Can an electrician connect electricity to the room power box from the hallway outlet?

The electrician can or cannot, from the socket in the hallway to the power box in the room, and privately pull the wire to connect the electricity. First of all, you have to figure out the properties of the power supply in the aisle socket!

Electrician. If the power supply of this socket belongs to the same person, then his behavior is understandable!

If this power supply does not belong to his exclusive use, then his behavior is absolutely wrong!

If you do it out of necessity, you have to get permission from the owner! Failure to do so is a serious offense.

The electrician can connect the power box in the room from the socket in the aisle, because it is very troublesome to pull a set of wires, so that it can be used through the wall, and I think it can still be connected. As long as it is handled well, there is no problem.

No, first of all, whether to steal electricity, besides, the aisle socket wire diameter is not large, the load capacity is limited, you can't connect the power box to the room, and you can use low-power electricity at zero time.

If you connect a wire from this socket, you can use it to another socket. If this socket is connected to the electrical box in another room, this is not possible and will burn out this route.

It depends on the maximum power required by the power box.

The power cord of the outlet is capable of withstanding the maximum current.

and whether the empty opening of the socket can withstand such a large current.

If the above conditions are met, of course, you can use it.

Not at all, how much load is the power box, and the wire of a socket can energize the power box? If you are not afraid of a short circuit, you will take it, and it may lead to a disaster.

The main thing is to see whether the power of the socket can bring up the power consumption of the power box. I think the power of the power box uses a lot of electricity. The power of the socket is generally not enough to meet the power consumption of the power box.

Connect the power supply to the power box in the hallway to the room, I don't know what this power box is for you? If you say that this power box is an ordinary socket, then it is completely fine, if you say that this power box is a total electrical box for the whole room, it is not possible.

If the circuit is something you can control, and it doesn't matter with the electricity bill. I think it's okay.

Can an electrician connect electricity from an outlet on the track to Oda Zonoka? I think so, as long as you can control the power supply.

No, it is an illegal use of electricity, and the property management will investigate and deal with it.

No. The distribution box must be taken.

If it is temporary electricity and the cross-sectional area and current carrying capacity of the power cord of the maintenance power box are sufficient, you can wiring it in the box for temporary use, but it must be in good contact.

This situation must be operated by a professional electrician, live maintenance should be very dangerous, you still have to find a professional electrician to give you specific operation and maintenance.

Is this wiring corridor and other hotels generally plugged in the card to get electricity? If you wiring the wire, you have to find an electrician, as long as it is an electrician, you will basically know it, if you say, you must know nothing about electricians, this can not be understood casually.

It depends on how your home originally laid out the wire, is divided into several ways, if the socket is a separate way, after the power is on, only all the sockets have electricity, if all the sockets and switches are connected from the main line, then the whole room will have electricity, you can try it, but pay attention to safety.

If the socket in the room and the input power socket are the same sub-switch, there will be electricity, if not the same sub-switch, the sub-switch should be closed before the room has electricity.

It will be energized, that is, the lines associated with the socket will be energized, but it is not recommended to do so.

Let's look at the picture. <>

There was no ground connection point in the distribution box, so it had to be empty.

The live wire can be connected to the lower end of any of the switches in the lower row of switches.

There is no vacancy, the zero wire is connected to the live wire and any one of the following roads, and the zero line is the upper right corner, which is shared by several copper bars, and the live wire is connected to the small switch below the ground wire can be connected to the metal part of the distribution box.

The left end of the black wire switch, that is, the blue wire, the blue zero wire is connected to the red wire of the power supply, the two-color wire is grounded, and the switch has a special grounding terminal.

If according to the specification, it is definitely not allowed, but according to the actual situation, this wiring method as long as it is not in the use of high-power electrical appliances is no problem, as for safety, it is recommended that you connect the wire to another room in the socket box.

Your plug board is fine, the one with four plugs is enough to choke.

Yes, as long as the installation meets the electrical installation specifications.

It's better not to be like this. It is troublesome and unsafe to overhaul. Unless otherwise labeled.

If a socket circuit is reserved in the weak current box, it can be used for network optical modems, and a multi-purpose socket can be installed, or two sockets can be installed for refrigerators or other electrical appliances (the power cannot be too large, less than 1200 watts).

The weak current box cannot go strong current. The line should be laid separately to the weak current box and the switch box should be added.

In terms of use function, it is completely possible, but the internal power cord capacity must be sufficient, otherwise the current of the air conditioner is too large when it is used, coupled with the high power of the water heater, the power cord will be unbearable, and if it is tripped due to overheating, it can only be used separately.