Which of the following is NOT a pin for port A?

The main thing is that you don't have an option, so there is no way to help you choose, if you have a pin, you can directly choose A, which is very convenient.

In this case, the fourth option should be selected, and it should not be a pin for port A.

The following one is not a port, I haven't found this one, and I don't know too much about this one.

Which of the following is not the short of the port, is it called a leg tube? Because I really don't know the style of the armor, I can't see it clearly, what to buy, which one?

The wide-angle of port A is bound in one of the following ways:

This is not very obvious, and I don't know what you are asking? You should let someone else give you the complete question.

Play with that kind of nutrition problem, you can look up his manual on the Internet.

There is no option for you to ask this question, why you, this can't be you, remember to write the option next time.

Which of the following is NOT the key to a port class? You can check the specifics to know.

Which of the following port A is in a hurry, and we haven't seen your port number?

It's a difficult question, what does the following refer to?

Which of the following is not the housekeeper of port A, eh, this port also has to be piped, it should be a bad statement, right?

Which of the following is NOT a pin for port A? I don't quite understand what you mean by that, do you? Didn't see what you expressed.

Turning it off is not this one turning it off, and then you can look at which one you need, and then you can find the key to it.

Which of the following is either the pins of the port or C and D, and they are also far away from the port.

Hello, what you're talking about is an introduction to discipline.

As for the leg of the port, I feel that it should be the second of His Majesty's pin if it is not.

Which of the following is not the corner of the port?,This specific should be the 1st.,The first word you checked the dynamics in this regard.。

Which of the following is not the number of the port, I don't know the pipe angle, this is based on the reality, if necessary, to be operated by professionals.

As can be seen from the figure, SW2 is marked as the root bridge (with the lowest priority), SW1 F0 1 and SW4F0 2 are the root ports (directly connected to the root bridge and have low overhead), the MAC address of SW1 is less than SW4, so the bridge ID is small, so SW3F0 1 is blocked, and the peer port is the specified port (SW4F0 1).

sw3f0 2 is the root port.