Do you need to scrape putty at the back of the cabinet?

Door-to-door installation of furniture cabinets, after the overall interior decoration is completed. When decorating the wall, it is impossible to follow the area of the cabinet, and the wall behind the cabinet will not scrape putty.

Finish. I have never heard of such a decoration, decorate the wall according to the order of the process, and install the common cabinets at home are the finished cabinets. The so-called finished cabinet here is the cabinet we buy directly from the furniture store, and then put it directly where we need to place the cabinet.

<> according to the situation, it is still necessary to do a certain treatment, such as the wall near the bathroom to make a wardrobe, it needs to be waterproofed, so as not to affect the service life of the wardrobe due to water seepage in the future. Other dry places should come how to come, scrape putty or not, there is nothing to start the first leveling, everything that can be seen from the outside, except for the part in the middle of the door, everything else must be scraped into white or gray. Basically, after the completion of the carpentry ceiling, it can be seen outside the indoor kitchen and bathroom.

Now we will communicate with customers about the location of the cabinet that needs to be installed, close to the bathroom and kitchen wall, we will first brush the waterproof 2-3 times, and then use water-resistant putty powder.

Batch twice, no polishing or painting. It can effectively prevent water seepage, and can adsorb a certain amount of moisture, other special materials, of course, there is no need to scrape any putty, if the wood appliance material is scraped with putty, and the surface is sprayed with glossy paint, it will be a good protection of its service life, and now most of the wood appliances on the market are scraped putty and processed perfectly.

If the partition wall of the cabinet is a bathroom, the designer will also ask the owner whether the wall on this side of the cabinet needs to be brushed with waterproof paint on the premise that the bathroom is waterproof.

Prevent the wall from being damp and affect the life of the cabinet. When decorating, as long as we make cabinets on site, the back is generally not painted, and there is no problem. But it's okay to do it the other way around.

Tiles are generally pasted in common areas such as living rooms, balconies, kitchens, and bathrooms. The tiles are directly plastered on the wall, and there is no need to apply putty powder.

Need. Scraping putty is for aesthetics, but also waterproof, the back of the cabinet needs to be scraped putty, because sometimes you will change the decoration of the home, you will move the cabinet, if you say not scrape, it will look unsightly.

Putty is needed behind the cabinet, because scraping putty is a decoration, and it is not easy to carry out a decoration. The cabinet is often moved, and if the putty is not scraped behind the cabinet, it will have to be renovated at that time.

I think it is still necessary to scrape putty, because in this way to ensure the beauty of the interior, and the putty can also effectively prevent moisture and insects, so I think such a step is very necessary.

The fixed cabinet does not need to scrape putty, because the cabinet panel can be directly fixed on the wall, and the wall behind it cannot be seen, and there is no need to scrape putty for beautification.

Make the cabinet first, and a lot of wood dust will be generated during carpentry construction. If you do carpentry after making wall putty, it will be very troublesome to clean up.

Make the cabinet first and then scrape the putty. After the cabinet is done, it will fit a little small gap with the wall, so the putty can be closed with putty after scraping it to be more beautiful.

It should be scraped putty first. After the wall is installed, the wall itself is not easy to move. So it should be before installing the cabinet. Just take care of the wall.

For home decoration, it is usually done first to do the cabinet and then scrape the putty, because this is the construction of different stages of the two types of work, and when decorating, the carpentry is done first, then the cabinet will be done, and then after the carpentry is done, the oilman will enter the construction site and scrape the putty construction, so it has always been to do the cabinet first and then the putty.

However, due to the large-scale use of finished custom furniture in the current decoration, the use of the previous traditional order has been completely changed, and there is a situation where the custom furniture will be scraped putty first and then made into cabinets, so for two different decoration construction, it must be decided according to the entire construction.

I hope it can help you, and if you still have questions, click on the avatar and wait for you to tease

Answering "the back of the cabinet needs to scrape putty", if the back of the cabinet does not scrape putty, no matter how to deal with it, it will not achieve the ideal decorative effect. Before decorating, it is important to know some knowledge about renovation. Friends may choose to install a wine cabinet and so on.

So what should be done with the wall at the back of these installed cabinets? What are the ways to deal with the back of the cabinet? For example, now a friend asks such a question:

The back wall of the cabinet needs to be scraped greasy, this problem has been discussed, many places in the hard decoration part of the home decoration are covered by soft decoration, where are these places still necessary to decorate? If you don't do it, you can save a lot of money on materials.

Many people are worried about whether the cabinet will be damp if the back is not painted, and this worry is superfluous, because unless there is open water, under normal circumstances, the moisture on the wall will not make the cabinet damp and crack. And the veneer layer of the cabinet itself also has a certain moisture-proof garden decoration, wardrobes, kitchen cabinets, wall cabinets occupy a large wall area, some people have some questions: the wall behind these cabinets, do you need to scrape putty, paint or tile?

Living in a situation where the environment is not particularly humid. If the indoor and outdoor or the surrounding environment of the community is particularly humid, if the putty is scraped on the wall, it can also prevent moisture to a certain extent, and prevent the wall from being affected by the owners of personal cleanliness and the like, so it is better to feel that it is better to scrape the putty later.

2-3 times, and then use water-resistant putty powder twice to batch it, without grinding or painting. It can effectively prevent water seepage, and it can adsorb a certain is that I am a cabinet that has not come to do it. You can't scrape it, and you don't blame me.

Moisture. In addition, the visuals are not bad, and they will not be very messy. Of course, other special materials do not need to scrape any putty, and if the wood appliance material is scraped with putty, it will be sprayed with glossy paint on the surface to protect its service life.

There is still no need to scrape putty behind the cabinet, because the general cabinet will be blocked and cannot be seen, even if the putty is scraped, it will be scratched, so there is no need for this at all, and special treatment is not necessary.

are all needed, although it is behind the cabinet, but it also needs to be done some processing, otherwise the overall effect is not very symmetrical.

Of course, you need to scrape putty, because no matter if you are in the future, the cabinet will be very ugly after it is removed, but there is no need for special treatment.

The back of the cabinet needs to be scraped putty, so as to better protect the wall, and look more comfortable, generally scrape the putty and then install the cabinet. No special treatment is required when decorating, and the cabinet can be installed directly after scraping a layer.

Whether the back wall of the cabinet has to be scraped putty, the first situation is some finished cabinets that everyone immediately ordered. At this time, most of the wall interior decoration in everyone's home has already been completed, <>

Therefore, at this time, the wall should be all scraped putty, or even painted or wallpapered. Therefore, I think that there is a batch of scraping putty on the wall of the purchased finished cabinet, and the overall surface layer should be decorated.

Since this one location is not done interior decoration is particularly ugly. The second situation is that everyone's home is a custom-made cabinet. In other words, we use the method of customizing furniture in the whole house when decorating our homes, some of these cabinets are placed in the wall, and some are immediately made on the wall.

However, the advice I provide is best to batch putty, because it will not cost much, and it can also have the effect of moisture-proof in the middle and later stages. The third condition is also a cabinet built on the spot. For the cabinets made on the spot, I also propose that everyone scrape putty and spray latex paint on the wall, and it is not recommended that you make the back of the cabinet straight on the wall, which is not good looking and unhygienic.

What are the advantages of scraping putty on the back wall of the cabinet? The first advantage is the avoidance of dust deposits. Everyone knows that the wall surface of the general stucco layer is very unsmooth and has a lot of porosity, which causes dust to be deposited here.

And the back of the cabinet is difficult to clean at all.

Therefore, I propose that you can use putty to carry out batch scraping to solve the shortcomings of the wall behind the cabinet. The second advantage is that it can be moisture-resistant at a certain level. As we all know, most of the putty scraped in today's family life is dominated by moisture-resistant putty, and moisture-resistant putty has an effective moisture-proof effect.

Therefore, scraping this putty batch on the back of the cabinet can prevent moisture. Due to the poor standard of natural ventilation at the back of the cabinet, it is easy to grow mold after a long time. The third point is that it can also have the actual effect of the overall decoration of the wall.

The key here is that if we don't scrape putty on the back wall of the cabinet, it may lead to unsightly overlapping in which positions, and if we scrape the overall batch, this hazard will not occur.

It should be necessary to brush putty. Although the back of the wardrobe may not be seen often, but if you want to change the style of the whole home, and then move the wardrobe away, you will find that the back of the wardrobe is really a mess.

When carrying out interior decoration, it is usually necessary to scrape putty first and then make cabinets. This is because scraping putty is the basic project of interior decoration, and its main role is to make the wall smooth and smooth, providing a good foundation for the subsequent laying of decorative materials. The fabrication and installation of furniture such as cabinets is carried out after the walls have been treated.

If you want to know the specific decoration**, you can use the "decoration artifact" ** device to calculate, just enter the area + city, immediately calculate the local decoration**, list the detailed list of 102 decorations, so that you don't have to worry about overspending on the decoration, click here to start calculating: [3 seconds to get the local decoration**].

The ** of scraping putty will be affected by a variety of factors, including the brand of putty, quality, construction difficulty, etc. Generally speaking, the ** of scraping putty on the market is about 10-30 yuan per square meter. The ** of the cabinet mainly depends on the material, size, design and other factors of the cabinet.

Generally speaking, the ** of the cabinet in the market is about 300-1000 yuan per square meter.

When carrying out the renovation, it is recommended that the owner first make a good budget, and then choose the right decoration materials and design according to the budget. At the same time, it is also necessary to pay attention to choosing an experienced and reputable decoration company for construction to ensure the quality of decoration. During the construction process, the owner should also regularly inspect the project to ensure that the progress and quality of the project meet expectations.

Tuba Rabbit is one of the largest decoration platforms in China, with a total of more than 41 million owners, 110,000 decoration companies, covering more than 300 cities across the country, user reputation is very good, not only to meet your decoration needs, but also to provide professional decoration companies according to your budget, want to find a good company, learn more about decoration knowledge on Tuba Rabbit, click here, free 1 to 1 for your home decoration services: [Tuba Rabbit ** official website].

Kunming - [Kunming Decoration Strategy Guide].

Suzhou - [Suzhou Decoration Strategy Guide].

Hefei - [Hefei Decoration Strategy Guide].

Fuzhou - [Fuzhou Decoration Strategy Guide].

Beijing - [Beijing Decoration Strategy Guide].

Dalian - [Dalian Decoration Strategy Book].

Hangzhou - [Hangzhou Decoration Strategy Guide].

Shanghai - [Shanghai Decoration Strategy Guide].

Tianjin——[Tianjin Decoration Strategy Guide].

The following is the answer to this question for you, a renovation worker with many years of decoration experience! The lack of expression should be a matter of writing level, and it has nothing to do with work experience, so I hope you forgive me! I think what I said makes sense and like it and pay attention to it!

Here's wishing you all a happy life!

Without further ado, to cut to the chase [Decoration is to scrape putty first.

Or do you want to make a cabinet first]? These two processes belong to two different types of work, one is wall decoration and the other is furniture building, and the order should have no influence on each other? However, both types of work are on-site construction, and it is certainly inconvenient to carry out them at the same time, so it is divided into a sequence!

So should you scrape putty first or make a cabinet first?

I think the two types of work can be cross-worked, you can first scrape 1 or 2 times of putty, and then carry out the on-site production of the cabinet, and then complete the last putty construction after the cabinet is done! This operation can well deal with the gap between the cabinet against the wall (except for movable cabinets or customized cabinets), and achieve the dense effect of mixing the cabinet and the wall.

But there are also certain drawbacks in such a sequence operation, that is, in the final wall decoration, bumps may cause damage to the cabinet, so we must do a good job of protective measures, and do not be careless during construction, after all, it is not good for anyone to be broken, right? For such a thing, no matter who comes first and who comes later, there are pros and cons, and how to do it outweigh the disadvantages, it depends on the scene and the specific situation!

According to the normal procedure, the ground decoration (bricklayer paving) is completed to the carpenter, the ceiling decoration and the cabinet building are completed at this time, and then the painter enters the site to complete the putty scraping or some other materials of the wall decoration.

Of course, if the floor decoration is made of wooden flooring, it can also be arranged after the cabinet is built, so that the occupied position of the cabinet does not need to be decorated, which has the advantage of reducing the cost of floor decoration!

Of course, these two kinds of work generally speaking, who first and who has no special impact, first do a good job of wall decoration and then build a cabinet can also be, to put it simply, which group of workers are free to do first, each other can help each other deal with the problem (of course, there will be mutual complaints). It depends on the degree of cooperation of the two groups you invite!

Is the decoration to scrape putty first or make cabinets first? There's no need to dwell on this question! To put it simply, it is a first-come, first-served problem, whoever goes first will do it first, as long as the owner is satisfied, everything else is not a thing!