Does a 15 meter 3 storey factory need a high formwork solution?

Of course, this is needed, and only in this way can it be built higher and stronger.

In the case of a 15-meter three-story plant, a high-support formwork solution is required to construct it, and if there is no such plan, it is easy to cause loss of profit.

Project Overview. Project name: Haikou Tieqiao 110kV substation new.

Project location: north side of Yehe Road, Qiongshan District, Haikou City.

Structure type: pile foundation independent cushion cap, cast-in-place reinforced concrete frame structure, integral six layers (local three layers).

Floor area: square meters.

Project Overview: 1. Building height and number of floors:

1) A 6-storey building on the ground, with the first floor being 3 meters, the second floor being 5 meters, the third floor, and the fourth --- six floors.

2) Underground one layer of fire pool, fire pump room, floor height of meters.

2. Dimensions of columns, beams and plates:

The main cross-sections of the columns: 800x800, 800x1000, 500x500, 800x1200, the negative floor is mainly 300 thick shear walls, columns: 800x800, 800x1000, 900x900

Main cross-sections of the first floor beam: 300x900, 400x900, 300x800, 300x550, 200x500, 300x1000

Maximum cross-section of two-story beam:

Does a 15-meter three-storey factory need a high formwork support solution? Oh, you can go to this, ask specifically, and the architect will make the corresponding choice according to the structural design of the plant.

In this case, of course, the formwork support scheme is needed, and the scheme design must be reasonable in place before the construction can be completed.

If you don't know what the plan is, you can check it.

Does the 15-meter three-story factory need to be put in high formwork? This building is also relatively high, and it needs to be imitated by vocational high schools, and it needs to be paid and tortured.

Does the 15-meter three-percent factory need a high support scheme? I don't know what kind of solution this is.

High formwork. It refers to the formwork operation when the formwork height is greater than or equal to 8m.

Ministry of Housing and Urban-Rural Development. The construction quality [2018] No. 31 document "Provisions on the Safety Management of Dangerous Sub-project Projects" stipulates:

1. Concrete formwork support in the sub-project with greater risk.

Engineering: erection height of 5m and above; or erection span of 10m or more; or the total construction load is 10kn m and above; or concentrated line load of 15kn m and above; or concrete formwork support projects whose height is greater than the width of the support horizontal projection and are relatively independent and have no connecting components.

2. Concrete formwork support project in the sub-project with greater risk of exceeding a certain scale: erection height of 8m and above; or erection span of 18m and above, or construction total load of 15kn m and above; or concentrated line load of 20kn m and above.

Note: Sub-projects with greater risk than a certain scale need to be demonstrated by experts.

The tall formwork support system refers to the formwork support system of the concrete component formwork at the construction site of the construction project with a support height of more than 8m, or an erection span of more than 18m, or a total construction load of more than 15kN, or a concentrated line load of more than 20KN.

More than 8 meters is a high formwork, which needs to be demonstrated by experts.