I am going to install a squatting toilet in the bathroom, but the decorator said that the ground sho

Updated on home 2024-06-28
15 answers
  1. Anonymous users2024-02-12

    It can be heightened by 20cm with cement, which can improve the experience of going to the toilet.

  2. Anonymous users2024-02-11

    It can be heightened with floor tiles and cement underneath, and then tiled on the surface.

  3. Anonymous users2024-02-10

    The ground can be raised so that the problem is solved, backfill can be done, or a few steps can be added.

  4. Anonymous users2024-02-09

    In the construction standard, there is no requirement that the squatting toilet must be higher or flush with the ground, if it is on the first floor, the squatting toilet can be embedded in the ground and flush with the ground. However, flush is easy to cause water seepage, and it is difficult to use and take care of; If it's a high-rise, it must be above the ground. If there is no backwater bend and aqua privy.

    There is no difference, the biogas rises directly indoors, and whoever has the bad habit of smoking in the toilet may ignite the biogas and burn the butt eggs, and it will also burn"House Sparrows"burnt taste.

    <> know, sunken toilets.

    The ground is relatively low and there are caissons, so there is enough height to install a trap to ensure the normal use of the squatting toilet, whether it is to install a squatting toilet or a toilet, it is okay, and there is no need to raise it. Most of the seats used are commercial houses in the north, and the bathroom sinks about 5 cm when designed. If it is changed to a squatting position, it is impossible for the floor to sink, it can only be lifted, and there is no need to lift it as a whole, as long as the squatting position is raised by thirty or forty centimeters, and a step is designed.

    Take a second step at the position of the squatting toilet, so that the step is not too high, and it is a little more convenient to use. There is another way: just bury the squatting toilet on the step, and as for the sewer pipe, open the floor slab and go from the roof downstairs.

    You must seal the water inlet hole of the squatting toilet, and then what you have to do is to insert the water inlet pipe into the water inlet hole, so as to avoid water leakage in the future use process. After the test, if it is found that there is no water leakage problem, the last thing to do is to fill, but when filling, we must pay attention to the place where the cement slurry and ceramics are in contact, we must smear some asphalt, so that it can be better used in the future.

    Lightness is ceramsite.

    One of the most important of these properties is its ability to replace heavy sand.

    The main reason. The internal structure of ceramsite is characterized by fine honeycomb micropores. These micropores are closed, not connected.

  5. Anonymous users2024-02-08

    The reason why the ground must be heightened is because the squatting toilet before installation is a concave shape, and the amplitude of the depression is about ten centimeters, and the recess is a pipe for water bend and drainage, and it is not possible to install it directly on the sewer, because the sewer is on the ground, and there is no concave space, so in order to make the squatting toilet a plane, the ground can only be raised, and then a hole is left, and this hole is used to put the depression of the squatting toilet into it. Then smooth it with cement and lay the tiles on it.

  6. Anonymous users2024-02-07

    Because in this way, it will not be affected by other things, it can be more convenient, so that it can be more fashionable.

  7. Anonymous users2024-02-06

    If there is no difference between this backwater bend and a dry toilet, the biogas will rise directly into the room, and whoever has a bad habit of smoking in the toilet may ignite the biogas, burn the fart like an egg, and produce a burnt smell of burning "house birds".

  8. Anonymous users2024-02-05

    In the construction standard, there is no requirement that the toilet must be higher or flush with the ground, if it is on the first floor, the toilet can be placed on the ground and flush with the wooden floor. However, flush level is easy to cause water leakage, and it is very difficult to use and manage methods; If it's a high-rise building, it must be higher than the ground. With everyone attaches great importance to the difficult problems of bathroom odor and water leakage, the toilet has also been updated, the absolute height of the general toilet is 280mm-320mm, and the absolute height of the toilet with a water trap is 300mm-350mm, which needs to be higher than the ground when assembling.

    At the beginning, the toilet is higher than the floor of the bathroom, which can form a certain fluctuating absolute height, which is conducive to the smooth drainage of the bathroom, so that there is no need to worry about the blockage of the sewage pipe, and the difficulty of water leakage and leakage. Secondly, the toilet is higher than the ground, which is cleaner and more convenient to use. It forms an isolation zone with the undulation of the bathroom floor to ensure the cleanliness and tidiness of the bathroom.

    Finally, the toilet is higher than the ground, which is conducive to the maintenance of the ground structure, especially above the first floor, to avoid digging down to damage the ground structure and injure the neighbors next door.

    If you talk about your family's new opening real estate, the current real estate developers are all caisson scheme design. Caissons are generally 30 cm deep. Installing a toilet is a relative height in many ways.

    You don't have to lift the ground. If it's an old community, then this method won't work. If it is said that the bathroom of the rural villa is made on the first floor, you can dig a pit directly in the ground, which can solve the difficulty of putting toilets.

    And don't pull up the ground either. There's also a way to buy one that has a toilet with a toilet. It's dual-purpose.

    All of them can solve the difficulty of lifting the floor of the toilet. And it's easy to install and easy to use. It can also solve the disagreement between relatives in choosing a toilet is a toilet.

    Everyone should find the installation location of the toilet, and then leave a pipe here, but remember that the water pipe and the road must maintain a certain distance. After finding a part, the next thing to do is to make a dent, this relative height must be higher than the toilet, so that when assembling in the back, it will save costs.

  9. Anonymous users2024-02-04

    You can lay some floor tiles on the ground, and then increase the height of the squatting urinal on the ground, so that the design can be realized.

  10. Anonymous users2024-02-03

    Cut the concrete in the squatting area, then dig enough to dig a pit in the area, then use concrete or cement mortar to make the pit waterproof, and finally install the squatting in this position. This also completes the installation of the squat at the same height as the ground.

  11. Anonymous users2024-02-02

    As follows: 1. Split squatting toilet.

    The squatting toilet itself does not have a water trap, and the trap is separated, which is called a split squatting bend, which is easy to install, has a large water flow and sufficient momentum. The disadvantage is that it is more difficult to clean and it is difficult to take things out when they fall. In addition, if the plumbing does not have its own drain bend, the sewer odor is easy to flood.

    2. Siamese squatting toilet.

    The squatting toilet comes with a trap, which is called a one-piece squatting toilet. The biggest advantage of the one-piece squatting toilet is that it can use the bend of the water storage bend to create a water seal to prevent the odor from the sewer from flowing backwards. The disadvantage is that compared with split squatting toilets, conjoined squatting toilets are easy to clog and are not easy to dredge.

  12. Anonymous users2024-02-01

    In this way, these square numbers of sand and cement will be used, and the cost of home decoration will be greatly increased. If you don't want to destroy the waterproof, you can only put the floor of the living room and bedroom too high. In this case, the cost will be correspondingly higher, and the height of the home will also have an impact.

    It can only be solved by the bathroom floor is higher than the living room, but in the current decoration, this problem has become very easy to solve. So, for the floor of the bathroom decoration is higher than the living room, we must first know the reason, and then solve the problem according to the reason.

    <> this situation is certainly unreasonable. So the point of view given by the home miscellaneous altar is to take different approaches according to the stage of decoration in our home. One is before the decoration, and the other is after the decoration.

    Let's take a look at these two different methods. And our bathroom floor needs to be paved with floor tiles, especially in the case of uneven bathroom floors, it is necessary to level the blank floor and wipe cement mortar, plus the thickness of the floor tiles, so that the bathroom floor is higher than the living room.

    In the living room floor height is relatively high, such as higher than the meter, you can also increase the height of the base layer of the living room floor material, and thicken the base dry material layer when paving the floor tiles; When laying wooden floors, increase the thickness of the screed, so that the finished surface of the living room floor is higher than the bathroom floor. When the ground outside the bathroom is decorated, because the paving thickness cannot refer to the thickness of the bathroom floor, a paving thickness is set independently, so the bathroom floor and the living room floor form two different heights and uneven situations.

    The bathroom floor should be 2 4cm lower than the living room floor, but sometimes in our decoration process, there will also be a situation where the bathroom floor is higher than the living room floor, generally the main reason for this situation is to change the bathroom sewer pipe, such as the toilet displacement, the bathroom is the place where people wash, and it is also the place with the most water, if the bathroom floor is high, the water will flow out of the bathroom, stay in the living room, affect the health of the home, and there will be certain safety hazards. It may also have an impact on the downstairs and cause unnecessary trouble.

  13. Anonymous users2024-01-31

    You should listen to the decoration master, because the decoration master will have a lot of decoration experience, so what the decoration master says, you generally have to consider it.

  14. Anonymous users2024-01-30

    You should listen to the words of the decoration master, after all, they are still more experienced, so they can make certain concessions in this regard.

  15. Anonymous users2024-01-29

    It is not installed, and the squatting toilet is very unsightly, and it is also very uncomfortable to use.

Related questions
7 answers2024-06-28

You can buy the top 10 bathroom brands:

1. TOTO (under Dongtao, in 1917 in Japan, first-line brand, top ten brands of sanitary ware) 2, Wrigley (under Lehua ceramic sanitary ware, Chinese famous brand, first-line brand, top ten brands of sanitary ware) 3, Kohler (top ten brands of sanitary ware, started in 1873 in the United States, the world's famous bathroom brand) 4, American Standard (in 1872 in the United States, China's well-known trademark, first-line brand, top ten brands of sanitary ware) 5, Shanggao (China's famous brand, top ten brands of sanitary ware, first-line brand) 6, Roca (Top Ten Brands of Sanitary Ware, Spain in 1917, Transnational Sanitary Ware Group) 7, Apollo (first-line brand, Top Ten Brands of Sanitary Ware, Guangdong Famous Brand, Headquarters Guangzhou) 8, Hecheng (First-line Brand, Top Ten Brands of Sanitary Ware, World-famous Sanitary Ware Manufacturer) 9, Huida (China Famous Trademark, Chinese Famous Brand, First-line Brand, Top Ten Brands of Sanitary Ware) 10, Dongpeng (Chinese Famous Trademark, Chinese Famous Brand, First-line Brand, Top Ten Brands of Sanitary Ware). >>>More

31 answers2024-06-28

**Aspect: On the market, squatting toilets** are relatively affordable, with small space requirements, after all, there is no complex toilet structure, and it is also suitable for bathrooms with small space, but the toilet takes up more space. >>>More

25 answers2024-06-28

There is no problem with white tiles, but it is true that the cracks will turn black and the tiles will turn yellow over time. >>>More

25 answers2024-06-28

It is not necessary to install a heating exchanger. Heated rooms are generally uniformly heated and do not require the installation of switches.

10 answers2024-06-28

What do I need to pay attention to when installing squatting in the bathroom? Are there any requirements? Most girls will encounter it. >>>More