How do you install a drill bit in an IKEA drill?

IKEA. The steps to manually install the drill bit of the electric drill are as follows:

1. The hand drill must be installed to play a normal function, if the head is not interrupted or the drill bit is not installed correctly, it is easy to be dangerous in the process of use.

2. Disconnect the power supply of the flashpad and unplug the power cord of the flashmaster from the socket.

3. Hold the hand drill tightly, pinch the gourd mouth of the hand drill and rotate it forcefully to expose the hole with the drill bit.

4. Take out the drill bit to be installed, place it on the empty space exposed at the front end of the hand drill, and rotate the drill bit clockwise by hand to jam the drill bit.

5. Adjust the depth position of the stuck drill bit into the hole, and tighten the lock in the clockwise direction with the special key.

6. Plug in the power cord plug of the hand drill, turn it for two seconds after powering on, and observe whether the drill bit of the hand drill is installed firmly.

First, rotate the bottom circle to the screw mark, and then adjust the top two small circles in opposite directions to fix the drill bit. Or hold the black circle of the drill bit in one hand, and grasp the big one on it with the other hand, and twist it in the opposite direction to clamp or loosen the drill bit. The round black button on the handle is for protection.

The one inside is used to adjust the speed.

The first step is to disconnect the power supply of the flashpad and unplug the power cord of the flashpad from the socket.

The second step, put on gloves on both hands, hold the hand drill tightly with one hand, pinch the mouth of the hand drill hoist with the other hand, rotate hard, so that the hole with the drill bit is exposed, if the front end of the hand drill has a circle of teeth, twist it with a special key of the configuration, and loosen the hole to expose the drill bit installation.

The third step is to take out the drill bit to be installed, place it on the hole exposed at the front end of the hand drill, and rotate the drill bit clockwise by hand.

Fourth, adjust the depth position of the stuck drill bit into the hole, and twist the lock in a clockwise direction with a special key.

Step 5: Plug in the power cord plug of the hand drill and turn it idle for 2 seconds to observe whether the drill bit of the hand drill is installed firmly.

This is a keyless tightening drill chuck, which can be tightened by hand when installing the drill bit.

This is a keyless tightening drill chuck, and you can tighten it with a hand when installing the drill bit.

1. Disconnect the power supply of the flashpad and unplug the power cord of the flashpad from the socket.

2. Put on gloves on both hands, hold the hand drill tightly with one hand, pinch the mouth of the hand drill hoist with the other hand, and rotate vigorously to expose the hole with the drill bit.

3. If there is a circle of teeth at the front end of the hand drill, twist it with a special key.

4. Take out the drill bit to be installed, place it on the hole exposed at the front end of the hand drill, and rotate the drill bit clockwise by hand.

5. Adjust the depth position of the drill bit into the hole position and the ridge state, and use the special key to tighten and lock it in the clockwise direction.

6. Plug in the power cord plug of the hand drill and turn it idle for two seconds to observe whether the drill bit of the hand drill is installed firmly.