What should I do if my Cartier watch gets into the water and stops?

What should I do if there is fog in the water on the watchHow to deal with it:

If the water ingress is not serious, but there is a layer of fog in the surface glass, then you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the watch tightly, and bake it at a distance of 15 cm from a 40-watt light bulb for about 30 minutes to eliminate the moisture. Do not bake the glass directly near the fire, so as not to deform the glass by heating.

What should I do if there is fog in the water on the watchHow to deal with it 2:

Wear the glass inwards and the case outwards on your wrist and the moisture will be eliminated after two hours. If the water ingress is severe, it is best to immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

The solution to the water in the watch and the fog on the mirror:

Wrap the watch tightly with several layers of toilet paper or flannel cloth that is easy to absorb moisture, and bake it under the light bulb for about 30 minutes to eliminate the water mist inside, but do not put it close to the light bulb or bake it directly, so as not to cause the surface to be deformed by heating.

Wear the surface inwards and the bottom case outwards on your wrist to remove the mist from the surface after a few hours.

If you have silicone, you can put the silicone and the watch in water into a closed container, and after a few hours, take the watch out again, and the water mist in the watch will disappear.

If the water ingress of the watch is serious, it is best to send it to a watch shop to wipe the oil and eliminate the water in the watch to avoid rust on the parts of the watch.

Note: In order to prolong the service life of the watch, you should try to avoid fog and water droplets in the waterproof watch, do not wear the watch when washing your face, bathing, swimming and other "hydrophilic" activities, do not be affected by water vapor and hot vapor, and pay more attention not to be exposed to rain on rainy days.

Generally speaking, there are only three places where water can enter the watch movement: the handle (handle), the watch mask and the back cover. The waterproof device is also installed in these three places: add a rubber ring to the shank, add a rubber ring on the threaded edge of the back cover of the sealing ring, shank and other parts, and make the surface tight.

Water and fog into the watch has the greatest impact on the watch movement, and it should be dealt with in time to prolong the service life of the watch. If not treated in time, the residual moisture will easily cause the internal movement to oxidize and rust, resulting in inaccurate watch timekeeping and watch failure.

If the watch is seriously flooded, please send it to the repair center immediately for treatment, otherwise it will cause many metal parts inside the movement to oxidize and rust due to water vapor, causing greater damage.

Go to the after-sales service location for after-sales service, or go to the place where the watch is sold, there is generally a place for repair.

Water ingress into the watch may be a problem with the watch's glass, back cover, crown, and waterproof ring. It is recommended that you can open the warranty coupon attached to the purchase of the watch, under normal circumstances, there will be a service address on the warranty copy, or find a regular watch service center for testing and maintenance of the address of the store, etc., if there is a professional after-sales maintenance center nearby. For more information about watch repair questions and related information, you can click **Consultation or Dial** for consultation to provide you with professional watch repair services.

The most insured maintenance and repair will be handed over to the orthodox agency to dispose of the insurance. The cleaning of the interior must be handed over to a professional master, while the cleaning of the exterior is carried out by the owner of Cartier steel himself; Wash the strap with a soft brush dipped in liquid, and finally rinse with clean water. Cases with water-resistant function can also be liquidated in this way; Cases that are not water-resistant should never be brushed.

It is important to clean the exterior on a daily basis, because sweat, dirt, dust, etc., even if you are slightly unnoticed, actually continue to accumulate, and if you do not clean it, the Cartier strap will rust, erode or brittle, so it is best for the owner to wash it frequently.

1 3 Step by Step Reading.

The kinetic energy is insufficient, and the dynamic mechanical watch is to use the active Dazhi Kaidong of the arm to complete the winding. If the watch is left for too long or the amount of arm movement is less every day, the clockwork energy of the watch will be prone to inaccurate timing or night stop due to insufficient winding.

The hairspring is faulty, and the clockwork will be tighter if the amount of exercise is large. If there is a problem with the upper bar mechanism that causes insufficient power, it generally appears between 9 o'clock and 12 o'clock in the evening, "with a calendar function table" because at this time the hour wheel begins to drive the calendar wheel, and the load is large, if the power is insufficient, it is easy to stop during this time period. This time should not be reversed dial pin, now many mechanical watches use plastic parts of the calendar wheel, accidentally will break the gear, once the tooth is broken, every day at this time will be stuck, or to a fixed date will no longer jump.

Bump failure, the watch is a precision instrument, once the bump is violently vibrate, then the parts may fall off or damaged, and the watch can be stopped.

There are many reasons why this watch stops and goes, and there is no battery. In other words, if there is no power in the general situation, there will be no electricity, and they will not continue to move forward with the argument. Check it out to find out.

What should I do with my Cartier watch Zhou Ting, you Cong Zai This Cartier watch has two kinds, one is aggressive, and the other is a battery, yours must be a battery, and there is no battery in the hall.

What to do with a Cartier watch stop-and-go? Personally, I think that if this kind of watch stops now, you can check whether it is because there is no battery.

The discontinuation of Cartier watches may have been caused by a number of factors. It could be that the watch parts are damaged, worn, or need to be cleaned and lubricated. In addition, the watch battery may also need to be replaced.

The oscillation system components of the watch, such as the drum wheel, balance wheel, straight wire wheel, etc., may have some malfunctions due to their long-term maintenance and friction, resulting in the watch stopping. It is also possible that the watch movement casing may be covered with dirt or dust, which can cause the movement to clog and cause the watch to stop abnormally.

Therefore, in order to maintain the normal operation of the watch and prolong its life, regular watch maintenance and care are required. Regularly inspect the wear and tear of the parts of the watch and replace them at the right time. At the same time, the watch needs to be cleaned and lubricated to ensure that its components run smoothly without clogging.

In addition, the battery life of the watch also needs to be controlled to avoid the watch stopping due to excessive time.

In short, watches are precision mechanical crafts, which need to be maintained and maintained frequently to ensure their normal operation, timely replacement of parts, cleaning and lubrication of the movement, and the use of anti-wear technology are all important factors to ensure the stable operation of the watch. Carefulness, patience and attention to care are the best ways to preserve Cartier watches.

Summary. Hello.

The first is because of the lack of kinetic energy.

The second is due to a malfunction of the mechanical watch. Therefore, don't panic too much when you find that the mechanical watch is not leaving, and first distinguish which kind of big one it belongs to.

What to do if your Cartier watch suddenly stops?

Hello, the first missing key is silver resistance, because of the lack of kinetic energy. The second is due to a malfunction of the mechanical watch. Therefore, don't panic too much when you find that the mechanical watch is not leaving, and first distinguish which kind of big one it belongs to.

The reasons are as follows:1The power of the watch is insufficient, and the automatic watch only needs to be wound by the arm, but if you exercise less, or if you don't wear your watch for too long, the watch may not be able to run or stop directly due to lack of power.

Of course, you don't have to throw your arms as a hula hoop in order to wind your watch, just move normally. 2.If it is really caused by too little exercise, don't worry, you just take off your watch before going to bed and shake it horizontally for about 2 minutes, of course, you can also shake it for 4 minutes, because then it can go longer.

If your watch can be wound, you can also wind it clockwise. In order for your watch to last longer, it is recommended to have him wear it on your wrist for at least 6 to 8 hours a day. 3.

If the above two reasons are not the above, it may be the reason for the return to the hairspring. If you usually exercise too much, the clockwork will leak and the balance is tighter. If it is really a lack of power caused by the winding, usually between 9 and 12 o'clock in the evening, the "calendar function table" at this time his needle wheel began to drive the calendar wheel, the load is large, the watch is tired, at this time if the power is insufficient and no one pushes it, it is easy to stop.

During this time, don't reverse the dial, many mechanical watches have plastic calendar wheels, and if you are not careful, you will break the gears, if you break your teeth, you will be stuck at this time every day, or you will no longer jump on a fixed date. That's why the mechanical watch stopped. 4.

The parts of the faulty watch are very delicate and small, if you are careless and accidentally bump into it, or if you are healthy, you will bump it. This can easily cause the movement parts to fall off or break directly. All automatic watches must be worn or wound regularly in order to function properly.

If the mechanism stops working for a long time, it will cause the watch to deteriorate for a long time. Generally speaking, the power reserve of a large three-hand watch is probably no more than 38 hours, which means that if you do not wear the watch for more than 45 hours, the watch will eventually stop due to the exhaustion of the mainspring.