Can a broadband interface enable two computers to dial different numbers through a router?

This situation is impossible to achieve.

Only one can be used for a line.

Like the back-end system of the telecom room, the technology is mature and will directly bind the port.

Operators with immature technology generally bind a single device, but the same device can be used on a line in turn. However, it is not possible to reach the case of two on one line.

Use a router, the computers on both sides can go directly to the Internet without dialing, I have a router at home, so you don't need to dial up, if you want to turn off the router, you have to use dial-up on the host.

Yes, a good route will meet your requirements. But the price can be rented for another broadband.

There are old computers that can do soft routing. Mono or sea spider is simple and practical.

One router is connected to multiple computers, and several computers cannot be dialed separately.

Two routers can dial up Internet access at the same time, and the specific two methods are as follows:

First method:

From the LAN port on the original router to the LAN port of the new router, the IP is set up the same as the original computer. It's very simple, it is to turn the router into a switch, and it is a waste of one more port, or you can't connect to one more machine.

The second method:

From the LAN port of a router to the WAN port of a newly purchased router, a series of settings are required.

There are two ways to set it up:

1. If DHCP is enabled on the higher-level router and there are no other DHCP servers, the second-level route can be obtained using dynamic IP.

2. If the DHCP server is not enabled on the higher-level router or there are multiple DHCP servers and static binding, the secondary route can be set to static IP mode.

No. The ISP accepts only one access.

You can set one of them to be autodialed.

Broadband dial-up Internet access: When the router was not used before, the stand-alone computer system used the broadband Lian Songxiang to dial the wild bump number, and the operator gave a username and password. This is currently the most common way to access the Internet, and most home broadband is the Internet access method.

As shown in the figure below, in the router interface, find "Network Parameters" and "WAN Port Settings Noise".

Then, you'll see the following diagram.

4.Reboot and the setup is successful.

A broadband can only be dialed by one router, and if there are two routers, the broadband cat can be connected to the router, and the router can be connected to the router.

Router to wireless router, second router setup, there are two ways (provided that the first router has been set up):

The first method: dynamic IP mode (the first route is the primary route, and the second route is the slave route).

1. Plug in the router and do not connect the LAN port of the main router first, and reset the slave router (restore the factory);

2. Connect the computer from any LAN port of the router to enter the settings page;

3. Set according to the dynamic IP;

4. Then set the SSID, encryption method and password;

5. Save and restart;

6. After setting, connect the network cable from the LAN port of the main router to the WAN port from the router.

The second method: wireless AP mode.

1. Connect the computer to the LAN port of the router first, and change the IP address of the slave router. For example, most router addresses are, we just need to change from router IP address to that;

2. Turn off the DHCP function from the router in the settings;

3. Finally, connect the network cable from the main router to the LAN port of the slave router (any one is fine), note that it cannot be the WAN port.