How to use the wireless WAN of Tengda wireless router? The model number is W308R V2

If it is a wireless bridging, the model of the two routers must be the same model as well, I have also bridged a lot of routers, in general, TP bridges Tengda's can be, but with Tengda's bridge to other routers, the success rate is not high. First enter your router, then click to turn on WDS, then scan, find your other router, then click to connect, then enter cmd in the run dialog box, and then enter, click OK, if the number can appear, it means that it can be passed. Then enter your path finder, change the IP of the machine to, that is, to separate from the IP address of the router you want to bridge, at this time run in the dialog box, enter ping If it can be passed, it means that the signal of the previous router can be received, and then enter if it is also passed at this time, it means that the bridge is successful, at this time go back to the interface of the router you bridged, take a look at the moving status, if the display is successful, then good luck, this and then turn off the DHCP, and then it's OK, of course, Not all routers can be bridged successfully, some can succeed, some can't, good luck.

How did you get online.

Here's how to set up your router:

2. Then open the browser of the computer, enter the login address and login password of the router, and the specific login IP and password can be looked at the label on the back of the router.

3. After entering the router, there will be a setup wizard, first fill in your broadband account and password.

4. Then set the wireless name and connection password.

5. After the successful setting, a prompt will appear for the successful setting, and it will take effect by restarting the router.

How to set up the wireless bridging mode of the wireless router:

1. Confirm the main wireless routing parameters.

Confirm the wireless signal name, wireless encryption method, wireless password, and wireless channel of the primary router.

Note: Before setting up, the wireless channel of the main router needs to be fixed.

2. Set up the secondary router.

1. Modify the wireless parameters and turn on the WDS scan signal.

Connect the computer to the sub-router, log in to the management interface, click Wireless Settings >> Wireless Basic Settings, modify the SSID number to be the same as the main router, fix the channel, check to enable WDS, and click Scan.

2. Select the main router signal.

Find the SSID of the primary router in the scan page and click Connect.

Note: If the WDS cannot scan the signal of the primary router, make sure that the wireless function is enabled on the primary router, and try to reduce the distance between the primary and secondary routers.

3. Select the encryption method and enter the wireless password.

Key Type Select the encryption method of the main router, enter the wireless password of the main router in the Key field, and click Save after entering. You don't need to restart your router and proceed to the next step of setup.

4. Set the wireless password of the secondary router.

Click Wireless Settings >> Wireless Security Settings, select WPA-PSK WPA2-PSK, set the same wireless password as the main router in PSK Password, and click Save. When the system prompts "You have changed the wireless settings, it will take effect after restarting", click Restart, and when the restart prompt page pops up, click OK and wait for the restart to complete.