How do you turn off the big shower, old dripping,

There is a water distributor at the connection between the shower column rod and the valve body, and there is a shower switching knob on the water divider, and the large shower is closed and the small shower is turned on through the knob. In addition, after bathing with a large shower, the large shower will store some water, resulting in dripping. If it is dripping all the time, it means that the valve switch is not tightly sealed.

After the shower is turned off, it is still dripping after a while, and there are two situations:

One situation is that if it is dripped for a while, it will not drip slowly, which is normal. Because there is still water in the water pipe and shower, the water flow is not clean after it is closed, and there is a height difference from the switch of the shower to the top of the shower. After use, the air pressure and atmospheric pressure inside the shower are in a balanced state, so the water inside will not flow out for a while, and after a period of time, the balance will flow out.

Of course, when the shower is used for a long time, the seal at the switch or the interface will be more or less affected (but this is not a quality problem), when you turn off the switch, there is a height difference in the residual water in the shower cavity, so this part of the water will lose tension and drip down. Usually this condition lasts for about a minute, and within 30 seconds the amount of water will be relatively large.

Another situation is that if the water has been dripping non-stop after being closed, and it is still leaking for more than ten minutes, it depends on whether the valve core of the shower body is damaged or the switch is not closed tightly.

Because there is no pressure when the valve is closed, the water trapped inside cannot be sprayed out, but can only seep out slowly.

What causes the shower to drip water:

1. The problem of shower blockage.

The bath nozzle is used for a long time, and the amount of water will become smaller, because the water quality is not good, the water contains a lot of alkali, and the scale is deposited in the water outlet, resulting in the blockage of the shower.

2. Shower plating problem.

The paint of the shower coating is ugly, and if you have just bought the shower, this kind of problem occurs, which is very affecting the appearance. And some poor quality showers can also cause clogging due to paint peeling.

3. Material problems.

Some showers are made of plastic or cast iron. The plastic material may have a lot of waste added to it, and the service life will not be very long. Of course, some hand showers use materials such as plexiglass, ABS, etc., and the quality is still okay.

However, it is not recommended to choose a shower made of cast iron, which is extremely prone to rust.

How to solve the shower dripping water:

1. If there is dripping water in the normal shower, it must be caused by the aging of the gasket inside for a long time. Replace it with a spacer that matches the size of the spacer, which can solve the problem of dripping water in the shower.

2. If there are cracks in the contact part of the shower, it will also lead to dripping and leakage. If the glue does not stick, it is recommended to replace it with a new shower.

3. On the other hand, if there is a dripping situation in the shower, the part of the shower head may be caused by internal blockage. After disassembling the showerhead, there may be some stones and so on, blocking the normal flow of water, which may allow him to store water in it and then drip water.

4. If the contact part between the shower and the threaded pipe is dripping, it may also be caused by the gluing of the rubber pad after the threaded pipe has been used for a long time. It is possible to replace it with a new threaded pipe.

5. If it is not easy to replace, you can also directly replace a threaded pipe and a shower, so that the overall effect of replacing the new one is better.

The overall reason is that the internal structure of the mixing valve is not tight. The continuous dripping of the sprinkler head is the problem of the valve, and it is best to change the valve.

After closing the water valve, the remaining water will drip down, because the top sprinkler head is inclined and there is a certain angle to the horizontal plane. The solutions are:

1 Because the top sprinkler head can be adjusted in direction, after the shower, tilt the top sprinkler head to the maximum angle and put the stored water clean, which can be solved.

2. Adjust the water outlet side of the top nozzle to place the level, and seal the water outlet hole so that no air enters and can achieve the effect of no dripping.

When purchasing a shower, try to use a top sprinkler head with a thin water outlet hole, and adjust the placement level of the sprinkler head and drain the water storage after use.

The shower is broken, just change it.

The water valve seal is broken, it is recommended to replace it.

Check it to estimate that the seal is leaking.

Usually, we all pay attention to the moisturizing of the face and neglect the moisturizing of the body. It is often after taking a shower that you find that your skin is dry and you really need to replenish water. But it's troublesome to apply body lotion every time you take a shower. How can I prevent my skin from drying out?

Teach you a very simple way to prevent dry skin and save time. You can opt for bath products with essential oils added to them, and many body scrubs contain moisturizing essential oils. You'll notice that your body is still slippery and not dry after bathing, enough to skip the body lotion.

Another easy DIY way to prevent dry skin is to apply a layer of olive oil to the damp body in the final step of the shower, then rinse again. Even if you don't apply body lotion after drying your body, it won't dry out.

The shower keeps dripping after it is turned off, and it is mostly caused by the shower leaking. If the gasket is aging and leaking, we can rotate the shower head to remove it, replace the new gasket and then install the shower head; If it is caused by cracks in the shower head or threaded pipes and other accessories, you can replace the damaged accessories, or directly purchase and install a new shower.

It means that your switch has a water leakage, generally speaking, it has nothing to do with this shower, you should try the mixer switch.

Sudden water flow after the shower is turned off, is a problem that many people will encounter, sometimes it is turned off after a period of time before the water suddenly flows, and each time the time is very short, today let's talk about the 3 reasons for the shower leakage and the solution.

The residual water in the shower cavity takes a certain amount of time to drain out.

1. The quality of the shower is not good, and 2. The inside of the shower is a little clogged.

Because the water valve is leaking, the water splashes and ticks.

If it's a bad time, it's definitely a broken spool.

After the shower is turned off, there is still residual water after a while, which is divided into two situations: 1. If it stops after dropping for a while after being turned off, this is a normal phenomenon; Because, there is still water stored in the water pipe and shower, and after it is closed, it does not flow clean, so it will drip for a while; 2. If it has been dripping after closing, it means that the switch valve is damaged or it is caused by not closing it tightly.

It's not a problem with the shower, it's a leak in your faucet, so consider replacing the faucet.

It's the top spray that's still dripping after it's turned off, right?

In fact, this is indeed a normal phenomenon, because your top spray is not equipped with a water stop valve, so the water left for the top spray will still have residue after it is closed, so it will drip and drip

It's okay, just get used to it