What is the content of the second subject of the car driver s license test?

Includes five items:

Reversing into storage. Candidates need to find the right spot, pour in from one side and drive out to the other side, and then pour in once from the other side.

Requirements: do not press the line on both sides and the rear side of the car, and the front of the car can not be outside the warehouse.

2.Side parking.

Candidates need to let the car drive sideways into the parking space, and they need to pull the handbrake to release the handbrake.

Requirements: Do not press the line on both sides of the car.

3.Curve driving.

Just use the front of the car to pass along the road.

Requirements: Do not crimp the line.

4.Right-angle turns.

After looking at the point, you can pass by slamming the direction.

Requirements: Do not crimp the line.

5.Fixed-point parking and ramp start on the uphill road.

Be sure to pay attention to the location of the fixed park, if the parking position is not accurate, you will be deducted points. When starting, pay attention to find semi-linkage, and never turn off the fire. Remember to pull the handbrake and release the handbrake.

Requirements: Pay attention to the position of the front and back, left and right, and do not slip and turn off the engine.

Hello Subject 2 is mainly uphill start, right-angle turn, S bay walking, side parking, reversing into the garage and so much more.

The content of the second subject of the automobile driver's license test is to have side parking on the inner road, starting on a slope, right-angle bend, S road, curve driving, reversing into the garage, etc.

Section 2 compulsory test items: reversing into the garage, side parking, fixed-point parking and half-slope starting. Other lottery items: S corner driving, right-angle turns, etc. are all very simple.

The test content of the driver's license subject 2 includes reversing into the garage, stopping and starting at a fixed point on a ramp, turning at a right angle, driving on a curve and parking on the side.

There are 5 items in total. 1. Reversing into the warehouse, 2 measuring square parking, 3 right-angle turns, 4s turning, 5 ramp starts.

If it is a C1 driver's license, it is a reverse garage, a slope, S road, and a right-angle turn when parking on the side.

Subject 2 exam items include:Reversing into the garage, side parking, ramp fixed-point, right-angle turning, and curve driving are five compulsory tests

Reversing into storage.

First, drive the test car outside the designated area, stop and adjust the mentality, because it is not time outside, and it is not illegal, and after the adjustment, we will drive the car into the test area of the reversing warehouse.

1. Remember that there is a longitudinal stringing and horizontal stop (these two things will directly affect your results, and these two things are very easy to do).

2. After the completion of longitudinal threading and transverse parking, play a circle to the right, walk forward about 1 meter to stop and then pull the reverse gear, the reversing into the warehouse officially begins, and the whole process of reversing and warehousing must be completed within 210 seconds. Control the speed of the car, keep an eye on the right mirror, and remember to adjust the method of wide and narrow back. After entering, through the reflector, the body is parallel to the line, quickly return to the right, and stare at the lower edge of the right reflector and the upper left line to stop the car.

Side parking

1. When entering the test area, you should thread longitudinally and park horizontally.

2. After entering the park, stop the car, play a circle to the right to hang the reverse gear, look at the left reflector, see through the mirror that the left rear rear car tail and the right rear library angle form a straight line, and then quickly turn the steering wheel back to the right, and then through the left reflector, you can see the left rear tire, the car tire crimped line quickly to the left full, go inside through the reflector to see the body and the line parallel parking.

3. Turn on the left turn signal at the exit, stare at the left corner and take the left yellow line to quickly return to the right, and then pass the highest point of the wiper or take the left yellow line to quickly turn to the right.

The ramp stops at a fixed point to start

1. Before going uphill, it is best to aim the car at the parking area and drive over, so you don't need to adjust too much on the slope;

2. After parking, the distance between the wheels and the side line should be within 30cm, and the front of the car should be in the yellow line area;

3. Start again, slowly lift the clutch to semi-linkage, and start naturally without rolling and turning off.

Curve driving.

1. The front of the car is facing the entrance of the curve slightly to the right side line.

2. When the upper left corner of the front of the car and the right sideline are about to collide, make a circle of the steering wheel to the left and add 1 to 4 circles, keep the upper left corner of the front of the car always along the right sideline, and adjust the direction at a small angle at any time when there is a deviation.

3. When the upper left corner of the front leaves the right sideline and is about to collide with the left sideline, turn the steering wheel back to the right.

4. When the upper right corner of the front of the car is about to collide with the left sideline, make a circle of the steering wheel to the right and add 1 to 4 circles, keep the upper right corner of the front of the car always along the left sideline, and adjust the direction at a small angle at any time when there is a deviation.

5. After the front of the car exits the corner, observe the left rearview mirror, and when the rear wheel of the left car is about to be parallel to the left sideline, return to the right direction and drive out of the corner.

Right-angle turns.

1. Enter the right-angle turn, control the speed, and have longitudinal threading before entering, which is subject to about 30cm between the body and the right sideline.

2. The longitudinal check number should turn on the left turn signal, and the computer says: "right-angle turn" and turn off the turn signal artificially.

3. When the left rearview mirror is parallel to the horizontal line at a right angle, quickly fill it to the left.

4. When the car turns around, you should quickly turn the steering wheel back to the right and walk out.

1. Reversing into storage:

Reversing into the warehouse is more practice in the course of the subject 2 exam, and it is also a subject that students think is more difficult in the subject 2 exam. Before preparing to enter the garage, the trainee can look at the garage sideline from the rearview mirror to determine the angle of the steering wheel when reversing. The body should be kept meters to meters away from the sideline, and the front of the car should start to reverse slowly with infrared light.

The vertical lining of the triangular window on the right side of the rear door should coincide with the upper right corner of the yellow edgeline, and the direction can be reversed into the garage.

2. Side parking:

Side parking is a more commonly used technology in the daily driving process, the vehicle is driven to the front of the garage parallel to the forward direction, and then reverses to the right rear into the garage, there can be no pause in the middle, as long as the side parking in this range does not pass the edge of the storage position, it is considered to pass. It is important to note that you will fail the stop-in test.

3. Fixed-point parking for uphill start:

When the car is parked on the ramp, in order to prevent the car from slipping, the handbrake will be tightened, and then the process of starting acceleration and passing the ramp in the ramp is the test of ramp start. Points will also be deducted for slipping.

4. Right-angle turning:

When making a right-angle turn, you need to control the speed of the car, use low speed according to the prescribed driving route, and make a 90-degree sharp turn through the right angle without stopping. If you fail to turn a corner, or if you stop the engine in the middle of the game, you will be deducted points. When turning at a right angle, pay attention to the angle of the car and try to stay on the side of the road, so that it is easy to pass.

The second subject of the driving test is the field test, which generally tests the reversing into the garage, side parking, ramp starting, curve driving, etc.

Subject two, also known as the road test, is a part of the motor vehicle driver's license assessment, is the abbreviation of the field driving skills test subject, the car C1C2 test items include reversing into the garage, side parking, ramp fixed-point parking and starting, right-angle turning, curve driving (commonly known as S bend) five compulsory tests.

Reversing into the garage, S bay, side parking, right angle, and slope up, a total of five projects, I hope you pass through it at one time.

For the second subject of the driving test, the current content of the test is still the reversing into the garage, as well as right-angle turning, side parking, half-slope starting, and curve driving, these items.

The following is the content of the second subject of the driver's license: roll-resistant 1, reversing into the garage: in order to investigate the driver's ability to operate the car on the spot, reversing into the garage is an assessment point in the driver's test, that is, in the movement to manipulate the vehicle from both sides of the correct reverse into the garage; 2. Side parking:

Side parking is becoming more and more common in the city, especially in the conventional parking spaces, which are more tense, and many places have become parking spaces on both sides of the original street, becoming "side parking spaces"; 3. Ramp fixed-point parking and starting: ramp fixed-point parking and starting is an assessment point of subject two in the driver's test, and the test requires parking at a fixed position on the ramp with a slope of 10% and a slope length of 30 meters in Changwu, and the coordination and cooperation of the direction, braking and clutch are investigated; 4. Right-angle turn: Right-angle turn is an assessment point of the second question of the driver's test, which is used to assess the driver's ability to correctly control the steering when driving the vehicle in a sharp turn section, and accurately judge the difference between the vehicle and the outer wheel; 5. Curve driving:

Curve driving is the assessment point of subject 2 in the driver's test, commonly known as the S-bend, and the test requires the vehicle to drive on the specified S-shaped road width, not to squeeze the road edge line, and to use the direction freely.