How do you find the bottom when fishing? Do you want to find the bottom of the lead bag with more he

Fishing is a healthy recreational outdoor activity, which not only gives everyone the opportunity to get close to nature, but also exercises patience and willpower.

A good way. Fishing skills directly affect the harvest and experience, drifting is one of the very important details, drifting methods are varied, varied, such as empty hook drifting, no hook drifting, hanging double bait drifting, four fishing two, etc., each has its own advantages and disadvantages and adapt to the fish water conditions, so how to adjust the drift in fishing?

In fact, many novices think that it is too difficult to adjust the drift, I remember that I only started to learn fishing before, holding my mobile phone to watch the strategy tutorial**, going to the water's edge to see how others adjust the drifting, and it took a week to find a little way!

I've seen a lot of novices, just at first I didn't know how to adjust the drift, a large piece of lead directly put into the water, fishing for 2-3 hours did not catch, and finally came to me and asked, brother, how can you catch it, I can't do that?

So how do novices adjust drifting quickly, easily and efficiently?

To summarize the following steps:

1. Measure the depth of the water and find the ground roughly.

Measure the depth of the water, first find a heavy lead skin wrapped in the lead seat, throw the rod into the water, to see if the fish float leaks, such as leakage, then pull down the float, if the leakage can not get out of the drift tip, then pull up the float, until the tip of the drift and the water surface is level, at this time the distance between the lead skin and the tip of the drift is the depth of the water at our fishing point.

2. Semi-water drifting.

The depth of the water we found, then we should adjust the float to the required tune, that is, the so-called tune of the four fishing two, first of all, we pull down the float, so that the double hook off the ground, how much this float pulls, according to my previous fishing experience, the distance of the float is your line + 5-10 cm, the closer to the bottom, the more accurate the float adjustment, and then ** float must sink in the water, at this time we use small scissors, of course, if you take the big scissors at home, I have no opinion, a little bit to modify the lead, Each time you modify it, throw the rod into the water to observe the float until the float leaks out of 4 meshes. The buoy shows your envisioned tune such as 4 mesh without touching the bottom of the hook, and your half-water adjustment is completed, and then reverse the verification, press the water line with a rod to let the buoy submerge into the water, and then you see if the buoy floats up from the water to stay on the tune you set, if not, continue to adjust.

1. Without a hook to find the bottom, you can first hang a heavier lead at the bottom of the fishing line, first make the float a little shallower, if the buoy completely sinks into the water (description: the lead skin is greater than the buoy buoyancy), 2, at this time you adjust the float upwards until the buoy is exposed a little bit on the water surface, at this time, the bottom of the water depth of the fishing point is found, (in order to confirm the topography of the river bottom, you can put a few more places to see if the buoy is basically the same as the surface of the water, there may be a slope, there may be grass, It is possible that flatness, etc., can be reacted by floating)

3. Now hang the subline (hook) and lower the float to two-thirds or one-half of the length of the subline (depending on the situation, it depends on how many meshes you are fishing and the length of the strand).

4. Then start to trim the lead skin, slowly trimming little by little, until your float is exposed to the water, at this time the state of your lead skin is suspended, and the hook is lying on the bottom.

5. Then you can continue to trim the lead skin until 5 mesh is exposed, at which point your hook is suspended (this can be judged by lowering the buoy in step 3 just now).

6. Finally, you hang the bait, bait to the end, your buoy 3 mesh (this is related to the 3rd step just now).

Selection of fishing rods: Generally, according to the fishing species and water area, choose a fishing rod suitable for the fishing method, which is generally divided into long-throw rods (sea rods), rock rods, front rods and other rods with wheels, as well as platform fishing rods (hand rods).

Hook selection: 1. Choose according to the size of the fish's mouth.

2. Choose according to the type of fish.

3. Choose according to the different seasons.

The choice of floating: Generally, the floating materials on the market are roughly divided into, nano, reed, feather, and balr fir wood.

The collocation of the line group: The collocation of the line group mainly depends on the fish species to be caught, and the large fish line is required to be thick. The small line group is relatively thin. Generally, summer and autumn fish have high activity and struggle strength, and use slightly larger, and winter and spring fish struggle less can be slightly finer.

Fourth, the choice of wild fishing bait.

Bait formula: basic bait ten main bait (fishy + fragrant) ten state bait ten additives = fishing bait.

The principle of bait matching: pay attention to the combination of granular bait and powder bait, first establish the concept of fish-oriented, luring fish, fishing, and keeping fish are the three basic elements of the way to use bait. Pink bait attracts fish, and pellet bait retains fish, so it is the most basic matching principle in fishing practice.

Pay attention to the collocation of flavor type: freshwater fish like the flavor type in general, fishy, fragrant, sweet, sour, smelly, according to the season and the preference of the target fish, is the main factor to consider the flavor type matching, in general, the main fishy smell in winter and spring, the main fragrance in autumn, and the main light taste in summer.

Fifth, wild fishing nesting skills.

Flavor type of nest material: When the temperature is high, due to the greater activity of the fish and the wide range of foraging, we can choose the smell, color, and slightly lighter nest material. At low temperatures, the opposite is true.

Nesting time: When the temperature is high, fish generally gather in about half an hour to an hour. And when the temperature is low, it usually takes more than an hour, or even a few hours, for fish to enter the nest.

Therefore, when the temperature is low, it is a good choice to choose to nest in advance.

Timely renewal: Because the nest is full of fish, the fish are constantly eating the nest material, and the nest material will inevitably decrease. Therefore, if we want to "connect the rod", we must renew the nest in time.

Today I will share with you a fishing tutorial, in the process of fishing, use heavy lead to find some small misunderstandings! I hope it can help fishing friends, if you have any suggestions for this **, welcome to leave me a message. Together, we ** fishing tips and fishing experience.

Wild fishing heavy lead fishing bottom line, but generally used in the bottom fishing or winter is more used, spring can be used hollow lead directly to the bottom, summer and autumn is best to use thinner lead.

When fishing in the wild, if you fish the grass nest to pay attention to walking, keep the combination, the action of the fish in the place where the aquatic grass is dense is also very inconvenient, to the fishing position to select a main nest after the bait, and then fish for a while and then walk elsewhere to fish.

When wild fishing, it is best to choose the dissolved oxygen at the downwind and downwind.

Plankton in high, water bodies.

There are many small flying insects, the abnormal sound of wind and waves and the unstable water surface can interfere with the sight and hearing of the fish, and the fish is in a more relaxed state when foraging, and it will be easier to lure the fish.

However, in winter, when fishing in the wild, there is a lot of dissolved oxygen in the water body, and the fish does not have high requirements for dissolved oxygen in the water body, and the temperature of the downwind outlet is low, which is not suitable for fishing downwind.

The combination of bait is also very important when fishing in the wild, and fishing for crucian carp in late autumn requires the use of thick bait rich in animal protein, such as earthworms.

In summer, when the water temperature is high, the appetite of the fish is affected, so it is necessary to use fragrant grain bait, such as corn and wheat.

You roughly made 2 mistakes, if you start with a hook to adjust the drift, you hang heavy lead is a problem, there is a sauce layer at the bottom of the river, your heavy lead must be trapped in the sauce layer, your bottom has been found! There is also to join your previous operation is all right, do not pursue other mistakes, according to your own words a bait is basically in 4 mesh, so your 2 baits can roughly let the drift down 2 mesh, you can catch up to 3 mesh, it is impossible to have 2 meshes out, unless you increase the proportion of bait, you can appear 2 meshes you said.

Do not use heavy lead for bleaching, bai will sink into the bottom of the pool. Nor do you use an eraser.

Simple DAO method: empty hook, confirm that the hook is in a state that is not in the bottom of the water, start to cut the lead skin to adjust the drift, adjust to 5 mesh, fishing carp with a long tail 15 mesh drift can be adjusted to 8 mesh, pay attention to the main line to overwhelm the water when adjusting the drift. After that, directly double hook the bait to find the bottom, catch half of the purpose you just adjusted, and adjust it according to the fish condition.

To be clear: the empty hook, the hook is not to the end, this is your tune.

The bait hook is your catch.

I think you've made a low-level mistake After finding the bottom of the heavy lead, you have to pull out the buoy first to a length of 5 cm longer than your strand At the beginning of the cut lead skin repeatedly thrown to the fishing spot, many times only until the buoy is exposed to the fishing mesh you set, such as adjusting 4 mesh, and then start to hang the bait to find the bottom until the buoy is exposed 2 mesh.

1: Cut the lead skin half in water until the surface of the water is exposed.

2: The bottom hook is hung with lead to find the bottom (the lead skin should not be too large, but at least the remaining four eyes on the water surface can be completely pulled into the water).

3: Slowly move the float upwards until the bottom hook is exposed to the water with lead hanging on the bottom.

4: Take off the bottom hook and hang the bait for fishing.

When this method is drifting, it should be noted that the lead skin of the bottom hook must not be too heavy, and it is easy to fall into the mud if the bottom mud is deep, so the drift will not work.

The fishing method of fishing heavy lead is half-water drifting, the distance to the hook is less than the depth of the water, such as two or three meters of water depth, pull the drift to a position more than one meter away from the hook to start adjusting, and achieve the desired number of meshes by trimming the lead skin.

Lead skin is an auxiliary prop in the accessories of the fishing rough ant state, and it is an important material used to make a lead rock sinker to balance the fish float, which is very small. Generally large and small fishing tackle shops have **.

You can catch bigger fish, but if you want to improve, you must pay attention to the surrounding environment, and you must pay attention to the choice of fishing line, and make a reasonable match.

Heavy lead fishing bottom, although the whole fishing group is relatively dull, but fishing wild fish, especially big wild fish, has many advantages that the fishing spirit does not have: do not bother to bring Jane to find the bottom, drifting. The way to fish for heavy lead bottoms is to use heavy lead sinkers.

After entering the water, the lead falls on the bottom, so there is no need to look for the bottom and adjust the drift. As long as the rod is floated up and down, you can see the movement of the float after a few glances on the surface of the water. The specific number of fishing glances depends on the mood of the fisherman, and the fishing eye can be used, and the fishing eye can also be fished.

It can resist the movement of water. The lead sinks very heavily into the water, so much so that when the celery water we are fishing for is flowing or windy, it can hold the fishing group in place and it will not be carried away by the current.

In the process of wild fishing, most of the fish will feed on the bottom. Therefore, choosing a heavy lead fishing bottom dough can better sneer and bite the hook. But you should choose the right hook.

Fly lead fishing usually lead sinker and figure eight ring two parts are close together, but the fly lead fishing rule is to separate them, the lead skin to the direction of the float greatly moved, and then lock it, so that the lead sinker still will not move, but away from the figure eight ring, it is equivalent to greatly increasing the distance of the line line, the advantage is to make the line swing distance under the water increase, and thus enhance the function of attracting fish. At the same time, the plumb sinker is closer to the float, which will also greatly increase the standing speed of the float. The fly lead fishing method is more suitable for fishing for pelagic cut-off fish.

No, flying lead is fishing skin, in the case of the rules and their own operating habits, the float is fixed to a certain position, and the lead skin can be pulled next to the float.