My Nokia E66 is flooded, the following phenomenon, everyone helps

1. It is inevitable that there is a water channel in the screen of the water inlet, and it should be better to evaporate slowly in the future!

2. The sound of the call has become smaller, it may be that the person who got the mobile phone for you only put the mobile phone motherboard into the water treatment and did not use a heat gun to blow the horn to dry by the way! or the horn has been damaged due to serious water ingress (only replaced).

3. After powering on, prompt to select the headphone mode (the phone headset and single listening are headphones, it should be that the mobile phone has not been handled well when the water has entered the water, and you may also be able to see that the tail plug and the headset are plugged in, there is already oxidation (copper blue or mold)!

Look at the phenomenon you mentioned above, it should be that the person who repaired the mobile phone only gave you a simple water treatment (use a brush to take the washing water brush), and did not use the regular water treatment method to treat you The regular one is: put the mobile phone in the ultrasound, use the washing water for 15 or 30 minutes, and then take it out, and then use alcohol to clean the motherboard, blow dry, and then install the machine.

You should go and ask him to clean it up for you! Or go somewhere else

Go to repair it.,It's also money in the warranty.,The warranty has never been guaranteed into the water.,It's absolutely impossible to warrant the phone anywhere in the water.,If the problem is not serious, it shouldn't be expensive.,Take it apart and clean it up.。

Before the warranty period is over, you have to repair it at Nokia's repair center, and you don't need money.

If you don't repair it, you can use an electric fan to blow it Remove the battery and ** card and use a hair dryer to blow on the gap of the mobile phone Of course, it is best to use hot air But you have to pay attention to the temperature!

Blow it hot, put it under the fan, let it cool down on its own, and do it a few times, and the water marks on the screen will disappear.

My phone also often drops water, basically using this hair dryer method is not unpleasant!

Customer service is very dark in some areas. In fact, you can clean it yourself at home, disassemble the phone as much as possible, and use a hair dryer to blow it for several hours.

If you can't figure it out yourself, you can find someone you know to repair your phone, don't look for someone you don't know, in case you change something. You can find customer service during the warranty period, and after the warranty period, wait for him to hack you, and the customer service will also replace the parts for you.

Your problem may be that there is water in your phone, which causes poor contact.

Hello, first of all, don't worry, the phone is in the water, if it is clean water, it is easy to do, save yourself first, not clean water, take it directly to the mobile phone store to deal with the self-help method, first remove the battery, card, can be dismantled, the mobile phone case is also dismantled, dismantle the mobile phone with a hair dryer, and then the sun comes out to dry, do not dry when the sun is strong, it is easy to expose the screen, blow the wind with resistance! Two days or a day later, start to try, if there is a white screen, a flower screen, a black screen, can not be turned on and other hardware failures, can only be sent for repair, if the keyboard is not working, and press the health disorder, but also need to blow and dry. In fact, the mobile phone is not so easy to break when it gets into water, which is the best self-repair method.

It is highly recommended to deal with it briefly first and repair it at the mobile phone store.

After the mobile phone is flooded, most of the cases cause failures such as failure to turn on, abnormal display of the mobile phone and noise on the call. And some water inlet machines corrode the circuit board more seriously, resulting in the mobile phone can not be repaired for life. Therefore, when the mobile phone enters the water, whether it falls into clean water or dirty water, the mobile phone battery should be removed, and the mobile phone should not be charged again, such as continuing to charge the mobile phone, the internal components of the mobile phone will be short-circuited and burned out.

This will further expand the fault and make it more difficult to repair, so do not charge the phone again and remove the battery after encountering water intrusion into the phone. Then check whether your phone has been dropped into clean water or dirty water. If you fall into clean water, as long as you stop the mobile phone immediately, the fault will not be expanded.

After removing the battery of the mobile phone that fell into clean water, wash the mobile phone with anhydrous alcohol. Because alcohol evaporates quickly, the moisture on the circuit board can be volatilized and taken away. Then use a heat gun and hair dryer to dry the circuit board, and then you can charge the test machine, and most mobile phones will work normally.

If the mobile phone fell into the sewage, the first thing to do is to disassemble the phone to see the degree of corrosion of the mobile phone circuit board. Because there are many acid and alkali compounds in sewage, they will cause different degrees of corrosion to mobile phones. Therefore, after the mobile phone falls into the sewage, it should be cleaned quickly, and the corrosive materials that can be seen should be cleaned first.

Use a brush to brush off the impurities attached to the pins of the components. Then, use an alcohol cotton ball to clean the circuit board.

Hope it works for you

Hello: I can only go to repair it, let him help you dry it.

There are two possibilities, one is not cleaned, and the other destroys the coating of the screen, even if you use sulfuric acid, it is useless.

C6 is decisive and stress-free, just a few more days, my phone is like this.

The first time you play, you can't dismantle it, it's dangerous! Take after-sales repairs.

It seems that water enters, and the sun is the best!

Turn it off, blow it out, and wait 1 day to dry.