The router light is normal, and I can t go to the network 20

1. DHCP service is enabled.

2. If the settings are correct, either you can't go on or you can do both. There is no such thing as a matter of luck.

3. Try to set the computer to a fixed IP, and DNS should also be set.

4. There is also the bandwidth is too small and the speed is slow, which makes you feel that sometimes you can and sometimes can't.

5. Use the ping command to observe the delay.

Look at the IP settings of each computer, and whether a single computer can be connected to the router's management platform.

Go into the router and take a look at some IP information.

It is recommended to use automatic IP acquisition

If it doesn't work, enter the router and see the relevant information to access the Internet, and then follow the relevant information to the computer below to designate the Internet.

Oh, it is possible that you have not made reasonable use of the router's automatic IP assignment function, it has an address pool, which may have been artificially modified, there is only one, and the default address pool of some routers is from 100 to 200, so you don't have to set the IP address manually,

You've got a jack! Route that to dial up! The cat comes out of the line and the route is marked"lan"holes. Plug in the others casually, and then enter the route to set the password, and then go on together without any problem.

If the IP address is set, pay special attention to whether the DNS is correct.

Here's how to turn on the router normally but can't connect to the Internet

1. After resetting the router to factory settings, reset the relevant network parameters, which should be caused by problems with the relevant network parameters of the router.

2. Router factory reset method: There is a small hole in the back of the router, generally written rst or reset, find a small and sharp thing such as a toothpick or pen tip, poke this small hole for more than 5 seconds when the router is powered on to restore the router's factory settings.

3. Re-set the relevant network parameters of the router: the router is a device that sets up a LAN to achieve network sharing, and the general connection and setting methods are as follows: connect the network cable from the broadband cat to the WAN port of the router, connect each computer to the LAN port of the router, and set the IP address of the computer network card to be automatically obtained, and enter it in the address bar of the computer browser.

4. Log in to the router, the general username and password are admin, select the WAN port settings, set your broadband account and password to the PPPoe mode (if it is a fixed IP, choose the static IP mode), save and restart.

Router

A router (also known as a pathfinder) is a computer network device that can send data to a destination by packaging a network (selecting the transmission path of data), a process called routing. A router is a device that connects two or more networks separately, and routing works at the third layer of the OSI model, that is, the network layer.