How to recover G drive data, how to recover hard drive data

I'm sorry to tell you that the EasyRecovery type of tool mentioned above is useful for recovering a single accidentally deleted file, but your 3G game doesn't make it clear whether it's a single installation file or the total folder where it is installed after installation. If it's a folder after installation and decompression, it's almost impossible to fix it, because this tool uses the method of disk scanning, and can only find out a single file that is not too large, and after finding out, it is all side by side, and can only recover the content and type of files, and most of the file names can't be restored, let alone accurately restore to the previous game folder tree mode according to the original folder separation. For example, if you lose a few ** on your disk, or even a few videos, it is possible to restore them.

So if it's a single large installation file, you can use this tool to give it a try, even if the 3G file is too large, but still give it a try.

In addition, there is a method that can be fully and accurately restored may exist in your system, as follows: click Start, all programs, accessories, system tools, system restore, see if there is a restore point that the system automatically established before, if there is any, restore your G drive to a certain moment before the accidental deletion, you can restore all the data of this disk intact!! But the premise is that your computer has not turned off the restore of the G drive.

Hard drive files can be tried with this software, I use this all the time.

It can be repartitioned with partitioning software.

Or reinstall the system. Repartition.

To scan down the hard drive partition after formatting, you can try it with easyrecovery to sweep down the hard drive partition.

The specific steps are as follows:

1.Open the main interface of EasyRecovery and click on the FormatRecovery button;

2.Select the partition that needs to be formatted and click the Next button.

3.Wait for a period of time after the program scan is over, and the lost data has been successfully retrieved;

4.Select the files you want to recover, click the Next button, and select the location of the files you want to save.

Special note: The location of the partition where the recovered files are saved cannot be the same partition as the lost files. The most rigorous method is to connect the hard disk that needs to be recovered to the slave disk, and then scan the slave disk by launching EasyRecovery on the primary disk, and restore it to the main disk partition.

In this way, you can avoid overwriting caused by misoperation, and once the recovery fails, you can try to recover again, and you can also turn to 51recovery.

There is a cracked version.

No problem to recover more than 90%.

Partition recovery software is perfect for recovery.

How to recover data if the hard drive is broken.

1. When we get the faulty hard disk, the first thing is to carefully inspect the hard disk, such as judging the fault part of the hard disk, checking whether the hard disk is opened, whether the motor is burned or whether the head is damaged, etc. Judging from the appearance, the hard drive does not show any signs of damage. After further testing, it is found that the hard disk has a knocking sound and the hard disk data area cannot be accessed, which can basically determine that the hard disk head is faulty.

After the cause of the fault is clarified, first find the magnetic head accessories that match the faulty disk, and successfully open the disk and replace the head in the clean room.

2. Connect the hard disk after the replacement as a slave disk, and the hard disk is still in an unrecognized state, which may be due to the loss of the hard disk firmware area, which may cause the hard disk to fail to boot. For Western Digital hard drives with lost firmware area, the data area can be accessed through the firmware loading technology of the Efficiency Source DC Data Recovery Compass. Connect the hard disk to the DC data recovery compass, start the data recovery software, get the hard disk information in the "Firmware Loading" working interface, and successfully obtain the hard disk information.