Can you fix your Tissot watch if it gets into water, and what should I do if my Tissot watch gets in

The watch must be dealt with in time after it gets into the water, and the following is the following method, you can refer to it.

Method. 1. If the watch is soaked in water, you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the watch tightly, put it near a 40-watt light bulb about 15 cm, bake for about 30 minutes, and the water vapor in the watch can be moisture. Do not bake the watch close to the fire, so as not to deform the watch by heat.

Method. 2. Put the surface face inward, the bottom shell facing outward, and wear it on the wrist, and the water vapor can be eliminated after two hours. If the water ingress is severe, it is best to immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

Method. 3. Put the granular silicone into a closed container with the watch that has accumulated water, and after a few hours, take out the watch, and the water will all disappear. This method is simple and economical, and there is no damage to the accuracy and longevity of the watch.

The silica gel that has been absorbed many times can be dried at 120 degrees for several hours, and the water absorption capacity is renewable, and it can be used again and again.

The first method: baking with an incandescent lamp.

Wrap the watch with several layers of paper towels, then place it at 15 cm of a 40-watt incandescent lamp, and bake for 5 minutes, and the water vapor in the watch will be evaporated. Remember not to bake for too long, and for watches with leather straps, the strap should be removed first.

The second method: put it together with the desiccant.

The water absorption effect of desiccant is much better than that of rice, put the watch and desiccant together, wrap it in plastic wrap, wait for 24 hours, and it will not cause dust pollution.

The third method: put it in rice.

Rice has a good water absorption effect, and every family has rice, and it is easy to use. After 24 hours of placing the watch in the rice, most of the water is absorbed. Finally, take out the watch and gently wipe off the rice dust.

The fourth method: reverse the watch.

In order not to disassemble the watch, you can wear the watch upside down, wear the watch glass on your arm, and discharge the water vapor in the watch little by little.

There is fog in the watch, which means that there is moisture in the watch. In general, although the watch is hermetically sealed, there are very small pores in the joints of the case, especially in used watches.

When washing hands or washing clothes or on rainy days, water can enter through these pores, especially the hot steam in the kitchen, which is more likely to soak into the case. In addition, the temperature is high and the humidity is high in summer, so if the watch is suddenly cold, the air containing more moisture in the watch will condense into mist or water droplets, which will stick to the watch glass.

If water enters the watch, please send it to the repair center immediately for treatment, otherwise it will cause many metal parts inside the movement to oxidize and rust due to water vapor, causing greater damage.

There are several phenomena or degrees of water ingress into the watch:

1) There is fogging in the glass of the watch, and there may be some times and sometimes not, especially when the temperature difference is large;

2) There are water droplets condensed in the watch glass;

3) A large number of water droplets can be seen on the glass and dial of the watch;

If you find that the watch is flooded, it is imperative to send the watch to the watch repair shop for drying as soon as possible, and if the water is serious, it is necessary to do oil washing. If you don't do it in time, then the water will make the steel parts in the watch movement embroidery, and the tiny clock parts usually need to be replaced once they rust, and the repair cost in the future will be very large, you must know that the damage to the watch by water is "catastrophic". In addition to the movement parts, long-term contact with water vapor will also cause discoloration, blistering and rust of the watch dial and watch hands.

Here, I would like to remind you that if it is a watch with repeated water ingress, you need to pay extra attention when wearing it.

Water in the watch is a more serious thing, especially some high-end mechanical watches, if not repaired in time, then the water will make the steel parts in the watch movement appear embroidery, tiny clock parts usually need to be replaced once rusty, the future repair cost will be very large, to know that the damage to the watch is "catastrophic". In addition to movement parts, long-term exposure to moisture can also cause discoloration, blistering and rust on the dial and hands of the watch.

The watch maintenance center is located in Room 3705, 37th Floor, Block 2, Ganghui Henglong Plaza, No. 3 Hongqiao Road, Xuhui District, Shanghai 021-80184441

Small pieces of calcium chloride can be directly wrapped with gauze; Then take out the watch cover and put the calcium chloride wrapped in gauze and the electronic watch seal into a plastic bag and box. After waiting for half a day, you can take out the watch, and you can see that the moisture of the electronic watch disappears. If the water ingress of the watch is serious, it can be left for a day.

Wear the watch backwards. You can also put the mask facing inwards and the bottom shell facing outward, and wear it on the wrist backwards, and the moisture can be eliminated after two hours. If the water ingress is severe.

Send it to the watch shop to wipe the oil. None of the above two methods can remove the moisture, so you should immediately send it to the watch shop to wipe the oil and remove the moisture from the movement to avoid rust on the parts.

If you have any questions, please feel free to send me a private message.

If you find that the watch is flooded, you can use several layers of toilet paper or flannel cloth that is easy to absorb moisture to wrap the watch tightly, put it about 15 cm near a 40-watt light bulb, and bake for about 40 minutes, and the water vapor in the watch can be eliminated. Do not bake the watch directly near the heat, so as not to deform the glass by heating. Because although there is no moisture on the dial, there may still be water in the movement, and the movement will rust and cause damage to the movement after a long time.

After the watch is flooded, it is recommended to find a professional repair outlet as soon as possible for the master to check and deal with it, which can reduce your unnecessary losses.

The solution to the water in the watch and the fog on the mirror:

Wrap the watch tightly with several layers of toilet paper or flannel cloth that is easy to absorb moisture, and bake it under the light bulb for about 30 minutes to eliminate the water mist inside, but do not put it close to the light bulb or bake it directly, so as not to cause the surface to be deformed by heating.

Wear the surface inwards and the bottom case outwards on your wrist to remove the mist from the surface after a few hours.

If you have silicone, you can put the silicone and the watch in water into a closed container, and after a few hours, take the watch out again, and the water mist in the watch will disappear.

If the water ingress of the watch is serious, it is best to send it to a watch shop to wipe the oil and eliminate the water in the watch to avoid rust on the parts of the watch.

What should I do if my watch gets water?

1. If the watch is soaked in water, you can wrap the watch tightly with several layers of toilet paper or flannel cloth that is easy to absorb moisture, put it at about 15 cm near a 40-watt light bulb, and bake it for about 30 minutes, and the water vapor in the watch can be eliminated.

2. Put it in a rice jar and bury it deep in the dried rice for a period of time, if it is fast, you can see obvious results in one night.

3. You can use a granular substance called silica gel to put it into a closed container with the watch that has accumulated water, and after a few hours, take out the watch, and the water will disappear.

4. Take a hair dryer to dry, and then apply a layer of transparent nail polish on it to avoid impurities and prevent rust.

5. If there is water vapor in the watch, you can wear the watch face inward and the bottom shell outward, and wear it on the wrist to eliminate the water vapor in two hours. If there is too much water in the watch, the case must be opened and scrubbed. If you are not sure to deal with it yourself, you should send it for repair in time.

Water into the watch Generally, there is water mist or water droplets on the watch glass, which will corrode the movement after a long time, resulting in inaccurate or non-time, so the earlier the watch water ingress treatment time, the less damage to the movement, the recommended treatment method is as follows:

Law. 1. Place the vent - dry the watch with a dry paper towel and then place it in a cool and dry vent for a few hours, and do not place the watch directly in the sun or dry, which is to prevent water mist from flowing into the movement.

Law. 2. Silicone drying - for the water inlet of the mechanical watch, you can use the granular substance of silica gel to absorb water, put the two in a closed container, and take it out after a few hours, and the water mist inside will be cleaned up; If it is a quartz point clock, you can take a few small pieces of calcium chloride, wrap them in gauze, and then open the electronic watch cover and seal it.

Law. 3. Wipe oil and remove rust - method 1 and method 2 can only clear a slight water mist, and for some more serious water ingress, these two work earlier, which is not enough for the rescue time of the movement, at this time it is best to find a professional watch repair center for ** maintenance, oil wiping treatment.

Hello, yes.

Way. 1. If the watch is soaked in water, you can use several layers of toilet paper or fluffy cotton cloth that is easy to absorb moisture to wrap the watch tightly, put it near a 40-watt incandescent lamp about 15 cm, bake for about 30 minutes, and the water vapor in the watch can be water vapor. Avoid baking the watch on the wrist close to the fire, so as not to cause the watch to suffer thermal deformation.

Way. 2. The watch is worn inwards and the bottom case outward, and the water vapor can be eliminated after two hours. If the water ingress is severe, it is best to send it to the watch shop immediately to wipe the oil and sweep away the nutrients of the movement to prevent the parts from rusting.

Way. 3. Use granular silicone to put the watch on the wrist that has accumulated water into a tightly sealed utensil, and after a few hours, take the watch on the wrist, and the water will disappear. This method is simple and economical, and there is no damage to the accuracy and longevity of the watch.

The silica gel that has absorbed water many times can be dried at 120 for several hours, and the water absorption experience is renewable, and it can be used again and again.

Friends who wear watches often must have heard of this Tissot watch, right? With Swiss roots, he is an innovative brand. There are many people who like this watch, and his spokespeople include:

Xu Xiyuan, Huang Xiaoming, fairy sister Liu Yifei? What should I do if such a world-famous watch accidentally gets into the water?

If your Tissot watch gets into the water, you can use our toilet paper at this time, or a flannel cloth that easily absorbs moisture, and then wrap the watch tightly, bake it for about 30 minutes on a light bulb of about 40 watts and a distance of about 15cm, and the moisture in the watch can basically be eliminated.

I don't know if you have heard that rice can remove moisture, we can put the watch in the rice jar and bury it in the middle of the rice, if it is fast, you can see obvious results in one night.

You can use a kind of silicone granular substance and put the watch in an airtight container, and after a few hours, take out the watch and the water will disappear!

The stupidest way is to use a hair dryer to dry, but be sure to apply a layer of transparent nail polish to avoid impurities and prevent rust.