Is inorganic the same as intrinsic energy? What is the difference between inorganic rubber and inter

Even if they are different, the principle of the two is the same. The most obvious is sponge springing. Inner energy is more common in coats.

Contains energy and high elastic sponge. Regular inorganic is foaming sponge primer. The principle of both is that the high-elastic hitting effect can be achieved without the expansion of the external organic glue, similar to the SEEP without irrigation of the bus, and the G series of SRIVER can be directly applied to the inorganic glue (of course, the effect of the internal glue is better after organic expansion)....For example, the neo series does not require organic expansion at all...Personal humble opinion.

This one is definitely different.

Internal energy can be said to be the transition from organic to inorganic. It is in order to cope with the advent of the inorganic era, and the technology invented, in layman's terms, is that the internal energy can maintain good elasticity without glue. There is no problem with organic or inorganic glue for internal energy.

Organic glue will be more elastic.

The inorganic sponge cover glue is difficult to apply organic glue, which will have some adverse consequences. Therefore, only inorganic glue can be applied, and the elasticity can only be maintained by pre-priming. In order to achieve organic elasticity, it can be said that most of the inorganic rubber sponges are internally energetic (except for some inorganic long glues such as butterfly longii, which do not use internal energy technology).

It is not the same, inorganic refers to glue, and internal energy refers to sponge.

There are two ways to increase internal energy, one is to absorb heat, and the other is to do positive work on it.

How to judge the increase in the internal energy of an object, that is, the increase in temperature, we generally ignore the molecular potential energy inside the object.

Therefore, if the object absorbs heat, it can also release heat at the same time, and it is not possible to judge whether the internal energy of the object has increased.

The most important use is density, which is usually used in separation and purification.

Roughly remember that the chain hydrocarbons are larger than water, and the benzene content is smaller than water, and so on.

Also remember some characteristic physical properties such as the smell of esters, the state of chloroform at room temperature, and so on.

It is best to consolidate your memory and summarize the key points of the common test by doing more questions.

Inorganic? It must be different......

Inorganic is generally for glue, not rubber, that is, the glue used to glue the racket and the glue is made of inorganic materials, the main advantage is that it is non-toxic, and the glue is firm; Internal energy is for the sponge with glue, that is, the sponge adopts the so-called "internal energy" technology, which can maintain good elasticity without glue.

The internal energy rubber is newly developed by manufacturers in response to the era of inorganic glue.

The inner energy sleeve is usually more elastic and as close as possible to the effect of organic glue after glue filling.

The rubber that does not use organic glue is inorganic rubber, and the internal energy is not necessarily.

Simple! Inorganic rubber is a sufficient and non-essential condition for internal energy rubber.

Inorganic glue is the international table tennis federation promulgated after the promulgation of the "glue ban" can not use organic glue to achieve the effect of the previous use of organic glue after the glue set of glue, to put it bluntly, the inorganic glue does not need to be filled, with inorganic glue can also achieve the effect of the previous glue potting. Through this special technology, the molecular structure of the sponge is changed, so that the bubbles of the sponge are increased, the air permeability is enhanced, and the elasticity is increased, so that the sponge is softer, more ball-eating and more elastic.

CJ8000 internal energy two-sided arc ring rubber does not need to be glued, inorganic or organic glue can be used, no glue is needed.

The internal energy rubber is to say that the sponge contains internal energy ions, and there is no need to improve the expansion of the sponge through organic glue, and the non-internal energy rubber is that the sponge does not contain internal energy ions, and after a long time, the expansion of the sponge is reduced, and it is necessary to rely on repeated brushing of glue to maintain the expansion of the sponge.

Inorganic.

Inorganic, a chemical noun. Compounds are related to or derived from non-living organisms, and generally refer to compounds that do not contain carbon atoms except for carbonate and carbon oxides. Such as inorganic chemistry, inorganic chemicals, inorganic substances, inorganic acids, inorganic salts, inorganic coatings, inorganic pigments, inorganic fertilizers and so on.

Inorganic functional materials belong to inorganic materials, but not all inorganic materials belong to inorganic functional materials. For example, Al2O3 mainly uses its mechanical properties and is a structural material, rather than a functional material. ZNO uses its electrical and optical properties to be an inorganic functional material.

Belong to, semiconductor monocrystalline epitaxial films: monocrystalline, isotropic polycrystalline silicon films: long deposition time, repeated deposition.

Semi-insulating oxygen-doped polycrystalline silicon film Insulating silica Silicon nitride.

There is a slight difference. First, the organic glue seems to be less viscous, and it is not easy to damage the bottom plate when replacing the glue; Be careful when the inorganic glue sticks to the peeling glue. The second is that it can be a lot worse. The third is that the organic smell is too big, and the smell is a bit unpleasant if you don't stick to the ventilation.

If you don't pour glue, you don't use glue to expand the sponge, and the inorganic internal energy effect is better than that of organic, but try not to use organic glue for inorganic covering, which will be damaged.

You don't even pour glue, why do you want glue (what do you think.)

If we ask about the composition of ecosystems, we cannot strictly say that we cannot answer "inorganic environment", and from a conceptual point of view, we can think that non-living matter and energy refer to the inorganic environment.

**Unclear, it is recommended to take a new one. In fact, asking the teacher is the fastest.

Because adiabatic q=0 rigidity u=0 generates water pressure that increases h>0

Tianji 360 is a relatively new rubber for Double Happiness, the sponge is relatively soft, and it is good to use on the backhand, using the original Tianji 3 mask with No. 60 sponge. It is enough to brush the glue 3 times, and the organic glue will do.

The rubber sponge is very integrated, soft to eat the ball, and can create strong rotation by stable friction.

When twisting and tearing, it is the same as sticking the ball on the rubber surface and throwing it over, there is no need to worry about slipping, and the control and speed of the arc circle are good.