What are the maintenance methods for wipers? How to maintain the wipers

Wiper hardening. If the wipers are hardened due to the aging of the wipers, you can replace them with a new one or clean the wipers with lubricant.

The wiper rod is not angled properly. To adjust the wiper angle, hold the wiper with a wrench, then gently roll and adjust to a straight position, or go to a repair shop to find a professional to help adjust.

1. Keep the wiper at the lowest position when not in use: Place the wiper at the lowest position when not in use, and pay more attention to cleaning the lower part of the wiper to prevent foreign objects from causing deformation of the wiper blade due to long-term compression.

2. Wipers are best only used to clean up rainwater: try not to use wipers to clean dust or stains on the windshield at ordinary times. The function of the wiper itself is to clean up the rainwater, and the unknown stains on the glass may cause the aging and wear of the blade edge of the wiper strip, which will reduce the service life of the wiper.

3. Clean once a week or two weeks: lift the wiper blade and separate it from the windshield, check whether the wiper is damaged, replace it in time if it is damaged, if there is no damage, soak the wiper blade with water and then polish it back and forth with sandpaper several times, and finally rinse it with water.

The glass is not clean. Because the glass is not cleaned in place when washing the car, it will cause some sticky particles to adhere to the glass, and the wiper can not be scraped clean and may be damaged, so find a car wash shop to carefully clean the glass.

Hope, thank you.

1. Before leaving the car in rainy days, pull up the wiper and wipe the contact parts between the wiper strip and the glass with a wet cloth. When using, be sure to spray the glass cleaning solution first.

2. Don't use the most expensive wipers, it's best to buy the right wiper strip according to your own wiper skeleton to replace it, one yuan, very cost-effective, the effect and service life are not inferior to hundreds of yuan wipers, buy a 20 can be used for 8-10 years only 30 yuan, and always use a new one.

Wipers are inherently consumable parts, and there is currently no effective way to maintain them. The wiper strip has a certain service life, and it is enough to replace the scraper or the strip regularly. The motors and mechanisms inside rarely break.

The most important thing is not to dry scrape, as this will damage both the wiper and the glass.

Use the original wiper blades with a special cleaning solution! Don't turn on the windshield wipers or bring some water to scrape when there is snow! ~

Usually pay attention not to dry brush, there will be a lot of insect corpses when driving at high speed, do not directly use the wiper to brush directly, to moisten the water first with the wiper, in winter to freeze to open the windshield to defrost, until the ice and snow melt and then use the wiper.

Pay attention to check and adjust the angle of the wiper and the fixing screws that fix the wiper arm, and regularly drop a few drops of oil lubrication on the shaft of the wiper.

<> "Introduction to the maintenance method of the wiper.

1) To prevent the aging of the tape.

A small amount of wax is usually added during the manufacturing process of wiper blades.

Before using the wiper blade for the first time, it is recommended to wipe the wiper blade several times with a soft cloth moistened with a little window washing liquid to wash off the wax on its surface, as any oily substance on the surface of the windshield and wiper blade will increase wiper resistance, reduce the cleanliness of the wiper blade, and even produce annoying noise.

2) In order to ensure a good scratching effect, the specified window cleaning liquid should be used, and it is strictly forbidden to use clean water as the window cleaning liquid.

Because the professional wiping and window liquid is added to dissolve oil stains and improve the wetting interface of the glass, its freezing point is far below zero degrees Celsius, and ordinary water cannot achieve this effect.

3) It is recommended to clean the wiper blades and windshield frequently, because these tiny substances produced by the dust in the air and the oil stain of the car exhaust will adhere to the windshield and wiper blades, increasing the friction when wiping.

At the same time, if a large amount of dust is attached to the surface of the tongue scraper, it will reduce its elasticity and affect the service life.

4) Do not use the wiper when the window glass is dry or there are obstacles (such as ice and snow), otherwise it will damage the wiper blades, draft sail wiper motor and glass.

5) Before using the wiper in cold weather in winter, check whether the wiper blades are frozen on the car window. If it freezes, do not use it immediately, or it will damage the wiper motor. At this time, the heating function of the windshield should be turned on to ensure that the ice between the front and rear windshields and the wiper blades melts before it can be used normally.

6) In winter ice and snow weather, if there are ice particles in the wedge-shaped groove of the wiper blade, the wiper blade will become hard, hindering the normal turning and affecting the use. The windshield is heated to melt the ice particles on the wiper blades and restore the elasticity of the wiper blades.

7) Although the freezing point of professional window washer is far below zero degrees Celsius, before using the glass washer in winter, the window washer should be used a few minutes after the engine is turned on to ensure that the window washer does not freeze.

<> "Maintenance methods of wipers.

1.Keep it clean.

The windshield has streaks, and the wiper blades will be dirty. Wet the towel with alcohol and wipe off the dirt from the wiper strips. It is advisable to inspect and clean the wiper blades regularly and to keep them clean at all times.

2.Check the rubber.

When the wiper is working, the windshield makes a screeching sound, check the rubber strip for cracked, worn, and uneven.

3.Keep out of the sun.

Park your car in a shady place, like a garage. Especially in hot weather, many people park their cars outdoors and expose them to the sun. High temperature is the natural enemy of rubber materials, so it will accelerate the aging of wiper blades.

4.Replenish the solution.

Please note that clean water is not a substitute for a glass of aqueous solution. In order to extend the service life of the parts, it is necessary to use a conventional glass water cleaning fluid. At the same time, pay attention to the remaining amount of glass water and replenish it in time.

5.Defrost. Especially in the northern region, the wipers are frozen by snow after the vehicle is parked. The snow should be manually cleared by Serino. Suddenly turning on the wipers can cause structural deformation, cracking of the wiper blades, scratching the windshield, and even burning out the wiper motor.