Videojet 43S printer charging failure

To be precise, this fault is not really a charging fault, but because it can be printed and the quality is normal. Specifically, the phase is not detected, and the phase is not detected, generally for the following reasons:

One: Phase may be broken and cannot detect charging. Please check the distance between the phase detection head and the ink line, whether it is very far away. Also, if there is a condition, you can use a meter to measure whether its voltage is normal.

2: Please make sure that the 15-core wire is intact, especially the four lines of brown, red, orange and silver with a meter.

Three: There is no problem with the above two points, then it is the last item, your IO board is broken. It would be nice to replace the IO board.

There are several reasons why the Videojet 43S printer reports a charging failure:

1. The ink dot modulation value is not selected properly, that is, the ink line breakpoint is not good.

2. There is ink on the phase detector, or the phase detector does not detect well.

If there is still ink leakage, the problem is not solved after cleaning and drying the nozzle, which means that the nozzle is blocked, if the nozzle is blocked, and then it will cause the breakpoint to be bad, I don't know if the method of cleaning the nozzle is correct, if the nozzle is blocked can not be completely solved, then the problem you said will exist repeatedly. I hope it will be helpful to you.

It must be that the phase detection is not good, it cannot be detected, it is possible that the phase detection is not good, it is also possible that the phase charging is not good, or the ink line is a little far away from the phase detection, you can try to scrape off the blade of the silicone for phase detection, try to see if the silica gel for phase detection is corroded by solvent.

Go to the modulation level settings and turn off the charging fault, and there will be no problem, so you don't have a problem.

There are several reasons why the Videojet 43S printer reports a charging failure:

1. The ink dot modulation value is not selected properly, that is, the ink line breakpoint is not good.

2. There is ink on the phase detector, or the phase detector does not detect well.

If there is still ink leakage, the problem is not solved after cleaning and drying the nozzle, which means that the nozzle is blocked, if the nozzle is blocked, and then it will cause the breakpoint to be bad, I don't know if the method of cleaning the nozzle is correct, if the nozzle is blocked can not be completely solved, then the problem you said will exist repeatedly. I hope it will be helpful to you.

There are several reasons why the Videojet 43S printer reports a charging failure:

1. The ink dot modulation value is not selected properly, that is, the ink line breakpoint is not good.

2. There is ink on the phase detector, or the phase detector is not good at detecting the rejoicing.

If there is still ink leakage, the problem is not solved after cleaning and drying the nozzle, which means that the nozzle is blocked, if the nozzle is blocked, and then it will cause the breakpoint to be bad, I don't know if the method of cleaning the nozzle is correct, if the nozzle is blocked can not be completely solved, then the problem you said will exist repeatedly. I hope it will be helpful to you.