Wheat harvester, can light the fire, can be put on the stall or not aisle?

It may be that there is a problem with the clutch.

Incomplete clutch disengagement Fault phenomenon: When running at low speed, it is difficult to put the clutch pedal in gear in the end, or even unable to enter the gear, or the harvester is still moving forward slowly. When the harvester slides in neutral, the clutch is still in a semi-clutch state, which causes the friction plate to slip for a long time and the friction plate burns out.

Causes: Improper clutch adjustment, free stroke is too small, so that the clutch separation stroke is insufficient, the separation lever stroke is shortened, and the compression force on the friction plate of the driven disc cannot be completely relieved, so that the closure can not be completely separated. The inner spline of the friction plate hub and the outer spline of a shaft match the gap is small, so that the friction plate can not move freely, resulting in unclear separation The clutch center and the spline in the outer jacket group are not concentric, and the clutch shaft can not slide freely, causing the center to deviate to the side, so that the friction plate is difficult to separate freely.

The clutch spring pressure failure, which is too soft or the compression force of the nine springs is too large and the length is different, will cause the pressure plate to tilt on the spline, resulting in unclear separation. The non-planarity of the friction plate is too large, especially the deformation of the moving plate, because it is rigid and will produce ** when separating. The thermal expansion of the friction plate is too large and the clutch separation gap does not take into account the thermal expansion of the friction plate.

Generally, there is no incomplete separation during the run-in of the new car, and after the full running-in, the phenomenon of separation belt row is generated. Solution: Check the disengagement clearance of the clutch; Whether the thermal expansion of the friction plate is too large.

Hello, there are several possibilities, the clutch plate is not working, the propeller shaft or cage is broken. Please double-check. Hope.

Dear <>

Hello Jiamusi wheat harvester can not be in gear may be due to the following reasons:1Improper operation by the driver:

If the driver is not familiar with the handling of the harvester, or if the wrong operation method is used, it may not be able to engage the upper gear. It is necessary to read the operating instructions of the harvester carefully, and operate carefully when operating, and use the gear lever correctly. 2.

Gear system failure: A failure of the harvester's gear system may result in the failure to put up gear. It is necessary to check whether the gear system of the harvester is faulty, and if there is a rolling obstacle that needs to be repaired in time.

3.Damaged gear lever: If the gear lever is damaged or deformed, it may not be able to hang the upper gear.

You need to check the gear lever for damage, and if there is damage, it needs to be replaced. 4.The gear part is missing

Missing harvester gear parts may result in failure to engage the gear. It is necessary to check whether the gear parts are complete, and if there are missing parts, they need to be replaced in time. The above are the reasons that may lead to the failure of the Jiamusi wheat harvester, which needs to be carefully checked and troubleshooting to ensure the normal operation of the harvester.