The router DSL light is always flashing, and the network is temporarily disconnected

The DSL or Link light on the broadband cat indicates the communication status between your broadband cat and the operator's equipment room, it should be on forever at normal times, if it is not bright or shining, the biggest possibility is that there is a problem with your **line, directly call the operator's customer service** to report the obstacle and let people come to check and repair: Telecom 10000 Netcom 10060

Actually, it's your RP question, the standard answer. Hey.

The broadband modem DSL light is not lit or flashing, indicating that the modem is not synchronized, it is recommended that you first check whether its fixed ** can be used normally, and then check whether the **line is correctly connected with the divider and the modem, you can also remove the splitter** outdoor line directly connected to the splitter, and finally check whether other devices are connected between the **line home bus and the divider, (such as: **extension, etc.). If it still can't be used after the above checks, you can call customer service** to report the fault.

Hello, the DSL light of the broadband cat does not light up or keeps flashing, indicating that the ADSL line is connecting or has not been connected, this is a line problem, the most common situation is that the separator incoming line is connected to the wrong port.

You can check the separator, change the wiring port, and then check whether the ** wire connector in the room is not in good contact; Or cancel the splitter, directly connect the home line to the modem, and then restart the modem.

This is obviously a cat or line problem, and your service provider is responsible for handling it. But now they can't help you, so what do you say? If you find a way for them to take the initiative to deal with it for you, or you can get that person, and he will be willing to deal with it for you.

Isn't the situation bad for you? The line is too long, the line index is not good, and this is a service provider, people are not afraid of you.

I'm dizzy, you're **, Netcom is very cheap here, only a few hundred yuan, but most of them are still telecommunications, telecommunications' signals are much better than Netcom, I think, it's not whether you want to reverse or continue to use, but to solve this problem, I think if telecom can get to you, you can consider telecommunications, but telecom is more expensive!! 1600 is now in my county, and Telecom doesn't need 1600 a year, hehe! As for how to do it, I can't suggest it, I feel that it is more practical to return the money first!!

Then switch networks!

A flashing DSL light indicates that the device is not receiving an ADSL signal.

1. Check whether the lead-in line is damaged.

2. Check whether the wire of the separator is connected correctly.

3. Check whether the fixed ** can be dialed, if it can't be dialed, the line must be broken.

4. Replace the adslmodem test, if the fault is still there, then it means that the line is faulty, and you need to contact customer service personnel for maintenance.

There are several possibilities:

1. The position where the modem is placed has poor heat dissipation, resulting in frequent disconnection.

2. If the broadband port of the telecommunications bureau is problematic, the port needs to be replaced.

3. It is possible that the quality of the modem is not good, the power supply is unstable, the separator is not connected, the line quality is not good, etc., check them one by one.

Judging from your phenomenon, the item is more likely.

1. Check whether the line connection is normal.

Pay attention to whether the thread is damaged and whether the contact of the crystal head is normal.

2. Check whether the separator is connected correctly, and don't connect the adsl wire in the opposite direction.

3. Replace the ADSL modem test to see if the DSL light stays on after connection.

If the fault persists, then there may be a problem with the operator's line. You need to contact customer service to report for repair.

If there is a problem, press the reset button of the main router, restore the factory settings, and reset the router to try to use it

It's a bad thing that the cat doesn't flash, and you may have bad contact or an ARP virus network outage attack.

Are you already at home, in your dorm, or on a network shared by several people? If someone else uses it, then the probability of ARP is higher.