How to wipe the ocean clean, how to clean the ocean discoloration

Updated on culture 2024-04-18
11 answers
  1. Anonymous users2024-02-08

    Oceans belong to silver coins.

    Generally, gold and silver coins can be made of weak acid.

    Weak alkali treatment, others are not recommended. Because although acid and alkali can temporarily clean the surface, the corrosion of copper, nickel, aluminum and other materials will look very ugly in the future.

    The most commonly used dish soap is dish soap.

    Or wash with soap, or put in boiling water and boil for 5-10 minutes, but sometimes the effect is not obvious. This type of method is less damaging to the coin itself.

    Darkened, darkened, and dirty coins are soaked in boiling water, then squeezed some toothpaste on the surface of the coin, and then scrubbed with a soft cloth, repeating several times.

    If the surface of the coin has been oxidized and the dirt is more serious, you can use a coin brush to rub it to remove the dirt and oxide layer and restore its original appearance.

    All the quality and modern coins, the surface of the coin only has a slight oxide layer, dust, and hand sweat.

    Fingerprints, etc., can be wiped several times with an eraser, and the surface will be as bright as new.

    Coins with serious dirt and no longer visible patterns cannot be removed by the above methods, so dilute hydrochloric acid can be used first.

    Soak for a few minutes, then soak in alkaline water for a few minutes, then wash with water, and finally brush a few times with a coin brush.

    If the quality is different, the issuance age is old, the surface of the coin has been oxidized and corroded, you can first soak the coin (except aluminum coins) in vinegar for a few minutes, wash it with water after taking it out, and then rub it with a coin brush (glass fiber system) several times, and you can also remove impurities and dirt on its surface.

  2. Anonymous users2024-02-07

    The method of cleaning a silver coin depends first and foremost on the degree of oxidation of the silver coin and its fineness. Oxides formed on the surface of silver alloys with high silver content have different characteristics than oxides formed on the surface of silver alloys with low silver content.

    If a coin with a high silver content is left underground for a long time, or if it is subjected to other adverse factors, a thick layer of oxide will form on its surface, and the coin should be soaked in an aqueous ammonia solution for 1 hour (composition: 90% water and 10% concentrated ammonia). If there is no aqueous ammonia solution, sodium carbonate solution (30 grams of edible soda ash dissolved in 100 grams of water) can also be prepared instead.

    The coin is placed in the solution for a few hours until the oxide is completely dissolved.

    If the high silver content of the silver coin is only slightly oxidized, then it is best to clean it with an ammonia solution with a sodium carbonate solution and toothpaste to make a paste. This paste should be soft to the touch and free of fine hard particles. This is done by gently applying it to the surface of the coin with your fingers or with a soft brush, and when the oxide has dissolved, rinse it off with clean water.

    Low-silver silver coins with copper as a intermediate alloy turn green when heavily oxidized. To wash such coins, it is best to wash them with a solution of 5% dilute sulfuric acid. When the rust layer is dissolved and receded, it is cleaned by cleaning the silver coins with high silver content.

    However, if the oxide on the surface of the coin is homogeneous, it is not necessary to clean it off.

    Tips: Generally, coins should not be cleaned, because of dust, sweat, the hands of the player, or buried in the soil, long-term friction, and even the passage of rays in the air, layer by layer, the gradual formation of the surface shell, called pulp. The pulp is also known as "black lacquer ancient", it is smooth and gratifying, and the light is quiet, telling you that this thing has an age, revealing a warm old atmosphere.

    That's exactly the contrast with the dazzling "thief light", impetuous tone, and dry texture of the new product that has just come out. Pulp is not only the best protection for coins, but also the best material for coin identification! If it is dirty things that get on later, the best way is to boil it in boiling water, and the real pulp cannot be boiled.

    This is also a good way to identify the authenticity of the toning!

  3. Anonymous users2024-02-06

    Simple treatment can be electroplating.

    The method is as follows: 1. Go to a nearby Chinese medicine pharmacy or pharmacy to buy a pack of alum;

    2. Then boil your ocean in water at the ratio of water 10:alum 1 (the water must be boiling);

    3. Take out the ocean and put it in cold water with a soft brush (such as a toothbrush) and dip it with toothpaste or laundry cream or salad to clean;

    4. Dry it with a hair dryer and wipe it with suede to make it look as good as new.

  4. Anonymous users2024-02-05

    It's not worth anything when it's washed! A Tibetan friend got a bronze mirror! Seeing the rust on it, I found the gauze and polished it, and came to the gate of Huayu for identification, and got married is an expert who gave such a sentence, your salary is too expensive, it was originally worth 200,000, and you wiped 100,000 yuan like this, the salary is too expensive!

  5. Anonymous users2024-02-04

    A little trick to wipe the glass, no longer afraid that the glass will not be clean.

  6. Anonymous users2024-02-03

    Tips and tricks.

    1. Wipe the glass with newspapers: There is ink on the newspaper, so wipe the glass with the newspaper that has been read and just published, which can quickly remove stains and oil stains; Then wipe it off with soft paper or cloth.

    2. Dip cotton yarn in warm vinegar: Wipe the glass with cotton yarn dipped in slightly warmed vinegar, which has high efficiency and good quality. Tips for cleaning glass.

    Method 1: First find a few small soap heads (use soap for washing clothes), then hit a basin of hot water, put the small soap heads in the water to dissolve it, and after the water becomes warm, you can use a rag dipped in soapy water to wipe the glass, and wipe it again with waste newspapers after wiping. The glass that is wiped in this way is particularly translucent.

    Method 2: In fact, this can't be regarded as another method, but it may be a little easier than the previous method, that is, first wipe the surface of the glass with a damp cloth, and then wet the small soap head and apply it directly to the glass, and then wipe it with a damp cloth. Hehe, this method doesn't seem to be easy enough, I used the second method yesterday to wipe it, and even the oil stains on the glass have been wiped off.

    You can give it a try, ah, what are the tricks for cleaning the glass, wipe it with a slightly damp old newspaper. When wiping, it is best to wipe one side vertically up and down, and the other side is horizontally stacked on the left and right, so that it is easy to find the missing wipe.

    Powdered teeth in water, wipe both sides of the glass with this solution, wipe with a cloth after drying, and finally wipe with a crumpled newspaper.

    3. Mix a little ammonia (10:1) in the water, scrub the glass, and finally wipe it with a dry cloth and crumpled newspaper. Rinse with warm water and wipe with a damp cloth dipped in a little alcohol to make the glass particularly bright.

    Now there are many window panes in the living room, and the area is large, so you can wipe it with a damp cloth dipped in alcohol (liquor or liquor) or warm salt water to remove the stains, and then wipe it again with old newspapers, which is fast and clean.

    4. Buy a new elbow plastic sanitary brush, carry a small bucket of water to soak the brush, and scrub the glass directly. Due to the strong cleaning power of the plastic sanitary brush, the dust on the outward side of the glass can be brushed off, and the brush has a certain length, which can easily clean the glass. If the glass is too dirty, you can put some detergent in the water.

    This method is especially suitable for use in winter.

    5. Wipe the glass with a damp cloth first, then dip a little liquor with a clean damp cloth, and wipe it on the glass with a little force. After wiping, the glass is clean and bright.

    6. Use a spoonful of shampoo with a little water or shampoo after washing your hair, wipe the window with a cloth, and then wipe the window dry with a dry cloth or paper, and the window will become bright, beautiful and clean.

  7. Anonymous users2024-02-02

    A little trick to wipe the glass, no longer afraid that the glass will not be clean.

  8. Anonymous users2024-02-01

    Rub the ...... vigorouslyHaha, just kidding, we generally use alcohol to clean the glass at home, if there is no alcohol, use liquor, and the glass is very bright with wine, unlike washing powder or something, which will leave a mark after wiping. Now there is also a glass cleaning artifact, which saves time and effort and is clean when used, I hope it can help you with children's shoes.

  9. Anonymous users2024-01-31

    In the army, I used to wipe it with a damp rag first, and then with a newspaper. Barely visible at its cleanest.

  10. Anonymous users2024-01-30

    1. Use a good wet towel dipped in warm water at about 30 degrees Celsius and wipe it (be careful to wring it out).

    If there is oil, wipe the oil with a tissue dipped in dish soap and then wipe it with a towel.

    I've been wiping my notebook like this every 2 months for 4 years and I'm still having no problems.

  11. Anonymous users2024-01-29

    Wipe with a cotton ball or a tissue dipped in water, and dry it with a tissue. Rubbing it a few more times will definitely be clean.

    Do not use any detergents or organic solvents, such as alcohol, gasoline, banana water, etc.

Related questions
15 answers2024-04-18

1. Dish soap, soap, etc. can be used for daily cleaning of ceramic tiles. >>>More

10 answers2024-04-18

Soak shoes: Throw the shoes into the basin, fill the basin with 2 3 pieces of water, and the washing temperature should not be higher than 45 degrees Celsius, so that the shoes are soaked with water, and some washing powder can be added to the general mesh shoes. Note: >>>More

8 answers2024-04-18

1. Cement and grinding stone floors can be cleaned with a nylon brush or soapy water; If there is a dirty area, you can use force to scrub it several times and then dry it. >>>More

13 answers2024-04-18

1. Tool removal method.

Glass water, watering can, scouring pad, glass scraping and rubbing with a watering can to replenish glass water at any time. Among them, if the scouring pad can be replaced with a sponge with better water absorption, the effect is better. Because it doesn't take much friction to remove scale, as long as the glass is full, the scale is very easy to dissolve. >>>More

6 answers2024-04-18

Cleaning and maintenance methods of glaze:

1. Tea stains, fruit stains, coffee, sauce vinegar, leather shoe prints and other stains can be used with sodium hypochlorite diluent (bleach), soaked for 20-30 minutes and then wiped with a cloth; Some stains that have been infiltrating the brick for a long time can be soaked for several hours. >>>More