What is the plan for the re cuttings of desert rose seedlings?

Let me introduce you to how to propagate the seedlings of desert roses by cuttings, which are seedlings of desert roses cultivated by sowing, which can cut off a small section at the bottom of the rhizome, about three or four centimeters.

To cut with a sharp blade, prepare a dry paper towel, cut the bottom of the desert rose branch completely flat, and then cut it diagonally along the edge of the incision, so as to ensure faster healing of the wound, the bottom of the incision can be stained on the paper towel to allow the wound to dry faster.

Next, we need to prepare some rooting powder, which is to sterilize and disinfect to promote rooting. The bottom incision of the desert rose branch is evenly smeared with rooting powder, prepare some peat soil and coconut peat, mix and stir well, and water appropriately.

After watering, stir evenly, and then pinch the water dry. In this way we get a slight damp peat soil. The peat soil should be kept slightly moist, but not too wet.

Mix these peat soil and perlite in a shallow basin, the ratio of peat soil to perlite is about 1:1, you can add appropriate slow-acting granular fertilizer to the soil, not too much fertilizer, so that we can get some soil suitable for cuttings.

Prepare a small pot with a drainage hole at the bottom, spread about 1 2 or so of these potting soils first, and then put a small foam board on it. Then cut off all the leaves at the bottom of the branches of the desert roses that need to be cuttings, leaving about 2 or 4 young leaves at the top, and half of the larger top young leaves.

Next, you can place the desert rose branches covered with rooting powder on the foam board. Then spread some potting soil, which is very loose and breathable, slightly compacted soil. You can keep it in a ventilated and well-lit place.

Don't rush to water first, after three to five days, you can slowly replenish a little water. Wait for the soil to dry a little and then water it a little more, because it was potted on damp soil before. You can slightly remove the potting soil at the edges, and if the soil is dry three centimeters below the surface, water it again, and if the soil is still wet under the surface, don't rush to water it.

When watering, be careful along the edges of the pot and do not overwater it. A little spray of water will do the trick to keep it alive, after about two weeks. The bottom of the desert rose branch can basically take root slowly.

After two or three weeks of checking the condition of the soil, it is found that two or three centimeters below the surface of the soil are dry, and then water it a little more.

At this time, you should slowly see the light, don't keep it in an excessively dark place, and replenish a little water.

There are a few points to pay attention to when cultivating desert roses from branch cuttings and growing them into bonsai after changing pots.

Answer; Cut off half of it flat with a blade. Sprinkle some rooting powder on the soil. Stir well after watering. Prepare a small basin. Don't overwater and spray every day.

1. Ensure that the seedlings can grow vigorously within one year.

2. The garden will be expanded, and it is expected that a rose field will be formed within three years.

3. Promote the rose industry to the world.

The time of desert rose cuttings can be selected between May and June, the northern cuttings are postponed for a month, and the branches that grow for 2 years are selected when cuttings, with a length of about 9 cm, and the cuttings are soaked in water for a while into the loose and breathable soil, sprayed with water to maintain a moist environment, and moved into the astigmatism environment for maintenance.

1. Cutting time

Desert rose is a high-temperature resistant plant, so how to grow vigorously in desert rose cuttings, the best time to choose in spring and summer 5 and 6 months, in a high temperature environment is conducive to desert rose branches rooting, in the north cuttings can be postponed for a month, and so on 6 July cuttings is the most suitable.

2. Cut the branches

Desert rose branch cuttings need to choose branches that have grown for more than 2 years, the length of the branches can be retained at about 9 cm, and then the bottom position is soaked in clean water, and it is fished out for half an hour, placed in a cool place to dry, and then cuttings can be carried out.

3. Soil preparation

Desert rose cuttings need to choose loose and high air permeability of the soil, can add an appropriate amount of vermiculite to the humus, or directly choose sandy soil, the soil is fertile and can also increase the drainage effect, and promote the effect of rapid rooting of branches.

4. Insert the soil

The treated branches are cut into the prepared soil, sprayed with water to keep the soil moist, and it will only be placed in a sufficient astigmatism environment, during which attention should be paid to good ventilation and timely hydration, and the branches can take root in about half a month.

There are two best times to cut desert roses, one is in May and June, which is at the beginning of summer, and the other is in August and September, when it is in early autumn. In terms of temperature, that is, when the temperature is between 20 and 35 degrees, it is most suitable for cuttings of desert roses, with high survival rate and fast rooting.

1. Propagation by cuttingsSo if you want to take cuttings, you can, to choose the right time, his only requirement is that the temperature can not be lower than 15 degrees to ensure normal growth, it likes high temperatures, so it is recommended that the temperature is around 25 degrees is the best, even if it is 30 degrees, it doesn't matter, as long as the high temperature ventilation is good, you can take cuttings.

2. Seed propagation.

The most reliable breeding method of desert rose is seed propagation, first of all, we know that there are many varieties of it, most of which single-petal varieties can be self-pollinated, even if the double-petaled varieties can not self-pollinate, we can also obtain seeds through cross-pollination, and he can produce dozens or hundreds of seeds in a flower, so the amount of reproduction is very large, so if you want to breed, you can buy some seeds, pollinate the seeds yourself, and you can go to sow seeds.

After the adenium cuttings are viable, it usually takes a while to establish a stable root system and adapt to the new environment. The pruning time will vary depending on the health and growth of the plant. In general, it is advisable to wait at least 3 months after the desert rose cuttings have become viable to ensure that it has sufficient growth force and health before considering pruning.

There are a few things to keep in mind when pruning:

1.Choose the right pruning tool: Use sharp, clean scissors or pruning shears for pruning to avoid unnecessary damage to the plant.

2.Determine the purpose of pruning: Pruning can help plants form healthier shoots and a more compact growth pattern. You can determine the purpose of pruning according to the needs of the plant and your preferences, such as trimming the tree, promoting branching, adjusting the height of the plant, etc.

3.Pruning tips: When choosing where to prune, choose old, non-viable branches, pests and diseases, or branches that don't meet your desired shape. When pruning, try to preserve the healthy branches and leaves, and make sure to cut at healthy nodes.

4.Take care of the spine guard: When pruning, take care to protect your hands and avoid scratching yourself, but also be careful not to damage the plants.

In conclusion, pruning times and pruning methods can vary depending on the variety, climatic conditions, and personal preference. If you're unsure about the pruning of your desert rose, it's a good idea to consult a local horticultural expert or floral friend for more specific advice.