5000 N·m.

In terms of vehicle power, the Teana accelerates from a standstill to 100 km/h in seconds. Audi seconds, Accord also takes about 9 to 10 seconds.

1. Open the door and pick up the core, install the smart key, the key of the sky is similar to the business card, press the black button on the door handle to open the thick door.

2. Starting, as long as the key is in the car, the place where the key is inserted in the ordinary car under the steering wheel, press and turn to start.

3. Hang the gear, press the brake with the right foot (if you don't step on it, you can't hang the gear), hang the gear from P to D, and look at the dial on which the D word will be displayed.

4. Start, there is a production under the left corner, step on it and then release it (equivalent to the handbrake), step on it again when parking, and then slowly release the brake car with the right foot.

6. Stop, step on the brake with the right foot, wait for the car to stop, hang the gear from D to P, step on the brake with the left foot and release it, and then release the right foot to make the plate, and then return the ignition there.

7. Lock the car, people come out, press the black button on the door handle and the car is locked.

Fairy about your question, manual transmission and automatic transmission vehicles need to be run-in, new cars need to pay attention to the following points during the run-in period: 1The engine speed should not be too high, preferably not more than 3000 rpm.

2.There should be a process of warming up the limbs during the cold start, and driving on the road after the water temperature changes, generally about 5 minutes. Demolition shed 3

The load must be reduced according to the load regulations of the model, and it is advisable not to exceed 70% of the specified load capacity. 4.The impact damage of the sudden braking on the engine, braking system and punching chassis of the new car is great, and the situation should be dealt with in advance during driving, and the deceleration and gear reduction should be carried out.

5. Avoid sudden refueling and braking, and try to maintain a constant speed. The maximum speed of the vehicle within the run-in period should not exceed 90 kilometers per hour, but it is not possible to drive at low speed for a long time. There is no difference between a manual transmission vehicle and an automatic transmission vehicle.

Hello, to put it simply, it is to press the brake to pull the gear down and hook it in"d" gear, then push the gear lever to the left, that is, enter the manual mode, on this basis, push the gear lever + forward to go up 1 gear, and pull back - to drop 1 gear. The manual automatic integration is only on the basis of the automatic transmission to increase the function of artificial shifting, its essence is still automatic transmission, the specific operation steps are as follows:

First, press the brakes and pull the gear down to hook in"d" gear, and then push the gear lever to the left, at this time it is hung into the manual mode, when it is necessary to increase or decrease the gear, on this basis, push the gear lever + forward for 1 gear up, and pull back - for 1 gear down.

Note that when the speed and engine speed are not as required, the gear cannot be raised, and each step of the driver's operation must be allowed by the transmission control unit. In manual mode, when the speed is low, the transmission will actively downshift but will not actively upshift.

Dial back to the right to resume the automatic mode, manual and automatic can be switched at any time, no brake is required, and the throttle can not be loosened.

It's easy, the position where you push the gear lever to D is the forward gear, if it is pushed to there.

Ten and one is the manual mode, ten is the increase in gear, and the other is the reduction in gear.

It's easy to hang the D gear "Forward gear" first, and then hang the gear to the left, without stepping on the brakes, and adjust the gear or downshift by yourself with the increase in speed.