What is the reason for the anti plating of the board plated by the VCP line?

The main reason for this is that its process is very good, so that the galvanized sheet is relatively good in corrosion resistance, and can achieve a very good effect.

This situation occurs because the proportion of raw materials is not well adjusted, so on the other hand, its antioxidant capacity is relatively good.

The reason why the plating out of the tied board is anti-wrinkle is because probably his module does not have it. The access is very good and the right current, so it causes his plating to be unsafe.

Just because he has a membrane on the outside. So you can protect what's inside.

The reason why the electroplated out of the board is anti-acne is because it has a layer of plating on it, which then prevents it.

After the CP wire is blown out, the cause of the board to fight acne may be different depending on the one.

His anti-left eye will also have a protective film on his surface, so it will **.

There are still many reasons for the resistance of the VCP, its wire plating, and its board, and it is also because of its material problems.

1.Foreword VCP is the abbreviation of VerticalContinuous Plating, which means vertical continuous plating, compared with the traditional vertical plating, the cathode plating material takes a step way to work is its biggest feature, this working method effectively improves the quality of electroplating, and at the same time the floor space is greatly reduced, and also has advantages in mass production, so it has been favored by the electroplating industry recently. Figure 1 is a schematic diagram of the general working of the VCP line, which shows the front view of the operation interface.

The operator is in. 2.Test part Test conditions Three commonly used sizes of 24 (l) * 18 (w) inch (l) * 16 (w) inch (l) * 20 (w) inch are used.

The reason for the resistance of the board plated by VC and PE wire can be queried in the manual or the introduction of the details on the **page.

vertical conveyor plating.

Electroplating is the process of using the principle of electrolysis to coat a thin layer of other metals or alloys on some metal surfaces, and the process of using electrolysis to attach a layer of metal film to the surface of metal or other material parts, so as to prevent metal oxidation (such as rust), improve wear resistance, conductivity, reflectivity, corrosion resistance (copper sulfate, etc.) and improve aesthetics.

The plating is mostly a single metal or alloy, such as titanium, palladium, zinc, cadmium, gold or brass, bronze, etc.; There are also diffuse layers, such as nickel-silicon carbide, nickel-fluoride and fossilite;

There are also cladding layers, such as copper-nickel-chromium layers on steel, silver-indium layers on steel, etc. In addition to iron-based cast iron, steel and stainless steel, the base materials of electroplating also include non-ferrous metals, or ABS plastics, polypropylene, polysulfone and phenolic plastics, but the plastic must be specially activated and sensitized before plating.