-
You can find the complaint platform from the Autohome app or the Auto Review app, upload the relevant questions, and after the review is passed, the 4S store will reply to help solve it! It works so much, you can try it!
-
The engine is not afraid of mold, I really don't like it, just go to the beauty shop to clean it, there is no need to look for 4s, a little.
-
The engine compartment of the car is very moldy, and staying in a damp place for a long time will have the following effects on the vehicle: 1Accelerate line aging, corrosion, and even spontaneous combustion. 2.The heat of the loose gear becomes worse, and the fuel consumption of the finchite will increase.
-
To answer this question, it is necessary to know whether there is any potential safety hazard to the vehicle after the engine compartment is dirty.
1.Under normal circumstances, dust or dirt in the engine compartment does not affect the use of the vehicle and does not affect the performance of the engine. You may think that dust build-up in the engine compartment affects the heat dissipation of the engine, but in fact, the engine is dissipated by the heat dissipation system, and the effect of dust accumulation is almost negligible.
**From the Internet).
2.There are a large number of electronic components such as wiring harnesses, sensors, connectors, ignition coils, and ECUs in the engine compartment of a vehicle.
Equipment. Once cleaned, it can lead to short circuits, corrosion, and failure of the part.
To sum up, it is not recommended to clean the engine compartment, and here are a few cases of parts failure caused by cleaning the engine compartment.
Case 1: Water enters the vacuum control valve, causing the plunger seal seat to swell and detach from the plunger, and the atmosphere communicates with the joint cavity of the supercharger connecting pipe, resulting in no negative pressure output.
Case 2: Water enters the injector, and the water penetrates into the chlorine element in the water between the injector housing and the valve body.
Corrode the surface of the injector valve body, resulting in rust and cracking of the injector valve body.
Case 3: Water ingress into the engine wiring harness, resulting in corrosion of the wiring harness pins and poor sensor contact.
Therefore, it is necessary to clean the engine compartment, and there is a risk of corrosion of parts, so there are no special circumstances, and the most important thing is not to clean the engine compartment easily.
If you have to wash it, how do you wash it?
If you have to clean the engine compartment under special circumstances, you can go to our Geely 4S store to wash it, blow the dust off with gas iqiang, clean it with a brush, and wipe it clean with a dry cloth.
Some car owners will ask, I think it is not clean enough to blow dust with gas, at this time we can consider using foam cleaner (there may be corrosion in the foam cleaner, which can be used under the identification of the staff).
Notes:1It is forbidden to flush with high-pressure water guns: avoid vacuum control valves, fuel injectors, generators, spark plugs.
Holes, fuse boxes, wiring harness plugs and other sensitive parts enter Hechang water, causing a series of engine failures such as short circuits. Therefore, car owners must not be careless!
2. When using foam cleaning agent, it should also be noted that the engine decorative cover needs to be assembled during the cleaning process, and the engine body, wiring harness and other parts should not be cleaned, but only the plastic or leather surface should be cleaned.
**From the Internet).
3.During the repair and maintenance process, protective measures should be taken for engine parts (vacuum control valves, fuel injectors, generators, spark plugs, fuse boxes, wiring harness plugs, etc.) to prevent liquids (including coolant.
The cabin does not need to be cleaned frequently, but it is still necessary to advise the owners and friends who love to clean not to do things that outweigh the losses, and to take care of the car in order to better serve us.
-
The car has been parked for a long time, and there is mold inside, so you can take out all the things in the car and dry it.
Most of the musty smell of the car is because there is stagnant water, you can wait until the sunny day to drive to an open place to open the door, take out the mat in the car, and remember to take away the perfume in the car when drying, the perfume has alcohol, and the exposure to the sun is easy to occur**.
In addition, the interior of the car is more likely to become moldy, such as seats, carpets, door panels, etc. Knitted flannel interior: first use a vacuum cleaner to suck out the dust and mold on the surface of the interior, and then clean it with a special cleaning agent for the car interior, and then dry the interior after spraying, or drive the car to the sun to dry.
Ways to avoid mold in the car:
1. If the car is not used often, turn on the heating mode of the air conditioner when parking, and dry the air conditioning pipe and the moisture in the compartment to avoid the environment in the car being too humid, which will cause mold;
2. Place some activated bamboo charcoal in the car to absorb the moisture and harmful substances in the car, so as to adjust the humidity in the car;
3. Install a solar air purifier: Placing a car air purifier in the car can not only absorb dust and impurities in the air, but also decompose harmful substances, purify the air, and avoid mold in the car.
-
Good afternoon, landlord! In this case, you have to deal with it properly, otherwise it will be really annoying. Because the mold has a particularly strong ability to reproduce, a mold spore can multiply to more than 100,000 after 24 hours of culture.
-
Consumers should pay attention to the following five points when picking up their cars.
1.Check the vehicle's "identity" documents: If it is an imported car, look at the car's certificate, date of manufacture, frame number, etc. before picking up the car.
2.Check the exterior and interior of the vehicle: whether the door gaps are uniform, whether there are paint spray spots, whether the welding points are coated with soft rubber, etc.
3.Try out all the features in the car, such as the window sunroof, car navigation audio, lights, etc. If you open or close the window or sunroof several times and find that it is not working, there may be a problem.
4.Check the vehicle maintenance records: ask the 4S shop to check the car's historical repair and maintenance records, and when purchasing insurance, you can also find out whether there is a historical insurance record from the insurance company.
5.Don't write less about the purchase tax invoice price: Some 4S stores will tell the car owner that it is best to write a low amount of the purchase invoice, and the purchase tax and insurance can also be paid less. 4S stores do this to pay less tax, but it will also affect consumers' claims in the future.
-
This first determines whether it is caused by quality or after water ingress, and if it is a quality reason, you can directly go to the after-sales service to make a claim.
Hello. Hard.
The engine is wading, if it is driving, before the engine automatically turns off, there has been damage (such as bent connecting rods) and can only be repaired; If you wade in the process of parking, do not start, contact the trailer, drag out the internal drainage of the rear cylinder, wiring harness and various parts of the engine room before starting, if there is no drainage treatment, there will still be a risk of damage to the inside of the engine, and this damage can be completely avoided. >>>More
Enter the license plate number to check whether the vehicle is burned, whether it is soaked in water, whether the structural parts are maintained, whether the appearance parts are maintained, whether the kilometers are normal, whether the important parts are repaired and other important information, you can check the types of passenger cars, large cars, new energy cars, new energy vehicles, etc. >>>More
The knock sensor is installed in the middle of the engine block, and the four-cylinder engine is installed between the 2nd and 3rd cylinders, or one in the middle of the 1st and 2nd cylinders, and one in the middle of the 3rd and 4th cylinders. Its function is to measure the degree of engine shake, and to adjust the ignition advance angle when the engine detonation.
Since they overturned your car, it is their own responsibility to help you fix your car, and you can negotiate with their person in charge. >>>More
What is the quality of the 4G63S4T engine, there are the following 8 points: >>>More