Is there any good way to clean the urine alkali in the toilet?

As there is not a side in front and cannot be knocked along the edge, it is more troublesome to change the taper to the urine alkali in the waterproofing bend.

Heat it over the fire and make a hook to clean it up. Remove it and then use neutral glass glue.

Put the toilet in the new place. These three cones were made the last time I cleared the toilet. If it is stained, there will be white spots on the clothes; Sulfuric acid is highly corrosive, and the state strictly prohibits buying and selling; Hydrochloric acid, glacial acetic acid.

It is also a corrosive chemical and is not recommended. and absolute ethanol.

That is, the alcohol we usually use, the effect is good, and it is safe to use.

<> hydrochloric acid has a good cleaning effect on urine scale, but there is no corrosion on the ceramic glaze, just drain the water before the toilet bend as much as possible, pour hydrochloric acid, cover the toilet lid, soak for 10-15 minutes, and then flush several times. I tell you that you don't need too much of a bottle cap to pour the toilet with 84 disinfectant, and after a while, you can use a brush, which is very clean, economical and easy to use.

Since you have chosen to rent it out, you don't need it yourself. It doesn't matter if you continue to rent it, or you can replace it with a new one, and the cost will be added to the rent. I have a local way, buy a watermelon, and eat it with a red husk.

Scrape off the green pulp, pour it into the toilet, soak it for 24 hours, then flush it off with water, and use a toilet brush to easily clean it. If there are still stubborn traces, you can soak them again.

Use an unwanted towel, blot the water inside (to occupy the water many times, wring it out, and occupy it again), then add hydrochloric acid, soak it for ten minutes, and then brush it with a brush, pay attention to wearing masks and plastic gloves, one to reduce the pungent taste of hydrochloric acid, and the other is to avoid hydrochloric acid on your hands to prevent burns.

Formerly brass. Foundry! The wire of the electric furnace is often blocked!

You go and buy a kind of stuff called descaling online! Come back and boil it with boiling water! Soak the drain for half an hour!

Just wipe it clean and you're clean! This thing cleans all grease! Especially the fouling stuff!

Oxalic acid, which is sold in many chemical stores, can also be sold in white vinegar. Soak it for a day and you can get it down, bring plastic gloves and wipe it with a cleaning ball, it's very clean.

Pour the mixture of vinegar and water into the toilet, soak for half a day, the urine alkali in the toilet will be brushed off, after brushing the toilet, spray the white vinegar on the inside of the toilet, keep it for a few hours and then flush it off with water, which can have the effect of disinfection and deodorization.

The urine alkali in the toilet bowl is difficult to clean, we can take the toilet bowl cleaner, or put some white vinegar and baking soda to neutralize the acid and alkali, or buy some oxalic acid or dilute hydrochloric acid and other acidic substances to clean it.

You can choose a more professional toilet cleaner in the supermarket, you can use more dosage for stubborn stains, and you can also use it with a scraper, so that it can be cleaned well.

You can use Coke, just pour it in, or you can use a toilet cleaner to brush it inside and out, in fact, every time you get it, you should clean it up, so that it will not form stains. You can also use some baking soda.

Vinegar is acidic and can dissolve alkaline precipitates. Frequent flushing with vinegar and baking soda and soaking the toilet bowl can be cleaned quickly, and the macula will not produce urine alkali in a short time.

You can pour the unfinished cola into it, soak it overnight, rinse it with water and clean it, sprinkle the toilet cleaning product evenly into the toilet, and wait for an hour or two to clean it.

You can buy a special cleaning agent that removes water alkali, which can be dissolved quickly when placed in water, and then scrubbed with a brush.

I believe we all know that if the toilet is not cleaned for a long time, a large amount of urine alkali is often attached to the inside. So the question is, how to remove urine alkali from the toilet? Let me find out.

How to remove urine alkali from the toilet.

1. Open the toilet cover, prepare a bottle of toilet cleaner, brush and 1 basin of water, and spray the toilet cleaner evenly on the inner wall of the toilet, taking care not to leave dead corners, and spray all in place.

2. After spraying, do not clean it immediately, but should cover it and wait for one to two hours.

3. After one to two hours, gently open the lid of the toilet, at this time you will be pleasantly surprised to find that the urine alkali on the inner wall has been completely dissolved, as long as you use a brush to gently scrub inside, pay attention to the process of brushing should wear a mask and gloves, after all, the smell of toilet cleaner is still relatively unpleasant, and direct contact is not good.

4. Brush all over with a brush, and wipe the position where you can't brush it with a soft towel, and after brushing the inside, wipe the exterior clean by the way, and dry it after wiping it off for normal use.

Toilet daily maintenance methods.

1. We clean the toilet at least once a week.

2. If the water source in our area is hard water.

Then it is even more important to keep the water outlet clean.

3. Frequent turning of the toilet seat will cause the fastening gasket to loosen, and we need to use a screwdriver.

to tighten the cover nut.

4. In daily life, it is forbidden to knock and step on the sanitary ware.

5. Do not close the toilet seat too fast.

6. When the detergent is poured into the toilet, the lid should not be covered immediately, but should be rinsed and then closed.

This article and **** on the network, do not bear any legal responsibility.

The urine alkali in the toilet bowl can be removed with vinegar mixed with cold water, first pour vinegar and cold water into the toilet, soak for half an hour and then brush off the dirt with a brush. You can also go to the supermarket to buy a toilet cleaner, and then buy a toilet brush, and stir the toilet clean with water a few times after you go back, don't add too much water, there will be bubbles, pour it on the urine stains, and brush it with a brush It is easy to come down.

You can buy a professional remover, or pour some white vinegar and baking soda into the toilet, or you can directly use toilet cleaner, which can effectively remove the urine test of the toilet bowl; White vinegar, baking soda, toilet cleaner, oxalic acid, automatic toilet cleaner, etc. can effectively reduce the production of uric acid.

You can pour in some baking soda and detergent, you can pour in some cola, you can put in some disinfectant, so you can remove it. You can put cola, baking soda, detergent, disinfectant, chemicals.

1. Pour white vinegar into the toilet wall first, the concentration should be higher, and then pour in baking soda, at this time, the white vinegar will have a chemical reaction when it meets baking soda, soak for about half an hour, and use the toilet brush to scrub the urine alkali on the toilet wall, which can easily dissolve the urine scale.

2. You can also use hydrochloric acid, but do not pour it directly into the toilet, you need to dilute it with water, and then through cola, these are acidic solutions, which can be neutralized with urine alkali to achieve the effect of quickly removing urine scale.

Precautions for using the toilet

1. When flushing, you should develop the habit of covering the toilet lid, if the toilet lid is opened to flush, the cyclone can flush germs or bacteria into the air at a height of six meters, which will be suspended in the air, and the bacteria will fall on the walls and toiletries. Therefore, it is necessary to get into the habit of closing the toilet seat when flushing.

2. The dirt in the toilet bowl should be cleaned in time, especially the toilet is easy to be contaminated with urine stains, feces and other dirt, if you find that there is still residue after flushing, you should use the toilet brush to clean the inside in time, it will be easy to form macular stains and mold, which will bring harm to human health.

3. Many people feel that if they throw toilet paper into the toilet, it is easy to cause the problem of toilet blockage. In fact, the paper softens quickly in the water, so there is no need to worry about the clogged toilet.

Wait until the liquid level does not rise as the amount of hydrochloric acid poured increases. It can be seen that there are small bubbles on the liquid surface, indicating that hydrochloric acid has reacted with urine alkali. Soak overnight, and then rinse with a pot of boiling water the next morning, and there is no trace of urine alkali.

I tried to poop once, snorted, and washed clean. If the urine alkali is too thick, it must be removed with strong acid, which can be neutralized with dilute hydrochloric acid, dilute hydrochloric acid and alkali; Remember not to use strong hydrochloric acid, which is too acidic and can easily corrode sewer pipes. The flush toilet produces yellow dirt, which is difficult to clean with a brush, so you can tie the waste nylon socks to one end of the stick, dip it in foaming detergent and scrub it, and clean it once a month to keep the toilet bowl white.

The carbonic acid in cola can react with urine alkali to form salt that does not adhere easily, as long as you pour the cola in a place with urine alkali and soak it overnight, it can be easily washed away the next day. Using a metal brush, it can be easily brushed clean, so the acid toilet cleaner is used in the bathroom to remove the stubborn urine alkali at the bottom of the toilet, after a period of time, it is very laborious, and the acid toilet cleaner is evenly sprayed on the stubborn urine alkali at the bottom of the toilet.

If you are renting or buying a second-hand house that is no longer decorated, it is recommended that you clean it thoroughly, spray the toilet inside and outside with 84 disinfectant, let it stand for a period of time, use a rough cloth or a wire brush to wipe it gently, and then clean it again with a toilet cleaner. If it doesn't come down, use white vinegar or pickling. Wait a few moments to rinse off and stay as clean as new, oxalic acid is available online**.

If there is no oxalic acid, edible vinegar can also be used instead, but the effect is slow and long, and even needs to be repeated several times. The principle is to use the neutralization chemical reaction of acid and alkali to achieve alkali spot removal. Hope it helps.

It is best to find a way to dry the water at the bottom of the toilet first, spray it evenly on the stubborn urine alkali at the bottom of the toilet bowl with an acidic toilet cleaner, wait for 3-5 minutes, and then brush it with a toilet brush, and it can be easily brushed clean. I hope my answer can help you.

It is best to use oxalic acid to wash it first to neutralize the acid and alkali, so that the urine alkali can be easily washed off.

Tips: Pour the mixture of vinegar and water into the toilet, soak for half a day, the dirt will be brushed off, after brushing the toilet, spray the white vinegar on the inside of the toilet, keep it for a few hours, and then rinse it off with water, which can have the effect of disinfection and deodorization.

You can sprinkle baking soda in the toilet, add a little white vinegar, soak it in warm water for a while, and then use the toilet brush to scrub and clean it, and you're good to go.

1. White vinegar method Because vinegar is acidic, and the odor factor of the toilet is alkaline, when the two meet, a neutralization reaction will be produced, which will achieve the effect of removing odors, and vinegar also has the effect of sterilization and decontamination! All we have to do is put the white vinegar in the mineral water bottle, then poke a few small holes under the bottom of the water bottle, and then place the bottle in the tank normally. Every time you flush the water, some of the vinegar will flow out of the water and mix it in the water to flush the toilet bowl together.

That's what we're trying to do. Very clean. You can use a toilet cleaner to brush the area around the toilet bowl, so that it is not only clean on the inside, but also on the outside.

It not only avoids the yellowing of the inner wall of the toilet, but also effectively deodorizes.

2. Buy toilet cleaner.

At present, the toilet cleaner on the market can be removed, pour it directly on the toilet, soak it for a few minutes, and then brush it off with a brush.