How to learn to correct the reversing and storage, and how to correct the reversing and warehousing

The main thing is that you have to adjust the reflector to be OK.

The correction method for reversing into storage is as follows:

1. When reversing into the warehouse, the steering wheel of the car is early, so the steering wheel should be returned to the steering wheel some time in advance;

2. The direction is late, this is the opposite of the early operation, and when you return to the right direction, you have to wait for the point to return to the right;

3. Whether the body is right, at this time, we need to use the rearview mirror to observe, if you find that the space on one side of the car is relatively large, then when reversing into the garage, you should put the direction in the corresponding direction a little more.

The method of reversing and correcting the direction and position of the vehicle is as follows:

1. Under normal circumstances, when the right rear wheel of the vehicle reaches the right corner, we have to return to the right direction, and observe the body and the side line through the left and right rearview mirrors to correct the body;

2. In the rearview mirror, the body is parallel to the side banquet line, which means that the body has been aligned, and the scattered silver can maintain a positive direction and continue to retreat until the lower edge of the rearview mirror reaches the sideline;

3. If you find that the body is not parallel to the sideline, then you must judge which side the body is deviating to through the left and right rearview mirrors. The principle of adjustment is that where the rear of the car is deviated, it will be played in the opposite direction;

4. Taking the rear of the car to the left as an example, you can see in the left rearview mirror that the body and the side line show a large position relationship between the front and the back. At this point, you should make a circle to the right and then continue to reverse, so that the rear of the car goes to the right, distance yourself from the left sideline, and return to the right direction when the body is parallel to the sideline. Then keep it in the right direction and go backwards until the rolling edge of the hill under the rearview mirror coincides with the sideline.

Pay attention to the following two points in the direction of reversing into the warehouse:

1.When reversing, turn left, turn left at the rear of the car, turn right, turn right at the rear of the car – driving in the same direction as heading.

2.When corrected, when the rear of the car is tilted to one side, the collapse is also known to return (fix) to the other side. (If the body is tilted to the left, it must be moved to the right to correct, and the steering wheel must be turned to the right.)

Otherwise, when you find that you are still leaning to this side, you will always think that you are wrong - in fact, yes, only when you return (repair) to the right direction of the square potato core, can you continue to turn to the other side to change the direction of the rear of the car, and not returning to the direction of the opposite direction can only reduce the deviation of the rear of the car.

3.You should master the operation method of "slow start and fast turn".

The reversing speed should be controlled within 5km h, when reversing, if it is necessary to move forward or backward repeatedly due to the terrain or steering angle of the steering wheel, it should be quickly turned the steering wheel through the movement of the vehicle at the moment before each backward or forward stop, so as to prepare for the re-steering, and after the vehicle is stopped, the steering wheel shall not be forcibly turned.

The specific approach depends on the actual situation. If you want to adjust, put your hands on 12 o'clock.

First, if the body is too wide, hit 90 degrees, that is, hit 9 points to the left and 3 points to the right.

Second, if the body is not too big, hit about 45 degrees. But remember, as soon as the rear of the car moves, you have to turn right, that is, back to the 12 o'clock position, otherwise you have to go in the other direction. Remember, don't hit left and back, and play back and forth if you don't get there.

In fact, it doesn't work. After all, the garage is only a few meters long, and if you don't control your feet well, it's the bottom line all of a sudden. I was like that at first.

When I poured into the garage, it was okay, the body was not too crooked, I always wanted to fix it, but it was better not to fix it once. Later, I realized these two things:

1.Correction of the direction of correction, 2Corrective actions should be neat (don't fix the steering wheel left and right if you don't get in place, you can only make yourself nervous and waste time).

The most important thing in the later stage is to do a good job of reversing and warehousing, so that there is no need to repair. I wish you to realize the truth as soon as possible, just practice more, and another point is to control the clutch. If it's slow, you'll have plenty of time to make corrections, otherwise you'll be in a hurry.

Millions of car purchase subsidies.

Reversing into storage, the most important thing is to learn to correct the direction, if the body is not correct, it is very likely to continue to reverse in the process of pressing the line, so how to correct the body of the reversing into the warehouse? Let's learn through **and**.

Before correcting the direction, we must keep in mind a principle: where to hit the direction and where to swing the rear of the car.

First of all, we need to judge which side the rear of the car is offset, then determine which side the rear of the car should be taken towards, and finally turn in the corresponding direction, and the body is about to return to the right direction and continue to the next operation.

There is also a situation, that is, the body is parallel to the garage, but the vehicle as a whole is left or right, if not adjusted, it is easy to press to the front corner of the garage when leaving the garage. As shown in the figure, if the body as a whole is on the left, then you can first hit the right direction of 1 4 circles, observe the front wheel do not easily press the line, when the distance on the right side is about the same, then hit the left 1 4 circles direction, the body is parallel to the garage again, back to the positive direction; If the body is tilted to the right, then the operation method is the same, but in the opposite direction.

Backup storage preparation: The vehicle is parallel to the bottom line (the front cycle is positive, depending on the steering wheel leak and whether the left front wheel is positive).

Note: First, when reversing into the warehouse, the steering wheel turns too early, and the remedial measures when the right rear end of the car and the front right end of the warehouse are too close in the rearview mirror - that is, before the car enters the rear door, the space gap from the right front end of the car is modified for a short time.

Second, when reversing into the warehouse, the steering wheel turns too late, and the remedy when the right rear end of the car and the front right end of the warehouse are too far away in the rearview mirror - that is, the rear door will enter after a short time of modification from the space gap between the right front end of the car.

There are three cases regarding the correction of the direction of reversing into storage.

First, the direction is early, and then you need to go back;

Second, the direction is late. At this time, you need to time your body, and the direction still does not return. Wait until the distance is almost up.

3. Fine-tune and repair the body after warehousing.

The following is a summary of the previous experience of reversing into the garage and telling the friends who are taking the driver's license test. I hope everyone can accept it after reading it.

For example, the right reverse garage: (the same is true for the left garage) Learn to look at the distance from the rearview mirror tires to the garage. The coach said that the exact distance was 2 finger widths.

1.Early morning direction is near the upper right corner of the garage: when the right rear wheel enters the garage and exceeds the upper right corner (don't look back as soon as the right rear wheel arrives), continue to turn in all directions to the right, and return to the positive direction when the body direction is not correct (at this time I can also look in the rearview mirror to see if the front direction is correct).

2.The direction of the taxi is near the upper left corner of the garage: if you find that the tire in the rearview mirror is far away from the upper right corner of the garage, immediately look in the left rearview mirror.

Don't look back at this point, tilt the car, wait for the left rear wheel to enter the garage outside the upper left corner, then turn back to the plaza and continue to turn left. After seeing the left side of the left rearview mirror safely entered, immediately look at the right rearview mirror and wait for the body to return to the positive direction to enter the warehouse.

3.It's better to play late than early. I don't expect to see it every time I enter the warehouse now, because it's hard for me to get it right in advance and correct it.

4. The clutch for reversing and storage must be stable, and there will be a long time and opportunity to do what you want to do when you slow down.

Millions of car purchase subsidies.

First, the correction method of the steering wheel playing early:

1. The steering wheel is early because the students did not find a good position, and they need to control the speed of the car, and observe the right rear wheel after half a circle (at this time, the radius of the car turns to the envy becomes larger, and the body begins to move to the left);

2. Observe the body from the rearview mirror when it is about to be on time, the steering wheel is back to the right, and the rearview mirror can be slightly corrected, and the car should not be reversed through the library.

Second, the steering wheel correction method in the library:

1. Observe the entire body from the rearview mirror, if the rear of the car leans to the right, it should be repaired to the left at this time, and the body is back to the right.

2. Judge the body by the rearview mirror, if the body is positive, but the margin side is too wide, at this time, you can repair the direction of the wide side, so that the body can press a little distance and then return to the right.

Attached: Key points of subject 2 reversing and warehousing:

1. The rearview mirror will be adjusted

The rearview mirror of a car is an indispensable and important aid when reversing. When adjusting, the mirror should be pressed down to facilitate the observation of the marking line on the ground, and the method of adjustment must be learned, because you can see that the height of the students is very different from that of the trainees, and the mirror can be better observed by adjusting the mirror.

2. Press the speed:

Novice students feel the car and driving skills are relatively unfamiliar, so they must learn to use the method of pressing the clutch pedal to control the speed, the speed is fast to press the clutch pedal to reduce the speed, the car is about to stop to relax the pedal, through repeated practice can feel the speed of the car is completely through the clutch pedal to determine the number of acres; The ideal state of pressing the clutch, the speed is extremely slow, but it does not stop.

Millions of car purchase subsidies.

1. The car is formed, indicating that the rear of the car is tilted to the right, and the direction is to the left, and when the body is positive, it will return to the positive direction.

2. When the car is formed, it means that the car is inclined to the left, and it will hit the direction to the right, and when the body is positive, return to the positive direction.

3. The car is completedshape, but the left side is wide, the right side is narrow, to the left direction, adjust to the rear track line, the ideal range, and then the track to the left direction, back to the positive direction.

The principle of reversing into the garage to correct the direction: to the tail of the car shall prevail, the rear of the car wants to lean to the right, to the right to hit the steering wheel; The rear of the car to the left, to the left to hit the square in front of the auspicious direction, and then to the opposite direction back to the right.